The alcoholic group, OH and halogen group present in the given synthetic steroid, dexamethasone are to classified as 1 ° , 2 ° , or 3 ° . Concept introduction: The alkyl halide and alcohol are identified as primary ( 1 ° ) , secondary ( 2 ° ) and tertiary, ( 3 ° ) . The primary alkyl halide or alcohol is the one in which a halide group or OH group is attached to that carbon atom which is bonded with one carbon atom only. The secondary alkyl halide or alcohol is the one in which a halide group or OH group is attached to that carbon atom which is bonded with two carbon atoms. The tertiary alkyl halide or alcohol is the one in which halide group or OH group is attached to that carbon atom which is bonded with three carbon atoms.

Question

Want to see the full answer?

Answer 1

Question

Chapter 3.2, Problem 5P

Interpretation Introduction

Interpretation: The alcoholic group, OH and halogen group present in the given synthetic steroid, dexamethasone are to classified as 1°, 2°, or 3°.

Concept introduction: The alkyl halide and alcohol are identified as primary (1°), secondary (2°) and tertiary, (3°). The primary alkyl halide or alcohol is the one in which a halide group or OH group is attached to that carbon atom which is bonded with one carbon atom only. The secondary alkyl halide or alcohol is the one in which a halide group or OH group is attached to that carbon atom which is bonded with two carbon atoms. The tertiary alkyl halide or alcohol is the one in which halide group or OH group is attached to that carbon atom which is bonded with three carbon atoms.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

There is an instrument in Johnson 334 that measures total-reflectance x-ray fluorescence (TXRF) to do elemental analysis (i.e., determine what elements are present in a sample). A researcher is preparing a to measure calcium content in a series of well water samples by TXRF with an internal standard of vanadium (atomic symbol: V). She has prepared a series of standard solutions to ensure a linear instrument response over the expected Ca concentration range of 40-80 ppm. The concentrations of Ca and V (ppm) and the instrument response (peak area, arbitrary units) are shown below. Also included is a sample spectrum. Equation 1 describes the response factor, K, relating the analyte signal (SA) and the standard signal (SIS) to their respective concentrations (CA and CIS). Ca, ppm V, ppm SCa, arb. units SV, arb. units 20.0 10.0 14375.11 14261.02 40.0 10.0 36182.15 17997.10 60.0 10.0 39275.74 12988.01 80.0 10.0 57530.75 14268.54 100.0…

A mixture of 0.568 M H₂O, 0.438 M Cl₂O, and 0.710 M HClO are enclosed in a vessel at 25 °C. H₂O(g) + C₁₂O(g) = 2 HOCl(g) K = 0.0900 at 25°C с Calculate the equilibrium concentrations of each gas at 25 °C. [H₂O]= [C₁₂O]= [HOCI]= M Σ M

What units (if any) does the response factor (K) have? Does the response factor (K) depend upon how the concentration is expressed (e.g. molarity, ppm, ppb, etc.)?