How is the air pressure in a tightly sealed house affected by operating the furnace? Explain.
Answer to Problem 1CQ
Explanation of Solution
Write the expression for ideal gas equation.
Here,
Since the furnace is operated in the tightly sealed house due to which the temperature in the tightly sealed house is increased and the volume is constant
From ideal gas equation, it is seen that the pressure is directly proportional to the temperature.
So the air pressure is increased in the tightly sealed house.
Conclusion:
Therefore, the air pressure increases in the tightly sealed house by operating the furnace due to the increase in the temperature.
Want to see more full solutions like this?
Chapter 17 Solutions
Physics (5th Edition)
Additional Science Textbook Solutions
Microbiology: An Introduction
Campbell Biology in Focus (2nd Edition)
Campbell Biology (11th Edition)
Chemistry: An Introduction to General, Organic, and Biological Chemistry (13th Edition)
Campbell Biology: Concepts & Connections (9th Edition)
Microbiology with Diseases by Body System (5th Edition)
- In the chapter on fluid mechanics, Bernoulli's equation for the flow of incompressible fluids was explained in terms of changes affecting a small volume dV of fluid. Such volumes are a fundamental idea in the study of the flow of compressible fluids such as gases as well. For the equations of hydrodynamics to apply, the mean free path must be much less than the linear size of such a volume, adV1/3 . For air in the stratosphere at a temperature of 220 K and a pressure of 5.8 kPa, how big should a be for it to be 100 times the mean free path? Take the effective radius of air molecules to be 1.881011 m, which is roughly correct for N2.arrow_forwardA high—pressure gas cylinder contains 50.13L of toxic gas at a pressure of 1.40107N/m2 and a temperature of 25.0C. Its value leaks after the cylinder is dropped. The cylinder is cooled to dry ice temperature (78.5C) to reduce the leak rate and pressure so that it can be safely repaired. (a) What is the final pressure in the tank, assuming a negligible amount of gas leaks while being cooled and that there is no phase change? (b) What is the final pressure it onetenth of the gas escapes? (c) To what temperature must the tank be cooled to reduce the pressure to 1.00 atm (assuming the gas does not change phase and that there is no leakage during cooling)? (d) Does cooling the tank appear to be a practical solution?arrow_forwardAt a spot in the high Andes, water boils at 80.0C, greatly reducing the cooking speed of potatoes, for example. What is atmospheric pressure at this location?arrow_forward
- The pressure gauge on a cylinder of gas registers the gauge pressure, which is the difference between the interior pressure and the exterior pressure P0. Lets call the gauge pressure Pg. When the cylinder is full, the mass of the gas in it is mi at a gauge pressure of Pgi. Assuming the temperature of the cylinder remains constant, show that the mass of the gas remaining in the cylinder when the pressure reading is Pgf is given by mf=mi(Pgf+P0Pgi+P0)arrow_forwardSuppose a gasfilled incandescent light bulb is manufactured so that the gas inside the bulb is at atmospheric pressure when the bulb has a temperature of 20.0C. (a) Find the gauge pressure inside such a bulb when it is hot, assuming its average temperature is 60.0C (an approximation) and neglecting any change in volume due to thermal expansion or gas leaks. (b) The actual final pressure for the light bulb will be less than calculated in part (a) because the glass bulb will expand. What will the actual final pressure be, taking this into account? Is this a negligible difference?arrow_forwardA theoretical atmospheric lapse rate. Section 16.7 described experimental data on the decrease in temperature with altitude in the Earths atmosphere. Model the troposphere as an ideal gas, everywhere with equivalent molar mass M and ratio of specific heats y. Absorption of sunlight at the Earths surface warms the troposphere from below, so vertical convection currents are continually mixing the air. As a parcel of air rises, its pressure drops and it expands. The parcel does work on its surroundings, so its internal energy decreases and it drops in temperature. Assume that the vertical mixing is so rapid as to be adiabatic. (a) Show that the quantity TP (1 )/ has a uniform value through the layers of the troposphere. (b) By differentiating with respect to altitude y, show that the lapse rate is given by dTdy=TP(11)dPdy (c) A lower layer of air must support the weight of the layers above. From Equation 15.4, observe that mechanical equilibrium of the atmosphere requires that the pressure decrease with altitude according to dP/dy = g. The depth of the troposphere is small compared with the radius of the Earth, so you may assume that the free-fall acceleration is uniform. Proceed to prove that the lapse rate is dTdy=(11)MgR Problem 16.50 in Chapter 16 calls for evaluation of this theoretical lapse rate on the Earth and on Mars and for comparison with experimental results.arrow_forward
- Engineers are frequently called on to inspect and, if necessary, repair equipment in nuclear power plants. Suppose that the city lights go out. After inspecting the nuclear reactor, you find a leaky pipe that leads from the steam generator to turbine chamber, (a) How do the pressure readings for the turbine chamber and steam condenser compare? (b) Why is the nuclear reactor not generating electricity?arrow_forwardUnder what circumstances would you expect a gas to behave significantly differently than predicted by the ideal gas law?arrow_forwardA deepsea diver should breathe a gas mixture that has the same oxygen partial pressure as at sea level, where dry air contains 20.9% oxygen and has a total pressure of 1.01105N/m2. (a) What is me partial pressure of oxygen at sea level? (b) If the diver breathes a gas mixture at a pressure of 2.00106N/m2, what percent oxygen should it be to have the same oxygen partial pressure as at sea level?arrow_forward
- Consider a container of nitrogen gas molecules at 900 K. Calculate (a) the most probable speed, (b) the average speed, and (c) the rms speed for the molecules. (d) State how your results compare with the values displayed in Figure 21.11.arrow_forwardWater in an electric teakettle is boiling. The power absorbed by the water is 1.00 kW. Assuming the pressure of vapor in the kettle equals atmospheric pressure, determine the speed of effusion of vapor from the kettles spout if the spout has a cross-sectional area of 2.00 cm2. Model the steam as an ideal gas.arrow_forwardWhat is the atmospheric pressure on top of Mt. Everest on a day when water boils there at a temperature at 70.0C ?arrow_forward
- Principles of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningGlencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-HillAn Introduction to Physical SciencePhysicsISBN:9781305079137Author:James Shipman, Jerry D. Wilson, Charles A. Higgins, Omar TorresPublisher:Cengage Learning
- College PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax CollegePhysics for Scientists and Engineers, Technology ...PhysicsISBN:9781305116399Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning