Concept explainers
You are building additional storage space in your garage. You decide to suspend a 10.0-kg sheet of plywood of dimensions 0.600 m wide by 2.25 m long from the ceiling. The plywood will be held in a horizontal orientation by four light vertical chains attached to the plywood at its corners and mounted to the ceiling. After you complete the job of suspending the plywood from the ceiling, you choose three cubic boxes to place on the shelf. Each box is 0.750 m on a side. Box 1 has a mass of 50.0 kg, box 2 has a mass of 100 kg, and box 3 has a mass of 125 kg. The mass of each box is uniformly distributed within the box and each box is centered on the front-to-back width of the shelf. Unbeknownst to you, one of the chains on the right-hand end of your shelf is defective and will break if subjected to a force of more than 700 N. There are six possible arrangements of the three boxes on the shelf, for example, from left to right, Box 1, Box 2, Box 3, and Box 1, Box 3, Box, 2, and four more. Which arrangements are safe (that is, the defective chain will not break if the boxes are arranged in this way), and which arrangements are dangerous?
The arrangement of the boxes that are safe and the arrangement of the boxes that are dangerous.
Answer to Problem 1P
The arrangement of the boxes that are safe are
Explanation of Solution
The mass of the sheet of the plywood is
The chains are all hinged at the center only so the angle made by the chain with the plywood is
The free body diagram of the arrangement
Figure (1)
Take the moment in the above diagram on the left end.
Here,
Substitute
So the tension in each chain in arrangement
The free body diagram of the arrangement
Figure (2)
Take the moment in the above diagram on the left end.
Substitute
So the tension in each chain in arrangement
The free body diagram of the arrangement
Figure (3)
Take the moment in the above diagram on the left end.
Substitute
So the tension in each chain in arrangement
The free body diagram of the arrangement
Figure (4)
Take the moment in the above diagram on the left end.
Substitute
So the tension in each chain in arrangement
The free body diagram of the arrangement
Figure (5)
Take the moment in the above diagram on the left end.
Substitute
So the tension in each chain in arrangement
The free body diagram of the arrangement
Figure (6)
Take the moment in the above diagram on the left end.
Substitute
So the tension in each chain in arrangement
Conclusion:
Therefore, the arrangement of the boxes that are safe are
Want to see more full solutions like this?
Chapter 12 Solutions
Physics for Scientists and Engineers
- As a hiker in Glacier National Park, you are looking for a way to keep the bears from getting at your supply of food. You find a campground that is near an outcropping of ice from one of the glaciers. Part of the ice outcropping forms a 47.5° slope up to a vertical cliff. You decide that this is an ideal place to hang your food supply as the cliff is too tall for a bear to reach it. You put all of your food into a burlap sack, tie an unstretchable rope to the sack, and tie another bag full of rocks to the other end of the rope to act as an anchor. You currently have 19.5 kg of food left for the rest of your trip so you put 19.5 kg of rocks in the anchor bag to balance it out. What happens when you lower the food bag over the edge and let go of the anchor bag? The weight of the bags and the rope are negligible. The ice is smooth enough to be considered frictionless. O The anchor bag is on a slope so the food bag will drop, pulling the anchor bag up. The motion of the food bag cannot be…arrow_forwardThe elastic limit of an alloy is 5.0×108 N/m2. What is the minimum radius ?min of a 9.0 m long wire made from the alloy if a single strand is designed to support a commercial sign that has a weight of 8000 N and hangs from a fixed point? To stay within safety codes, the wire cannot stretch more than 5.0 cm. ?min = ? marrow_forwardA cable used to lift heavy materials can resist breaking even under a load of 1 meganewtons. The steel cable must support twice that load for safety purposes. By how much the steel cable will stretch if it carries 1 meganewtons of load? Assume 8.0 m initial length of the cable. Group of answer choices 0.01 m 0.001 m 0.2 m 0.1 m 0.02 m 0.002 marrow_forward
- Determine the x, y, and z-coordinates of the mass center of the body constructed of three pieces of uniform thin plate which are welded together. Answers: y- 315 mm 375 mm 70 mm mm mm mm 180 mm 135 mm 210 mmarrow_forward*71. D A 61-kg snow skier is being pulled up a 12° slope by a steel cable. The cable has a cross-sectional area of 7.8 × 10-5 m². The cable applies a force to the skier, and, in doing so, the cable stretches by 2.0 X 10-* m. A frictional force of magnitude 68 N acts on the skis and is directed opposite to the skier's motion. If the skicr's acceleration up the slope has a magnitude of 1.1 m/s², what is the original (unstretched) length of the cable?arrow_forwardA tow truck is pulling a car out of a ditch by means of a steel cable that is 9.2 m long and has a radius of 0.50 cm. When the car just begins to move, the tension in the cable is 279.6 N. How much has the cable stretched from its initial length? Assume Ysteel is 2x1011 N/m2arrow_forward
- 16arrow_forwardThe assembly shown in the figure is welded to collar A that fits on a vertical pin. The pin can exert couples about the x- and z-axes but does not prevent motion along or about the y-axis. E 120 mm F A 60 mm 90 mm D 80 mm C 45 mm For the load W= 660 N, determine the tension in each cable and the reaction at A. The tension in cable CFis N. |N. |N) i +([ The tension in cable DE is The reaction at A is (| N) k.arrow_forwardA 480 mm long thighbone (femur), which is the largest and longest bone in the human body, has a cross sectional area of 7.7 × 10–4 m2. A safety factor of 4 applies and the maximum compressional stress that a bone can withstand is 1.6 × 108 N/m2 before it breaks. Young’s Modulus (E ) of a bone at room temperature is 15 × 109 Pa. How much will it compress to support a weight of 1.2 × 105 N?arrow_forward
- Four cables are used to tether a hot-air balloon as shown. The four cables are attached to a hook mounted to the bottom of the basket of the balloon at point A, and their other ends are staked to the ground. The hook is located in the geometric center of the basket. The balloon and the air inside it have a combined mass of 3000 kg. You want to determine the resultant of the tension forces in the four cables acting on the hook at point A. It is known that the magnitudes of the tension in the cables are as follows: TAB = 206 N; TAC = 354 N; TAD = 249 N; and TAE = 485 N. Express the resultant of all four forces on the hook at point A by the cables in rectangular component form.arrow_forwardA thin 1.50-mm coating of glycerin has been placed between two microscope slides of width 1.00 cm and length 4.00 cm. Find the force required to pull one of the microscope slides at a constant speed of 0.300 m/s relative to the other slide.arrow_forwardA 2×12 board is about 2.18 kg per linear foot. A 16-foot length board of Southern Yellow Pine is placed against a wall such that the angle between the wall and the length of the board is 20°. Assume that the wall is perfectly smooth (a.k.a. the coefficient of friction between the wall and the board is zero). (a) What is the normal force between the wall and the board? (b) What is the normal force between the board and the floor? (c) What is the force of static friction between the board and the floor? (d) What is the coefficient of static friction between the board and the floor?arrow_forward
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPhysics for Scientists and Engineers with Modern ...PhysicsISBN:9781337553292Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage Learning