The similarities and differences between inhibitory and excitatory postsynaptic potentials. Introduction: When the nerve impulse reaches the synaptic bulb of a neuron, the voltage-gated calcium channels open. It forces the exocytosis of synaptic vesicles that contain the neuron from the pre-synaptic end of an axon. When a neurotransmitter is released from the vesicle, it binds to its specific receptors present on the postsynaptic membrane of another neuron. This binding opens the ligand-gated channels, through which the ions flow. The flow of ions changes the voltage across the cell membrane and this alteration is known as postsynaptic potential. On the basis of the ions involved, the depolarization and hyperpolarization occur, that is, the sodium ions cause depolarization, whereas potassium ions, as well as chloride ions, cause hyperpolarization.

Question

Want to see the full answer?

Answer 1

Question

Chapter 12, Problem 19CP

Summary Introduction

To review:

The similarities and differences between inhibitory and excitatory postsynaptic potentials.

Introduction:

When the nerve impulse reaches the synaptic bulb of a neuron, the voltage-gated calcium channels open. It forces the exocytosis of synaptic vesicles that contain the neuron from the pre-synaptic end of an axon. When a neurotransmitter is released from the vesicle, it binds to its specific receptors present on the postsynaptic membrane of another neuron. This binding opens the ligand-gated channels, through which the ions flow.

The flow of ions changes the voltage across the cell membrane and this alteration is known as postsynaptic potential. On the basis of the ions involved, the depolarization and hyperpolarization occur, that is, the sodium ions cause depolarization, whereas potassium ions, as well as chloride ions, cause hyperpolarization.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Overview of Transformation Protocol -Prepare competent bacteria for transformation: Treat starter E. coli bacteria with CaCl2and Competent Cell Solution (CCS). Store on ice until transformation procedure. Competent cells are cells that are likely to take up foreign DNA and be transformed. This step increases the likelihood that the E. coli cells will take up the introduced vector and be transformed. -Transformation procedure: Obtain two microcentrifuge tubes containing your competent cells. Label one tube +DNA and one -DNA. Add CaCl2 to both tubes. Add the transformation mix containing the plasmid DNA to the tube labeled +DNA. Do not add any plasmid DNA to the -DNA tube. Incubate both tubes on ice for 10 minutes. Then, place both tubes in a 42\deg C water bath for 45 seconds. Replace the tubes in an ice bucket for 2 minutes. Add recovery broth to both tubes. Incubate both tubes in a 37 C water bath for 5 minutes. Questions: 1)What is the selectable marker in this experiment? How…

Based on your results, which suspect's DNA best matches the DNA found at the crime scene?

In oxidase test with Pseudomonas aeruginosa, the cell cultures on the slide turn colorless to be purple after tetra-methyl-p-phenylenediamine dihydrochloride (TMPD) is added. In the reaction, OTMPD is electron acceptor O cytochrome c is the electron source oxygen is terminal electron acceptor OH2 produced is electron donor