With drawing a topographic diagram

Q: Draw the 1 ft contours for the grid elevations below.

A: Contours are the lines that drawn by joining the equal elevations.  Contour interval is the vertical…

Q: What is the maximum discrepancy allowed between the difference of Grid and Geodetic distance in…

A: The maximum allowable discrepancy between the difference of grid distance and geodetic distance,…

Q: 180 2000 2200 2239

A: The diagram represents the contour lines with  having different RLs. In the given diagram, the value…

Q: Using a suitable scale, plot a rectangular area 5435 m (length of side AB, direction is due South)…

A: Given,

Q: How do plane surveys and geodetic surveys differ?

A: In the plane surveying process of surveying the earth surface is assumed as flat neglecting the…

Q: hat scale ratio was used in the map

A: The scale ratio of a map can vary depending on its purpose and the area it represents. The scale…

Q: How are contour lines determined in a topographic survey?

A: Contour lines are substantial features in topographic surveying as they represent imaginary lines…

Q: Question 1: Attached is a parcel (40m by 60m) with a 10m by 10m grid. Plot contours from 98m to 102m…

A:

Q: What kind of information is provided by U.S. Geological Survey Topographic Quadrangle Maps?

A: The distinctive aspect of a topographic map with the use of contour lines of altitude to indicate…

Q: The scale of a map is given as 1"=600-ft The elevation at point X = 1040' The elevation at point Y =…

A: Solution: Given: Elevation of X= 1040' Elevation of Y= 1160' Distance between X and Y (Run)=2.6" As…

Q: the contour interval of this topographic

A: A counter interval is the vertical distance or difference in elevation between contour lines. Index…

Q: Sample plates about Open Compass Traverse from a topographics map

A: Answer:- Open compass traverse:- A compass traverse is a method of filling in detail on a…

Q: Site Engineering Second Semester 1442 - 1443 (2021 - 2022) MILWAUKEE Pleasant B

A: The analysis is done totally based upon the details of the map.

Q: Given the coordinates of the land defined by fence posts 1-2-3-4-5-6-1 are shown in the following…

A:

Q: If the equivalence scale of a map is 2 cm = 50 yard, what is the scale ratio?

A:

Q: A map is drawn to a scale of 1 : 500. What distance does 145 mm on the plan represent on the ground…

A:

Q: Q2) From the figure below,draw a contour map with scale 1:600 and contour interval (2m). The area of…

A: A contour map is a map that shows the topographic features of the ground

Q: ADJUSTED ADJUSTED LINE DEPARTURE LATITUDE АВ 395.60 352.00 BC 591.60 23.40 CD 78.30 -558.20 DE…

A:

Q: In the map below, the contour lines have a fixed range of 200 meters. Since the height of point A is…

A: Since the range is fixed is 200 m, this means that every contour line depicts a rise or fall of 200…

Q: 3. Draw a labelled contour map of the following using any five contours value. Out of five contours…

A: POND

Q: Briefly describe what is meant by a right handed system of coordinates

A: Introduction : The first right-hand rule is concerned with the force exerted by a magnetic field on…

Q: There are three basic conditions for drawing the subdividing line in simple subdivision: - Passing…

A: Part a  There can be any no of lines passing through a certain point on a line . So there can be any…

Q: II I I| |||| Using the contour map what are the elevations of the contour lines Labeling Contours…

A:

Q: A land shown as 16 cm2 on a 1/200,000 scale map is shown as 4 cm2 on another map whose scale is…

A:

Q: Determine the equivalent length of 15,000m on a graphic scale of a map whose representative fraction…

A:

Q: Figure below represent contour lines for ground surface and wells located on it 50 w2 W1 fill table…

A: given-water table elevation of wells-W1=60W2=50W3=40

Q: Explain characteristics of contours. Write uses of contours and also mention the marks difference…

A:

Q: (a)Draw a sketch of the following figure and determine, by the cross-coordinate method, the area of…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: a) What is the contour interval? b) What is the lowest elevation? c) What is the highest elevation?…

A:

Q: URVEY- ROBLEM, eyor measured the distance between two points marked on a plan drawn to a sc = 1 m…

A:

Q: Describe the steps a land surveyor would need to do when performing a boundarysurvey.

A: A boundary survey is a method of determining property boundaries and genuine ownership borders for a…

Q: a. what kind of topographic landform is represented in the illustration? b. What are the Bold…

A: An illustration of contour have been given in the question and type contour, bold line in contour…

Q: For this assignment you are given three contour maps. Draw a profile elevation for each contour map.…

A:

Q: A NOT TO SCALE TODLI I VERSIUN

A:

Q: Laboratory Report 6 – Area Computation (Trapezoidal Rule) Objective: To compute the area using…

A: given, We have Set of Ordinates taken on a ground. Our aim is to calculate area of that land using…

Q: A topographic map show: O Parcel locations Ob Slope variation O Relief variation Od Cadastral areas

A: A topographic map show   a. Parcel location   b. Slope variation   c. Relief variation   d.…

Q: What is a geocentric coordinate system?

A: to know about geocentric coordinate system

Q: A rectangular area measures 12 chains by 12 chains, what is the acreage!

A: Given: The measured area is 12 chains by 12 chains.

Q: Will the topography help in computing the area?

A: Topography is the study of the forms and features of land surfaces. The topography of an area could…