o T ☺ ťWater flows in the canal of trapezoidal cross section shown in Fig. . The average velocity inthe canal is 10.2 ft/sec. Determine the F, and R, for this flow.y 5 t40-12 ftمرّ للأعلى لاستعراض الفلاترإضافة شرح. ..mum <

Bottam width = B = 12 ft. depth = y = 5 ft. Top width = T = [B + 2* y/tan(40)] = 23.92 ft. Area of…

Answered: Water flows in the canal of trapezoidal…

Water flows in the canal of trapezoidal cross section shown in Fig.. The average the canal is 10.2 ft/sec. Determine the F, and R, for this flow. y5 t 40

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: For the half-Vee channel in Fig., let the interiorangle of the Vee be θ. For a given value of area,…

A: Write out Manning's formula

Q: A 400cm long pipe with a smaller diameter of 3.937 inchesand a larger diameter of 11.81 inches as…

A: Asked: To determine the difference in pressure between the smaller and larger diameter sections.…

Q: Water flows in the canal of trapezoidal cross section shown in Fig.. The average velocity in the…

Q: Q1) Find The magnitude and direction of The Rorce exerted on The Blade shown bulow- by aget, if The…

A: In this, a jet strikes a surface, then two forces act simultaneously that are horizontal force and…

Q: For vertical gate, the flow condition was classified as submerged flow: (a) if t (c) if both (&) > 1…

A: A vertical sluice gate for which we need to choose a flow condition for submerged flow

Q: Q1-10: There is a sluice gate at upstream section of 3.5 m wide rectangular channel (see below…

Q: A trunk pipe of 2 m diameter is laid on a slope of 0.0004. Find the depth of flow when the discharge…

A: Water flow is not always at any time in the station the pattern of unequal flow behavior is…

Q: Q- A straight 100 m long raw water gravity main is to carry water from an intake structure to the…

A: Gravity main is to carry water from intake structure to the jack well of the water treatment plant-…

Q: Three locations are supplied with a big water tank. Determine the flow rate at the pipes and at the…

A: Given that :-Cross-sectional area of pipes and exits (d₁ = d₂ = d₃ = d₄ = d₅) = 0.01 m²Heights of…

Q: Q26: A manual bar screen is to be used in an approach channel with a maximum velocity of 0.7 m/s,…

Q: . Determine the flow capacity of the given gravity pipeline system. Use an air valve that operates…

A: Given :- f=0.02 Diameter of pipe = 1m Head to operate air valve=5m Determine capacity of given…

Q: A rectangular channel of 2.5 m width is carrying a discharge of 4 m³/s. Considering that…

A: A rectangular channel- Width B=2.5 m, Discharge Q=4 m3/s,

Q: The channel in Fig. 7.16 has a triangular cross section and is made of unfinished concrete. If the…

A: Water flow is not always at any time in the station the pattern of unequal flow behavior is…

Q: 1. An open trapezoidal tank is accelerated horizontally at 6m/s2 along its length. Its bottom width…

Q: A pipeline ABC 300 m long, is laid on an upward slope of 1 in 60. The length of the portion AB is…

Q: A pipeline consists of successive lengths of 325mm, 300mm, and 150mm diameter pipe with a continuous…

Q: A 12" pipe carrying 3.93 ft^3/s connects to a 6" pipe. Find the velocity head in the 6" pipe. a.…

Q: The open channel shown has a flow of 30 cfs with n = 0.018. Compute the required 1/2 slope. 2.5 ft 5…

Q: Consider the flow under the sluice gate of Fig. . Ify1=10 ft and all losses are neglected except the…

A: Assume the flow is frictionless. Equate the specific energy at section 1 and 2, we get…

Q: Q5 What is the size of a Steel sewer pipe that flows 30% full a slope of 0.003 with ((d=.... at a…

A: Draw FBD:

Q: Water (p =10 kg/m³) flows through the shown horizontal pipeline. At section (1), the flow velocity…

A: ρ = 10Kgm3P1 = 5KPa = 509.8581Kgm2v1 = 6msArea of the pipes = a = .15m2 Patm = 1498.9829 Kgm2 v1 =…

Q: Q3-A) A hydraulic jump was occurred in a 6m wide rectangular channel. The discharge of flow (Q ) is…

A: Using basic definitions and relationships

Q: A pipe system is using a lake as water source at elevation Om. The water is supplied in a reservoir…

Q: 1.) Verify if the continuity equation for steady incompressible flow is satisfied for the following…

A: Given data: u=3x2-xy+2z2ν=2x2-6xy+y2w=-2xy-yz+2y2

Q: View Policies Current Attempt in Progress Water flows under the sluice gate shown in the figure…

Q: 18- In order to treat peak design wet weather flow = 0.6375 m3/s, where %3D the velocity through…

Q: 3 of 5 9) A 4 ft diameter (D) drainage pipe, made of finished concrete (n = 0.014), slopes at the…

Q: A straight 100 m long raw water gravity main is to carry water from intake to the jackwell of a…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

o T ☺ ť
Water flows in the canal of trapezoidal cross section shown in Fig. . The average velocity in
the canal is 10.2 ft/sec. Determine the F, and R, for this flow.
y 5 t
40
-12 ft
مرّ للأعلى لاستعراض الفلاتر
إضافة شرح. ..
mum <

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

73 l ll GO7:45 Design of hydraulic... -> Q1: A horizontal rectangular channel of constant cross section has a sluice gat. When the gate is partially opened, water flow at 6 m/sec. with a depth of 60 cm. Determine whether a hydraulic jump will occur, and if so, which type is it? How much its height (D2-D1) and find the head loss through it? 1+ 8Fr,2 - الواجب الثاني تكملة رسم احواض التسكين في المثالين الثاني والثالث في المحاضرة مع تاشير الأبعاد
Q3/ A. What are the differences in details between each of the following: 1- Steady flow and unsteady flow. 2- Uniform flow and Non-uniform flow.
The velocity profile equation in Section 1 in a branching pipe flow is defined as: Pipe diameters are respectively D1=20 cm, D2=8cm and D3=4 cm. given. If the uniform velocity in Section 2 is u2=1 m/s, then the average velocity in Section 3 and the current find the direction.
The length of weir of a reservoir is 200 m. long. The depth of water over the weir is 4 m. Find the total time to discharge 1 000 000 m3 of water. Use Francis formula. a. 339.67 sb. 287.62 sc. 186.52 sd. 271.4 s
o T ☺ ť The 40° side slope for triangular channel has a flow rate Q = 16 m3 /sec. Compute a) yc, b) Vc, and c) Sc if n = 0.018. مر ر ل لأعلي لاستعراض الفلاتر إضافة شرح. . . mum <
Water flows in the canal of trapezoidal cross section shown in Fig. The average velocity in the canail is 10.2 ft/sec. Determine the F, and R, for this flow. y= 5 ft 12 ft
Water flows in the canal of trapezoidal cross section shown in Fig.. The average velocity in the canal is 10.2 ft/sec. Determine the F, and R. for this flow. y= 5 ft 40° 40° -12 ft-
A. 283.41mB. 205.12mC. 173.78mD. 195.62mPROVIDE COMPLETE SOLUTION FOR ME TO FOLLOW!