Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in which the pressure is reduced and electricity is produced. The shaft power input to the pump is 1 KW snd the shaft power output of the turbine is 1 kW. Both the pump and turbine are 90% efficient. If the elevation and velocity of the water remain constant throughout the flow and irreversible headloss is 1 m, the pressure of water in kPa at the turbine exit is ____. Include a diagram in yo

Q: 15 m/h water enters the turbine at 20°C and leaves it at 50°C. The internal diameter of the inlet…

A:

Q: A ventilating fan of the bathroom of a building has a volume flow rate of 25 L/s and runs…

A: Given:-  There is a ventilation fan in a bathroom of a building Volume flow rate (Q) = 25 L/s =…

Q: Consider an underground water source whose free surface is 60 m below ground level. The water is to…

A: For solution refer below images.

Q: Liquid water is compressed by a pump from 0.1 MPa to 4 MPa at a rate of 0.15 m³/min If the required…

A:

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: A turbine with an inlet area of 150 cm² receives a steam with a speed of 60 m/s, inlet pressure of…

A:

Q: (0.1 kg/s) of water enters a boiler at (323°K & 5 Mpa), and leaves as steam at (673°K & 5 Mpa). For…

A:

Q: A hydroelectric power plant is used to convert energy from flowing water initially stored in a…

A:

Q: Draw the control volume of a compressor and apply the first law of thermodynamics to it. With…

A: For solution refer below images.

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A: Option a is correct.

Q: As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and…

A:

Q: Water in the rural areas is often extracted from underground water source whose free surface is 65m…

A: To Find :  The power input to the pump in kW . Given :  The height of free surface of water below…

Q: Liquid water enters a nozzle from the inlet with area of 1000 cm2, and leaves the nozzle from the…

A: Given data: Inlet velocity, V1=10 m/s and inlet area of the nozzle, A1=1000 cm2=0.1 m2. Let V2 be…

Q: A pumped storage scheme comprises two reversible pump turbines which transfer water between an upper…

A: Disclaimer:Hello. Since you have submitted multiple questions, we will solve the first one for you.…

Q: Consider water flow in a piping network. The pressure, velocity, and elevation at a specified point…

A: Write the Bernoulli's equation between points 1 and 2. Here, P1 is the pressure at point 1, v1 is…

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: Water is pumped from a lake to a storage tank 25 m above at a rate of 70 L's while consuming 22.4 kW…

A: Given data Water is pumped from a lake to a storage tank 25 m above at a rate of 70 L/s while…

Q: The shaft power of a turbine operating with 80 percent efficiency is 450 kW. If the mass flow rate…

A: Given data: η=80%Pact=450 kWm˙=625 kg/sg=9.81 m/s2 Need to determine the amount of head removed from…

Q: n oil pump is drawing 35 kW of electric power while pumpi

A: Given: The power of motor is, Pmotor=35 kW. Density of oil is, ρ=860 kg/m3. The flow rate is, Q=0.1…

Q: In a steady flow apparatus, 135 KJ of work is done on each kg of fluid. The specific volume of the…

A: The properties at the inlet are marked with 1 as the subscript and the properties at the outlet are…

Q: work is done by each kg fluid. The specific volume of the fluid, pressure, and speed at the inlet…

A: The solution is given below:

Q: A pump increases the water pressure from 8 kPa at the inlet to 700 kPa at the outlet. Water enters…

A:

Q: (a) A garden hose attached with a nozzle is used to fill a 20-gallon bucket. The inner diameter of…

A:

Q: A garden hose attached with a nozzle is used to fill a 40-liter bucket. The inner diameter of the…

A:

Q: The mass flow rate of compressed liquid water through a pump is 20 kg/s and the pressure is…

A:

Q: The cooling system given in the figure is fed with water at a flow rate of 15 g /s and a temperature…

A: Given: T1 = 80°C m˙ = 15 g/s V = 300 cm3 Q = 500 cal/s

Q: Water flows through two adiabatic turbines and a heat exchanger as shown in the picture. Hot air is…

A: INTRODUCTION : Turbine is a work producing device, by taking energy from the inlet either compressor…

Q: Consider a river flowing toward a lake at an average velocity of 3 m/s at a rate of 500 m³ls at a…

A:

Q: Cold water at a rate of 30 L/min is mixed with hot water at 44 L/min in a continuous manner in a…

A: Find the mass flow rate out from the mixture Flow rate of cold water = 30 L/min Flow rate of hot…

Q: As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and…

A: Given data as per question Pressure at inlet = 24 psia Velocity =5 ft/s z1 =120 ft p2 =19 psia v2…

Q: 15 m³/h water enters the turbine at 20°C and leaves it at 50°C. The internal diameter of the inlet…

A: Write the expression for SFEE for the given flow system.

Q: Water enters a pump at 350 kPa at a rate of 1 kg/s. The water leaving the pump enters a turbine in…

A:

Q: possible to generate 3MW of power with a turbine through which 20 kg/s of steam pass under the…

A:

Q: A mining company depleted more than half of its ore reserves and is no longer using all of its shaft…

A: Given: Q - 220 lps = 0.22m3/s h - 1000 m ID - 345 mm f - 0.015

Q: A purifying air cooler is composed of electronic air filter and a water cooling system. The air…

A:

Q: Consider an under ground water source whose free surface is 60 m below ground level. The water is to…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.