Variation of water depth (y) in a gradually variedopen channel flow is given by the first orderdifferential equationIn(y)dydx=101-e 3In (y)-3 ln250-45eGiven initial conditions: y (x = 0) = 0.8 m. The depth(in m, up to three decimal places) of flow at adownstream section at x = 1 m from onecalculation step of Single Step Euler Method is

Answered: Image /qna-images/answer/26fc3d04-ff01-45d1-8b95-ea4a05bdacdd.jpg

Variation of water depth (y) in a gradually varied open channel flow is given by the first order differential equation dy dx = 10 1-e 3 n(y) In n(y) -3 ln y 250-45e Given initial conditions: y (x = 0) = 0.8 m. The depth (in m, up to three decimal places) of flow at a downstream section at x = 1 m from one calculation step of Single Step Euler Method is

Variation of water depth (y) in a gradually varied open channel flow is given by the first order differential equation dy dx = 10 1-e 3 n(y) In n(y) -3 ln y 250-45e Given initial conditions: y (x = 0) = 0.8 m. The depth (in m, up to three decimal places) of flow at a downstream section at x = 1 m from one calculation step of Single Step Euler Method is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A 2.5 kilometer long pipe connects two reservoirs as shown in thefigure 1. The minor head loss in the pipe is 10% of the major head loss.Determine the discharge in the pipe in m3/s.Choices of answers:0.8540.2850.5340.327
The stream function w = 4xy in which y is in cm² per second and x and y are in metres describe the incompressible flow between the boundary shown below: Calculate : (i) Velocity at B. (ii) Convective acceleration at B. (iii) Flow per unit width across AB. .xy=3 A x=3m- B
A sluice gate, as shown in figure 01, is used to control the upstream water level in a3 m wide rectangular channeL The water discharge in the channel is 15 m3/s. Use the Froude number to show that the clitical velocity at yc is given as Uc = .sqrt(gyc)
The flow through a rectangular channel (width in x and height in z) is nonuniform with a velocity profile of V(z) = mz+b. The velocity at the floor of the channel is V(z=0) and the velocity at the top of the channel is V(z=Z). a) Develop an expression for flow rate and average velocity using the given constants. If the channel is 5m wide in x and 3m tall in z and V(z=0) = 0 m/s and V(z=3m) = 6 m/s: b) Determine the value of the constants m and b in the velocity profile c) Determine the value of the flowrate and average velocity of water in the channel.
Considering the system connecting the 4 reservoirs shown, determine the flow in each pipe using Hazen William's equation with C1 = 120 .
3. A stream function is given by 4 = 2x²y + (x + 1)y² The flow rate across a line joining points A(3, 0) and B(0,2) is
4. Considering the following figure with flow from A to D, compute the total head loss from A to D if the flow is 1700 liters per second. Pipe 1: Length = 1000 m; = 900 mm; n =0.011 Pipe 2: Length = 650 m; Ø = 450 mm; n =0,011 Pipe 3: Length = 750 m; = 600 mm; n = 0.011 CIL Pipe 4: Length = 460 m; 0= 750 mm; n = 0.011
b. Figure 3.2 is the flow of a channel having a large width, b, under a sluice gate. Assuming frictionless steady flow with negligible upstream kinetic energy, derive a formula for the dimensionless flow ratio Q? (y2 b2 g) as a function of the ratio2/y, . Show by differentiation that the maximum flow rate occurs at Y2 = 5V, Gate V2 Figure 3.2 : A Schematic diagram of flow downstream of sluice gate
Handwritten solution required for this FM problem. Show detailed work
Errors.
The stream function w = 4xy in which y is in cm² per second and x and y are in metres describe the incompressible flow between the boundary shown below: Calculate : (i) Velocity at B. (ii) Convective acceleration at B. (iii) Flow per unit width across AB. .xy=3 A x=3m- B
Please answer question in detail subject is fluid mechanics