To produce low heat cement A-Increase C3S and C3A with reducing C2S contents B-Increase C2S and C3A with reducing C3S contents C-Increase C3S and C2S with reducing C3A contents D-increase C2S with Reducing C3S and C3A contents

To produce low heat cement A-Increase C3S and C3A with reducing C2S contents B-Increase C2S and C3A with reducing C3S contents C-Increase C3S and C2S with reducing C3A contents D-increase C2S with Reducing C3S and C3A contents

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Q No. Assignment questions Draw S.F and B.M diagram for a beam shown in fig 30 KN hm 4okN 50 KN A 1.…

Q: When tested, a 15 cm cube concrete specimen showed lower compressive strength compared to a 10 cm…

A: Given, when tested, a 15 cm cube concrete specimen showed lower compressive strenght compared to a…

Q: Q1 /Choose the correct answer. 1-To prevent the flash set from happenin. Gypsum is added to cement…

A: 1- To Prevent the flash set from happening cement Gypsum is added to the cement. Explanation: Gypsum…

Q: choose true or false The No.4 sieve has 4-inch wide openings

Q: During the hardening process of slaked lime, Lütfen birini seçin: O A. Volume expands about 2.5 to 3…

A: It is required to answer what happens when slaked lime hardens.

Q: Design bond stress in limit state design method for deformed bars conforming to IS :1786 and M-20…

A: Deformed bars- M-20 concrete To Find- The design bond stress in LSM as per IS:1786.

Q: Once in civil engineering, what is the minimum curing period typically recommended for concrete…

A: In civil engineering, the minimum curing period for concrete structures typically depends on the…

Q: What is the prestress steel loss from steel relaxation at 356 days for a Grade 270 low-relaxation…

A: Given:- Initial stress = 190,000 psi Yield stress = 245,000 psi Time period = 356 days To…

Q: Hydration of cement is due to chemical action of water with Tetra calcium Aluminoferrite Tricalcium…

A: Answer: d)Tricalcium silicate and Dicalcium silicate

Q: Which of the following compounds contribute to early strength gain and it makes up about 40%-60% of…

A: Option A is correct..

Q: Q1 Define five of the following with sketch compulsory. ( 1-Allotropy 2-BCC 3-yeild strength 5-…

Q: Locate centroid of composite area

A: Centroid is the center distance from the axis to the given area it gives an idea about the distance…

Q: 25 - Which of the information given about gypsum and lime is wrong? A) The calcination temperature…

A: A) Statement A is right as the calcination temperature of lime (900 degree Celsius -1100 degree…

Q: 6. The temperature of concrete for highways reaches 60C in summer, and in winter the temperature…

Q: Hydration of cement is exothermic process that generates heat. The table below shows the heat…

A: Option-a:This option implies that utilizing any of the specified cement components is unsuitable for…

Q: Collapse slump of the concrete can be treated by adding fine materials to the paste absorbing the…

A: Given: collapse slump we have to add fine materials to find: effect of adding fine materials to…

Q: Q-One of the most important factors that construction materials depend on for their moisture…

A: Given : The construction materials depend upon which factor for their moisture resistance

Q: e properties of five different pozzolans: Ground blast furnace slag, Silica Fume, Class F fly ash,…

A: Pozzolans, a large class of siliceous and aluminous minerals, are chemically reactive with calcium…

Q: 50- Vibration compasted Hand compacted Compressive Strength (28 days) MPa 15 0.6 Waterlcement Ratio…

Q: 9.6 Refer to the following pictures and identify the likely cause of concrete cracking from the…

A: Figure is as shown in the question.

Q: I also need FBD in this solution

Q: at is the foundation bearing pressure beneath

Q: How to prevent retained austensite

A: By controlling the below parameters we can prevent retained austensite. It is very necessary in…

Q: 1. The repair and rehabilitation of damaged or spalled concrete is done by removing the

A: This question is related to the Prestressed Concrete Structure from Design Concrete Structure.

Q: Give FOUR factors affecting the durability of concrete (C2) (CO1:PO1).

A: The ability of concrete to resist chemical attack, abrasion, and weathering action is called as…

Q: féz 4000 psi, NWC Grade 60 steel, &#8 Mn = ?

A: Answer We know that Nominal Moment capacity of singly reinforced beam is given by Mn = As*Fy*z As =…

Q: What are the two main reasons that steel corrodes inside reinforced concrete? ingress of chlorides…

A: Two major factors which cause corrosion of rebars in concrete structures are carbonation and ingress…

Q: In pressure grouting technique, the slurry contains * O PFA microsilica all of the mentioned O…

A: Grouting : Grouting is technique which is used to increase the strength of soil . In pressure…

Q: When determining the performance of the elements manufactured in the jet grout method, which one…

A: Jet grout method:It is a soil stabilization process, here the cement-based grout is injected below…

Q: The "slump" test is E. For room temperature and axial loading, aluminum behaves as a brittle…

A: ANSWERS 1. False because slump test is done to find the workability of the concrete.

Q: Which of the following statements is correct? A) Pozzolans react with Calcium Silicate Hydrate…

A: Pozzolans are silicate-based compounds that combine with the calcium hydroxide produced whenever…

Q: ): In a laboratory examination on a model of bricks, it was found that: 1. Moisture content 10% 2.…

A: Given data in question Moisture content 10% Saturation degree 39% Apparent specific gravity 1.83 To…

Q: Pozzolans materials chemically react with. CaS, which is normally present in the largest amounts,…

A: 1. Pozzolans materials chemically react with the Calcium Hydroxide to form cementitious properties A…

Q: Q1) What is retrofitting of concrete structures? (CO2-PO2, C1)

A: Retrofitting is strengthening the building , either for dilapidated building or deteriorated…

Q: Which of the following directly causes sulfate attack in concrete? CH Delayed ettringite formation…

A: Sulfate attack in concrete is mainly caused by the reaction of sulfate ions with calcium hydroxide…

Q: The area of the concrete in compression plus the area of reinforcement transferred on the basis of…

A: It is asked in the question that the area of concrete in compression plus area of reinforcement…

Q: The volume and mass are changed with Both options are above O Forming process. O Cutting process.

A: Excavation is much more than essentially burrowing an opening. Unearthing implies moving and…

Q: During the transformation of C3A, the strength of the cement paste lead to decrease in at the late…

A: The transformation of calcium aluminates hydrate from the meta stable hexagonal form to the stable…

Q: Two composite bars have the following composition. At an initial temperature of 5 degree C. there is…

Concept explainers

Types of Cement

Cement is a fine mixture of limestone, chalk, or marl and clay which when mixed with water, becomes compacted due to the formation of strong molecular bonds. Due to hydration, cement turns into a hard mass when left for a sufficient amount of time upon mixing with water. The water turns the cement compounds into gel-like submicroscopic particles having higher surface areas. It is due to the hydration properties of cement, they are often known as hydraulic cement. For instance, Portland cement is a popular example in this category.

Question

Choose the correct answer

To produce low heat cement

A-Increase C3S and C3A with reducing C2S contents

B-Increase C2S and C3A with reducing C3S contents

C-Increase C3S and C2S with reducing C3A contents

D-increase C2S with Reducing C3S and C3A contents

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Answer

VIEW

Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

If width of the expansion joint is 1.7 m in a cement concrete pavement. The laying temperature is 38°C and the maximum slab temperature in summer is 50°C. The coefficient of thermal expansion of concrete is 4 x 10-5 mm/mm / °C and the joint filler compresses upto 28% of the thickness. The spacing between expansion joints is S mm then Value of S is mm.
I need the answer quickly
Help
Which of the natural stones below cannot be used as a concrete aggregate? Gypsum a. Basalt Ob. Limestone d. Quartz
An exterior beam, located in Toronto, with a rectangular cross section has a width of 1000mm, height of 1300mm and consists of 12-35M bars, and 10M stirrup. Given that the spacing between the bars is 50mm, how many layers would you need to fit the bars in? f'c = 25 MPa fy = 400 MPa Es = 200GPa Maximum aggregate size: 20mm Minimum required Width value = Blank 1 mm # of layers = Blank 2
Plz
need asap for this question
The tricalcium aluminate compound present in cement Lütfen birini seçin: ΟΑΑlof therm O B. does not make significant contribution to the ultimate strength of cement. O C. is responsible for highest heat of evolution O D. characteristically fast react with water O E. provides weak resistance against sulphate attack
Q2) Why retrofitting of concrete structures is important? (CO2-P02, C1)
Pls fast hand written solution
Listen Concrete is required for the construction of an agricultural dairy barn floor slab in Central Alberta. The floor slab will be exposed to freeze/thaw conditions. Which of the following exposure classes best describes the environmental conditions that the concrete will be exposed to? A) A-2 B) A-4 OC) S-1 OD) S-2 APIO--:--) OLDG BO
the properties of concrete and its importance to the structure