Through flow velocity is 0.35 times the peripheral velocity. Find the diameter, and A. 7.11 m B. 7.3 m C 15 m D. 0.59 m minimum speed ratio. A 1.7 B. 0.83 C 3.0 D 401

Q: lin = 401. %3D Vc =? Given Oz BE 1.25" Be= 2.15" CD=2. S2" W2= 400 Las 02 4 400 AD 3 2.

A:

Q: A triangular gutter with side slope at angle 60 • has a depth 300 mm. Find the velocity of water, if…

A:

Q: where do v sub 1 came from? which is 0.95m/s

A:

Q: 1 QUESTION 1 Consider a desired pump operating condition which adds 35 psi at a flowrate of 500 gpm…

A: Given data  Flow rate = 500 gpm Pressure = 35 psi Density = 62 lbm/ft^3 Find the pump head

Q: For the water shooting out of the pipe and nozzle as shown in Fig. find 1- the flow rate (Q) through…

A: (1) To find: The flow rate through the pipe. Given: The diameter at A is DA=200 mm. The diameter at…

Q: Q3: For ideal fluid, Find the force required to hold the blade in position, if the weight (1kN) and…

A:

Q: Q3) A pump is used to transfer an oil between two tanks through a pipe of diameter 20-0.2 (cm),…

A:

Q: A large artery can have a diameter of about 0.5 cm, whereas a large vein may have a diameter of…

A: A large artery diameter = 0.5 mA large vein diameter = 0.8 mThe average blood velocity in artery =…

Q: Design the rectangular duct system shown in figure below using equal friction method with frictional…

A: Given Data∆P=1Pa/mh=300mmQD=0.6m3/s=QF=QI=QJ

Q: An adal-fow gas turbine rotor receives a flow of gas at a velocity V The gas leaves the stator with…

A:

Q: The parameters of a turbine in Figure 1 are r =1.8 m, the specific density is p = 1000 kg/m3,…

A: Given: The radius of the turbine, r = 1.8 m The density of the fluid = 1000 kg/m^3 The turbine…

Q: Consider a desired pump operating condition which adds 35 psi at a flow rate of 500 gpa to water.…

A: Given data  Pressure = 35 psi Flow rate = 500 gpm Density of water = 62 lbs/ft^3 Find the pump head…

Q: 4. The pipe system shown in the Figure. The flow rate in pipes AB and FG is 0.88 n'/s. All pipes are…

A:

Q: A 200 kg chunk of lead falls from a height of 30 m and smashes into a rigid concrete floor.…

A: Disclaimer: “Since you have asked multiple questions, we will solve the first question for you. If…

Q: 6a. Water goes through an inlet pipe at 5.0 × 10° Pa with a speed of 6.0 m/s. If the inlet pipe has…

A: Continuity and Bernoulli principle are applied to arrive the solution.

Q: The known mean velocity is 15.6 mph at a site at a height of 31 ft (about 10m). Approximate the wind…

A: Given data: H1 = 31 ft V1 = 15.6 mph H2 = 100 ft p = 0.3 To find: V2 = ?

Q: A pump delivering 0.23 m3/s of water has a 304.8mm diameter suction flange and 254mm discharge…

A: Given:Water flow rate, Q=0.23 m3/sSuction flange diameter, ds=304.8 mm=0.3048 mDischarge flange…

Q: The monthly wind speed for Baghdad station 3 m/s at height 10m and S.D is equal o.75, Calculate the…

A: given; specific density(S.D)=0.75at height(h1)=10mwind power density(ρ2)=?at height(h2)=50m

Q: 4.W.4_ Given: Vehicle Velocity = 50m/s discharge = 5 m/s O = IB0° VI neglect frictions Find the…

A:

Q: What power can be delivered by the turbine if its efficiency is 100%? The water flow rate is 0.01…

A:

Q: A fireboat is putting out a blaze from a beach bonfire that got out of hand. If the nozzle angle is…

A:

Q: Plate 30m V, Rx= Given z Rx = 890 Y %3D water

A: Given that, Rx=890 N,head of water, h=30 m,θ=90°ηt=90 % v=2ghv=2×9.81×30v=24.261 m/sec The…

Q: I need complete solution (step by step process) with given. Thanks Note: Instead of using g = 9.81…

A: Hl=1.39 mL=40 mf=0.012Q=600 L/s =0.6 m3/sg=9.806 m/s2

Q: eter 20mm and vertical int 'B') water is flow t a is 0.008. Pressure hea

A:

Q: To 212 F Water at 65 F flows nto a boiler at 5 gal min. It is converted to steam at 212 F Find the…

A: Given Data State 1: Saturated water, 65°F State 2: Steam, 212°F V= 5 gal/min

Q: Initial velocity=0 m/s Final velocity=21 m/s Time=2 s Required accelergtien

A: Given data : Initial velocity=U Final velocity=V Time=t   To find : Acceleration

Q: Q2 .. h, are 12m. The pump efficiency is 79%, and the pump is driven by an electric motor. A pump…

A:

Q: Fnd the Farce applied W=2.355 J d= 1.124m

A:

Q: Q9- if the pump shown in figure develops 5hp on the flow what is ti (Q=0.0335m/sec)

A: given:P=5HP

Q: 30cm pipe Ys as shown in fgure. Find the torce în x 4 the flow yak 1s at 300ps 2 with the pessure…

A: Given Diameter = 30 cm = 0.3m Pressure = 30 X 104 N/m2 Flow rate = 300 l/s = 0.3 m3/s To find Force…

Q: The branched pipe as shown in figure below discharges water. The diameters of the pipe 1 is 1.5 cm,…

A: Given,  Diameter of pipes , d1 = 1.5 cm , d2 = 4cm and d3 = 3.5cm Discharges in the pipes , Q1 = 21…

Q: A pump delivers water from a tank (A)X water surface elevation=D110m) to tank B (water surface…

A:

Q: EL..20m K=0.5 A= fi= 0.02 D₁-0.3m Lis 150m F₂2 0.02 Da= 0.6m L₂=240m Valve For Valve K= 0.2 EL.: 5m…

A:

Q: A Pelton wheel is supplied with 6kg/s of water at 70m/s. The buckets rotate on a mean diameter of…

A: Given , Pelton wheel  mass flow rate =  6kg/s velocity v1 =  70m/s. deflection angle = 165º mean…

Q: Hydraulic efficiency 85%, find Q in li/s. Power delivered 10,500 kW head of 320 m

A:

Q: ump has the following characteristic: Volume flow rate (m³/h) Head (m) 23 46 69 92 115 17 16 13.5…

A: A curve is plotted using the above data sets. Since we have two reservoirs and there is a difference…