The spiral shown in figure 1 is square, 4 cm on its side af with 3 turns. A magnetic field given by: B = 0.2xy(t + 1) k With t in seconds, x and y in meters and B in Teslas, passes through it. Determine for t = 5 s: a) Determine the magnetic flux. b) Induced emf.

The spiral shown in figure 1 is square, 4 cm on its side af with 3 turns. A magnetic field given by: B = 0.2xy(t + 1) k With t in seconds, x and y in meters and B in Teslas, passes through it. Determine for t = 5 s: a) Determine the magnetic flux. b) Induced emf.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A metal rod 1 m long rotates about one end in the plane perpendicular to a uniform magnetic field of induction 0.38 × 10 ¹Wb/m². If it performs 720 revolutions per minute calculate e.m.f. induced between its ends.
The conductor of length 10 cm moves with a uniform velocity of 5 m/s at right angles to a magnetic field. If the e.m.f. induced in the conductor is 2.5 x 105 volt. Calculate the magnetic induction.
3. 3. a) 3. b) 3. c) 8 Ø Ø Ø 8 Ø As shown in the figure below, a conductor bar starts from rest and slides vertically down along a conductor track while maintaining good contact. The uniform magnetic field is 0.207 in the whole space. The width of the track is 0.50m. The mass of the bar is 0.10kg. The resistance of the track is negligible, but the resistance of the bar is 3.02. For all calculations below, ignore air resistance and friction. Calculate the induced current in the bar when the bar reaches a constant falling speed under the combined influence of its gravity and the magnetic force. Calculate the constant speed at which the bar can fall under the combined influence of its gravity and the magnetic force. Describe the energy conversion in the process, and show that your results from parts (a) and (b) agree with the conservation of energy. Ø Ø Ø Ø
a bar magnet is brought closer to a conducting wire loop with 7Ω of resistance. As a result a uniform 3 A current is induced in the wire. What is the rate at which the external magnetic flux is changing indies the wire loop? Explain the reasoning behind your selection in detail. A) 5 T m2/sB) 10.5 T m2/sC) 21 T m2/sD) 42 T m2/sE) 84 T m2/s
A rectangular 30.0 cm by 50.0 cm circuit carrying a 15.0 A current is oriented with its plane parallel to a uniform 0.400 T magnetic field as shown in the figure below: a.) Calculate the magnitude of the force on segment ba b.) Calculate the initial torque exerted on the rectangular circuit
17. A U-shaped wire is bridged by a small metal rod AB of length I, and the distance of the rod from the left end of wire is a at initial moment t=0 as indicated in the right figure. A uniform magnetic field is directed into of page. Now move the rod at constant velocity y to the right as indicated.(a) Calculate the magnetic flux through the loop formed by the wire and rod at any instant t. (b) Find the emf induced in the loop as the rod is moving. (c) Indicate the direction of the current induced in the loop. O wire 8 Al -rod t30
b.) Find the net magnetic field at P. 10.) When a magnetic field is first turned on, the magnetic flux through a 10-turn coil varies over time. The equation for the magnetic flux is m = 200.0t2 – 120.0t, where the magnetic flux is measured in webers, and the t is in minutes. The loop is in the plane of the page, with the unit normal pointing out of the page. dºm a.) Calculate an expression for dt b.) Find an equation for the induced emf as a function of time.
A metal rod moves with constant velocity along two parallel metal rails connected with strip of metal at one side as shown in Figure. A magnetic field B = 0.35 T points outof the page. If the rails are separated by distance ZL = 25 cm and the speed of the rod isv= 55 cm/s, find a) the induced emf and direction of induced currentb) the amount of heat released in this system in 3 min if the rod has resistance of 18 Qand the rails have negligible resistance.
The current in a long solenoid of radius 6 cm and 22 turns/cm is varied with time at a rate of 3 A/s. A circular loop of wire of radius 8 cm and resistance 7 0 surrounds the solenoid. Find the electrical current induced in the loop (in HA). HA
Considering the following system of a magnetic induction grill: Number of turns = 30 Current = 10 A Voltage = 23-50 V Frequency = 23-50 kHz Internal Radius = 25 mm External Radius = 31 mm Considering that the 30 turns are distributed between the internal radius and the external radius, calculate the magnetic field on a circular path of radius internal radius, radius and external radius as shown on the figures. Justify your answer.
A "double-loop" planar structure shown in the figure below is made out of a thin wire with the resistance per unit length 5-0.131 /m. The length parameter of the structure a-47.4 cm. The structure is in the region of the uniform magnetic field as shown, where the normal component of the field changes with time t as B(t)-B, cos(2xft), where amplitude 8-349.8 G and frequency f-74 Hz. B a 2a X X X X Xax Q With the harmonically varying magnetic field, the induced currents in various segments of the structure will also be changing periodically with the same frequency. Find magnitude Io of the variable induced current in segment PQ shown in the figure: Jo=
AM Mon Nov 7 bconline.broward.edu b) 2.1 nT c) 1.6 nT d) 3.1 nT e) 3.6 nT 48 6. The electric field amplitude of the signal at that point is 0.780 V/m. What is the amplitude of the magnetic field of the signal at that point? a) 2.6 T 67% 1