The refrigerant R-134a enters a 29 cm diameter pipe at a speed of 4 m/s. Since the flow is continuous, which of the following is the inlet volumetric flow rate of the refrigerant R-134a? a) 0,3303 m³/h B) 0.3079 m³/h NS) 0.2642 m³/h D) 0.3217 m³/h TO) 0.3619 m³/h

The refrigerant R-134a enters a 29 cm diameter pipe at a speed of 4 m/s. Since the flow is continuous, which of the following is the inlet volumetric flow rate of the refrigerant R-134a? a) 0,3303 m³/h B) 0.3079 m³/h NS) 0.2642 m³/h D) 0.3217 m³/h TO) 0.3619 m³/h

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

8 -

The refrigerant R-134a enters a 29 cm diameter pipe at a speed of 4 m/s. Since the flow is continuous, which of the following is the inlet volumetric flow rate of the refrigerant R-134a?

a)	0,3303 m³/h

B)	0.3079 m³/h

NS)	0.2642 m³/h

D)	0.3217 m³/h

TO)	0.3619 m³/h

Expert Solution

Step 1

Given data:

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

23 - An electric water heater is supplied with a current of 0.2 Ampere from a 120 Volt source. What is the electrical work given to the water when this heater is operated for 5 minutes? a) 432 kJ B) 0.288 kJ NS) 0.12 kJ D) 7.2 kJ TO) 180 kJ
From the system of pipes that conducts water shown in the figure, we have that the velocities v1 = V2 y V3 = 3*V2, and the volumetric flow 4 is 30% of the volumetric flow 5, that is to say 8, = 0.385. Determine a) Speeds V1, V2, V3 b) The diameter of pipe 4, D4 c) The total volumetric flow in liters/ s, the total mass flow in kg /s and the total weight flow in N/s Pipe 1 Pipe 4 D1 = Scm D4 =? V1 = V2 V3 = 3V2 D2 = 3cm D5 = 10 cm Pipe 2 V5 = 8 m/s D3 = 2cm Pipe 5 Pipe 3
A valve is installed in a part of the pipeline system and due to flow restriction, the pressure drop is 12 kPa. If the velocity and density of the fluid is 6 m/sec and 680 kg/m^3, respectively, determine the minor loss coefficient of the valve? a)2.08 b)0.58 c)1.08 d)0.18 e)0.98
A valve is installed in a part of the pipeline system and due to flow restriction, the pressure drop is 18 kPa. If the velocity and density of the fluid is 4 m/sec and 750 kg/m^3, respectively, determine the minor loss coefficient of the valve? A)1 B)5 C)2 D)3 E)4
7 and 8
10 - What is the specific volume of air leaving a continuous flow adiabatic diffuser at 159°C and 100 kPa? a) 1.1532 m³/kg B) 0.4409 m³/kg NS) 0.4563 m³/kg D) 1.2398 m³/kg TO) 1.0532 m³/kg
Subject Date No. 41- The and increases water Pump delivers 0.6I Kglsee the Pressare by 560 mmH it's efficincy is o82,The fump Power is? a) 181.5 K W b) 45 K W c) none of these D) 133.4 w
if a 136.51g Al rod (c=0.900 j/g°C) is at 100.0°C and placed into 250.0g of water at 21.8°C, what is the temperature of the system (rod + water) at equilibrum assuming no losses to the surrounding? a) 46°Cb) 30°Cc) 206°Cd) 18°C
Fluid with a density of 950 kg/m^3 and velocity of 2.632 m/sec flows through a pipe diameter of 40 mm pipe . Determine the entrance length if the viscosity of the fluid is 0.001 kg/(m-sec)? a)0.51 m b)2151 m c)5001 m d)0.87 m e)0.4 m
Electric power is generated in the hydroelectric power plant with a turbine-generator system, which has a water input of 45 m3 per second from a height of 53 meters and operates with 73% efficiency. Calculate the electrical power generated in the plant since the friction loss in the pipes is neglected. A) 1,7 MW B) 17 MW C) 32 MW D) 171 MW E) 23 MW
22 - The volumetric flow rate of the refrigerant R-134a entering a compressor at 140 kPa pressure and – 10ºC temperature is 1.23 m³/min. What is the mass flow rate of R-134a? a) 0.1229 kg/h B) 0.7376 kg/h NS) 0.1404 kg/h D) 0.6804 kg/h TO) 0.1134 kg/h
A heat exchanger enters 25 kg of water vapor per minute as saturated steam at a pressure of 800 kPa and gives heat to the surrounding air at constant pressure, all of which comes out as saturated liquid. Accordingly, what is the change in the entropy of water in unit time? a) -2.523 kW/K b) -1.923 kW/K c) -4.616 kW/K d) -0.978 kW/K (please can you help quickly) thank you everything