-The Line Voltages at the terminal ofabalanced A-Connected Loud isEachPhase of the Load consistof 6+182/+) Find the lagnitud of the Linecurrent Feedthe loadb) Find the phase curreat inc) praw the Phasor diagranm of the phaseeach fhaseand Line eurrents take VAB as efekence

Per phase load in Delta connect 6+8j ohm Line voltage VAB = 100∠0 Line current? Phase current?…

-The Line Voltages at the terminalof abalanced A-Connected loud is-- Each Phase of the load consistof 6+1852/4 Find the wagnitud of the Linecurrent Feed the load b) Find the phase curreat in each Phase c) praw the Phaser diagranm of the phse and Line eurrentstake VAG as afekence

-The Line Voltages at the terminalof abalanced A-Connected loud is-- Each Phase of the load consistof 6+1852/4 Find the wagnitud of the Linecurrent Feed the load b) Find the phase curreat in each Phase c) praw the Phaser diagranm of the phse and Line eurrentstake VAG as afekence

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Ep Load = 927 V IL Secondary = 109.06 Ratio = 1:2.5 Z = 8.5 Ohms Find: EP Primary: ? Ep…

Q: e balenced, postive phaequenon, three-phase crou. ZLA 20OLO Vm ZLB B in 9. Zhe=100L60° 2

A: Given source and load are balanced so we can use per phase analysis. Apply KVL in the loop to get…

Q: 200/0°V L In the circuit in the figure; • Ly load draws 15 kVA with lagging power factor 0.6. • The…

Q: R = 609 ohms L=0.57 mH C = 125 pF www R Calculate the following: a. XL and XC b. Total I and…

A: Given that Series RLC circuit. R = 609 ohms L = 0.57 mH C = 125 pf Vs = 120 v f = 60 Hz

Q: Three phase power supply load R is 1699 VA, S is 15584 VA and T is 12818 VA. Find (a) the…

Q: What is the scale in this diagram?

A: Given: Phasor diagram of a balanced delta load

Q: Ithe Load consist of lo30 52

A: The star-connected load is a commonly used load in which the line current and phase current is the…

Q: CALCULATE THE THREE-LINE VOLTAGES AND THE PHASE VOLTAGES (with a degrees), THE LINE CURRENT, THE…

A: Note: In last three rows both line and phase current are mentioned (e.g Ian/Iab). so we assume it is…

Q: In a resistive load, the current angle: O Leads the voltage by 90. In phase with the voltage angle.…

A: There are three basic elements are present in an electrical circuit. They are resistance, inductance…

Q: Assigunent two (2) 14 3 phase, 8 pole, bottz Star-connec dolternator has 63labith lo turns w Coil.…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: ER Es ET IR URS Is !T Rine Rine Rine N Road Road Road U₂ bad Load Load Load

A: Answer : given that Line-to-line voltage URS=400∠30° V Line Resistance Rline=2 ohms Load…

Q: For the series-parallel arrangement shown in Figure, determine the equivalent series circuit…

A: The given circuit is From the given circuit the impedance of the branched connected in parallel…

Q: If the mesh current 12 = 0.827117.17° A, the supply curent l=1.2L45° A, and R=2.2 0, for the…

A: To find the power factor of current source in the given circuit

Q: Question: For the basic chopper circuit Edc= 50 V, R= 80 ohms, duty cycle is 30% then the average…

Q: 5mH 500 www m ~6V.COs (20T-1000+) {1k Luf reepeer 100mH

Q: A three phase load is connected in delta to a three phase 440 V, 50 Hz mains. An inductor of 100 mH…

A: Solution: A three phase load is connected in delta, voltage V=440 v, f=50 Hz, Inductor L= 100mH…

Q: Given a parallel circuit shown below, determine the: a. Branch current b. Total current c. Total…

Q: 44eV,50Hz IM has star conectd 31 at o3pf. find 3 phase

Q: Consider the following circuit, the value of Ris 2 220V f=50HZ Draw the power triangle indicating…

Q: A balance albc-seq ven ce Y-connected source with Van- idoL30'v Y-connected source with Van=…

Q: Vhat is tne avergge parer cansumed $y tae charge!

Q: Alternator 1 80 EL 200 V Fill in the values below for the figure above. Altemator 1. E phase=, 2. I…

Q: In a resistive load, the current angle: Leads the voltage by 90. In phase with the voltage angle.…

A: In this answer let us try to explain how the current angle and the voltage angle are oriented with…

Q: Explain this delta connected balanced load

A: In this question, We need to explain delta connected balanced load.

Q: 3. Three impedance of 3-j42 are connected in delta across a 400V,50HZ 30 AC supply. Find all the…

Q: n balancedsphase system the Sequguce is Positive and'aline Valtage Vbe=208/-70V The load is balancet…

A: 3 phase balanced system, positive sequence Line voltage Vbc = 208∠-70V Two parallel Loads connected…

Q: Pa balanced sphase system the Sequeuce is Positive and'aline Valtage Voe=208-70V Fhe tot is balancet…

A: We convert the delta connected load to star to draw per phase equivalent circuit

Q: 22.) The figure below shows a series-parallel circuit. Find the magnitude of the total circuit…

A: The solution is given below

Q: Three identical coils, each of resistor 8ohm and inductor 15ohm are connected in star to a phase…

A: Given, R=8 ΩXL=15 ΩVph=210 Vf=50 Hz

Q: The B-l1 is the equation for the positive sequence phase current of the phase

Q: A voltage and current applied to a single phase load is v= 145 sin (300t+40) and i= 115 sin (250t-…

Q: Determine the nodal voltages for the networks in Figure? ane 1₁ = 3A 40° 000 501 40 20 1₂ = 5A230

Q: Pa balanced sphase system the Sequece is positiveardaline Voltage Vbe=208/-70V The load is balancet…

A: In balanced three phase system, Iine to line voltage at sending end Vbc = 208∠-70V Two Load…

Q: Use node voltage analysis to determine the phasor V₂ in Volts and select the nearest answer. 18 Ω m…

A: The question is about finding node voltage Vx using nodal analysis.

Q: 12. Refer to the circuit below. The alternator has a line voltage of 240 V and the load has an…

A: In this question, Star connect alternator is supplied to Delta connected load. Find the phase,…

Q: In three phase power measurement using star connected system, reactive power can be calculated…

A: In star connection Line voltage Vph = VL (line voltage )/ √3 Line current IL = phase current Iph

Q: In balanced star (wye) connected system, the line voltage is 0 707 times the phase voltage phasor…

A: Electrical machines can be either generator, transformer or motors. They can be either Ac machines…

Q: What are the line voltage's phases?

A: Given data, Voltages, Van=2202∠0° VVbn=2202∠240° VVcn=2202∠120° V Frequency f=50 Hz Resistances…

Q: Three loads, each of resistance of 22 22 and reactance of 44.92 are connected in delta with a…

Q: 202 lor

Concept explainers

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.

Question

100%

-The Line Voltages at the terminal of
abalanced A-Connected Loud is
Each
Phase of the Load consistof 6+182/+
) Find the lagnitud of the Linecurrent Feed
the load
b) Find the phase curreat in
c) praw the Phasor diagranm of the phase
each fhase
and Line eurrents take VAB as efekence

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Hi this is gonna be on my final exam in April. But I have a hard time understanding how to solve these problems, help would be appreciated! Thanks
Hard: Basic: Write the currents on the following ammeters. HHH+ 1. The resist of equal the rema 0.45A 0 30A 0.15A 6. SAY 3. The p hob. show con Medium: sup ide 8. 0.30A (A A0.6A 0.30A 11. 0.3A 0.15A 0.45A 12. 13. 0.05A Villiers High Sehool
In a delta connected load Select one: O a. Phase and line currents are not equal O b. Phase current is zero Oc. Phase and line voltages are equal O d. Phase and line voltages are not equal
500 N 1000 N 160 nF 100 mH R = 500 A, R3 = 1000 N, L = 100 mH,C = 160 nF,i,(t) = 4 cos 5000t mA %3D %3D i,(t) = 4 cos 5000t mA Sinusoidal current sSource Voltage on sinusoidal current source Voltage on capacitor Current passing through the capacitor Inductance voltage, Current flowing from inductance Voltage over resistance R, = 500 N R2 = voltage over 1000 resistors Vct) ic(t) VR, (t) VR,(t) ia) a-4 mAR ta) O--4 VAR Which of the following is the reactive power on the current souroe? d) --U mVAR e) Q- 12 MVAR 1) Q- 12 mVAR
A three phase star connected alternator is supplying two loads both in delta. The alternator line voltage is 512V. The impedance are 20 ohm and 25 ohm. Find the phase current for 25 ohm load
4-1.) What is the phase sequence of a balanced three-phase circuit in which ??? =277 ∠ −300 and ??? = 277 ∠ 900, what is ????
The reference for phase measurement is the a. positive imaginary axis b. positive real axis c. negative imaginary axis O d. negative real axis
The values of the circuit elements are given below.Accordingly, what is the maximum power transfer that can be made to ZL? V=11.7 phase 30 VR=12 ohmsL=j20 ohmsC1=-j14 ohmsC2=-j8 ohms
Hi this is gonna be on my final exam in April. But I have a hard time understanding how to solve these problems, help would be appreciated! Thanks
9 In balanced 3phase system the Sequgace is positiveard'aline Voltage Vbe=208/-70V The toat is bataacet also Vin faraltlet with Arthe phoase impedaacesof the two load ake 5136.2214p 3-19.2/0 esfectivelye The line imfedance is loftja824p. Draw the singte phase equivelent Circuit and use It te calculate'the Line VolFage at the load in the a-phaase Find total Powler loss in Linee