The length of a spiral curve is equivalent to 124 meters and it's radius is 56 meters. If the speed of the vehicle tranversing the curve is 69kph, what is the rate of change centripetal acceleration in m/s^2?

The length of a spiral curve is equivalent to 124 meters and it's radius is 56 meters. If the speed of the vehicle tranversing the curve is 69kph, what is the rate of change centripetal acceleration in m/s^2?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A vehicle is required to travel 540 meters between points A and B in exactly 40 seconds. The vehicle…

A: Given. Time (t) = 40 sec Distance (s) = 540m Acceleration (a) = 1.8 m/sec2

Q: Determine the minimum radius of curvature that should be used for a highway if a car's normal…

Q: A car travels along the level curved road with a speed which is decreasing at the constant rate of…

Q: traveling AIn approximated by parabolay When the sled is at point A (XA = 2 m, yA =1 m), the sled's…

Q: A highway curve with a radius of 1 50 meters is banked so that there is no lateral pressure…

A: Given data, v = 50 km/hr Radius of car, r = 150 m Gravitational constant, g = 9.81 m/s2 To find…

Q: The figure shows two possible paths for negotiating an unbanked turn on a horizontal portion of a…

A: Given data ρA=88 m ρB=187 m Determine maximum speed of each path ?

Q: The length of a spiral curve is equivalent to 124 meters and it's radius is 56 meters. If the speed…

Q: The driver of a car, which is initially at rest at the top A of the grade, releases the brakes and…

A: Objective: To determine the velocity of the car at location B. Given: a=3.06-0.004v2; a in ft/s2…

Q: To anticipate the dip and hump in the road, the driver of a car applies his brakes to produce a…

Q: At a point on a streamline, the velocity is 3 m/s and the radius of curvature is 9 m. If the rate of…

A: Given Data Velocity (V) = 3m/s Radius of curvature (R) = 9m Rate of increase of velocity along…

Q: The driver of a car, which is initially at rest at the top A of the grade, releases the brakes and…

A: Given- Initial velocity u=0 ft/s, Acceleration- a=2.83-0.006v2, Distance S=755 ft

Q: nsta

A: At the point A , tangential component of velocity is zerov=aρv=0.2gρg=acceleration due to…

Q: The topic is all about tangential and Normal Components THe formulas: a_t=dv/dt…

A: Using formula given

Q: The rated speed of a 200-meter banked highway curve is 50 km per hour. the radius of the highway…

Q: A vehicle transverses a superelevated curve at 52 kph. If the radius of the curve is 64 meters, and…

Q: Car A experienced engine failure the moment it enters a 2-km highway that has a constant grade of 4…

A: Solution :

Q: At the instant shown, cars A and B (angle between them is 60°) are traveling at velocities of 50 m/s…

Q: A. Determine the rate of radial acceleration on a section of highway (design speed = 130 Km/hr)…

A: As per authoring guidelines, if the question number is not specified, the first question or three…

Q: The figure shows two possible paths for negotiating an unbanked turn on a horizontal portion of a…

Q: A monorail train starts from rest on a curve of radius 400 m and accelerates at the constant rate…

A: Given: Radius of curve, ρ = 400m, v = 72km/h= 20 m/s

Q: n an urban area with a design speed of 110kph, and Rmin=630m. What can you say about the computed…

A: According to given data there is no such necessity of providing the super elevation. Reason is shown…

Q: 13. A vehicle travels the transition curve of radius 150 m in duration 15 s at a design speed of 80…

A: Radius, R = 150 mTime, t = 15 sec.Design speed, V = 80 km/hr. = 22.22 m/sThe rate of change of…

Q: anticipate the dip and the hump in the road, the driver of a car applies his brakes to produce a…

A: Points which are prerequisite to solve this problem are 1) tangential acceleration is given by…

Q: To anticipate the dip and the hump in the road, the driver of a car applies his brakes to produce a…

Q: height of the centre of gravity of the car above the road

Q: Car A experienced engine failure the moment it enters a 2-km highway that has a constant grade of 4…

Q: A train on broad gauge track while moving on 4-degree curve experiences the curve resistance of 130…

Q: 6. A motorist is traveling on a curved section of highway with a radius of 2500 ft at a speed of 60…

A: Radius of curve= 2500 ft Speed before brake is applied = 60 mi/h After brake is applied Speed of…

Q: A vehicle moving at 60 kmph on an ascending gradient of a highway has to come to stop position to…

A: Stopping sight distance This is referred to as the sight distance that is accessible to the driver…

Q: PROBLEM 1: A SUV and a mini bus are travelling in the same direction at the same speed of 70 kph on…

Q: the traffic expected is to have a velocity of 100 kph and move around a radius of curvature of 250…

A: Given data- Velocity (V) = 100kph =100(5/18) =27.78m/s Radius of curvature (R) = 250 m

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

2/108 The figure shows two possible paths for negotiating an unbanked turn on a horizontal portion of a race course. Path A-A follows the centerline of the road and has a radius of curvature PA = 85 m, while path B-B uses the width of the road to good advan- tage in increasing the radius of curvature to PB = 200 m. If the drivers limit their speeds in their curves so that the lateral acceleration does not exceed 0.8g, determine the maximum speed for each path. A B PB = 200 m PA = 85 m 4 B 2/109 From an = ²₁ U=√an = √0.8g 12 A√0.89 PA=0.8 (1.81(85) = 25.8 m/s Ug = √0.8918 = √0.8 (1.81)(200) = 39.6 m/s Path BB offers a considerable advantage.
A particle moves in a straight line with a constant starting velocity of 45 m/sec within 12 sec. then slows down to -25m/sec within 16 sec and with that constant velocity within 14 sec. when it starts to speed up at 5 m/sec within 4sec. and constantly until it reach a total time travel of 50 sec. Knowing that x = -520 m at t=0, (a) construct the a-t and x-t curves for 0<t<50sec,determine themaximum acceleration of the particle within 5 sec. and determine (b) the maximum position of the particle (c) the time/s when x=0 (8) the maximum acceleration of the particle within 50 sec.
Highway Engineering
An accelerometer C is mounted to the side of the roller-coaster car and records a total acceleration of 3.9g as the empty car passes the bottommost position of the track as shown. If the speed of the car at this position is 205 km/h and is decreasing at the rate of 16 km/h every second, determine the radius of curvature p of the track at the position shown. Answer: p= i m 0.65 m
a) A highway has a horizontal circular curve with a deflection angle of 45° and centre line radius of 240 m. Determine the length of transition curve such that the rate of gain of radial acceleration is 0.3 m/s³ at a speed of 60 km per hour.
solve
Problem 1: A.) Find the angle of banking for a highway curve of 90 meter radius designed to accommodate cars traveling at 160 kph if the coefficient of friction between the tires and the road is 0.60 B.) What is the rated speed of the curve?
BOX YOUR FINAL ANSWERUSE 3 DECIMAL PLACES IN EVERY SOLVED VALUES