Answered: standard 5 days-biochemical oxygen…

Engineering

Civil Engineering

standard 5 days-biochemical oxygen demand (BOD,) is taken at a temperature of Select one: a. 20°C Ob. 30°C

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Question 2. A coal fired power station requires an ESP for dust removal from the flue gas. The…

A: Given:- The concentration of the dust particles in the influent flu gas = 5200 mg/m3 The flow rate…

Q: Calculate the flux of water through MF and UF membranes operating at 1 bar pressure and 298 K.…

Q: 6.106. Air at 25°C and 1 atm with a relative humidity of 25% is to be dehumidified in an adsorption…

A: Part a Assumptions : all water vapor adsorbed in 2 hours Pressure and temperature are constant.…

Q: Acceleratory period begin after 6 hours of * hydration True O False O . Matter is de fined as إجايتك…

A: 1."Acceleratory period begin after 6 hours of hydration" is the false Statement Explaination:- After…

Q: Convert the concentration of SO2 from 80 pg m temperature of 25°C and a pressure of 101.325 kPa. to…

A: ppm = Conversions are needed to calculate the volume of So2 in cubic meters.

Q: If an airplane is flying at an altitude where the actual pressure is 4.72 x 104 N/m2 respectively,…

A: Given data: Height of Aeroplan is in place where actual pressure=4.72*104 It is asked to choose…

Q: i. Calculate the change in volume of the glass. ii. Calculate the change in volume of the acetone.…

Q: The hot-side ESP is currently more popular than the cool-side ESP. Give reason.

A: The electrostatic precipitators can be classified into hot-side and cold-side based on the…

Q: Why is it crucial to maintain a liquid water film on all surfaces of the medium in the filter bed…

A: Biofiltration is defined as the biological treatment which is used to treat surface water for…

Q: You are designing a heatsink to cool a 100mm tall, 100mm wide surface. The fins you use are…

A: Solution; Given that; Height (H) =100 mm = 0.100 m Width (W) =100 mm=0.100 m Thickness of fins tf=2…

Q: 1-6. Įn a biological waste treatment system, solids may enter (b) Solids decay in the reactor at a…

A: Consider the given equation rs=-k1s2XS2+KsWhere,X=VSS concentration in the reactorAlsok1=8 mg DOCmg…

Q: 6. To refrain from separation in subsonic nozzles, the expansion angle must not be more than a) 10…

A: To refrain from separation in subsonic nozzles, the expansion angle must not be more than ________…

Q: 4. What does the analytical scale read? (Ans: 1.550 g) 5. What is the concentration of the Total…

A: Given, Flow rate (Q) = 20 mgd Volume (V) = 90 ml or 0.09 L

Q: B. A Carnot engine operates between two temperature reservoirs maintained at 200°C and 20 °C,…

Q: Convert the following from milligrams per liter as the ion or compound to milligrams per liter as…

A: Concentration in mg/L are given. We need to calculate concntration as mg/L CaCO3

Q: An Aluminum wire has a ler the wire. Select the correct responsE O 56.2384 milli-ohm O42.6343…

A: L=200m

Q: Question 3 A 2L, 4-stroke, 4-cylinder petrol engine has a power output of 113.9 kW at 5500 rpm and a…

Q: A glass flask whose volume is 1000.00 cm³ at 0.0°C is completely filled with mercury at this…

A: Step 1: Find the total volume expansion of mercury when the temperature increases. We know the flask…

Q: A dual-pane window in a house is composed of two parallel panes of glass, each with an area of 2.23…

Q: Q1: A conventional ASP is to be used for treatment of 10,000 m³/d of municipal wastewater. The…

Q: Condensation occurs when the temperature is the dew point temperature (Td). O less than or equal to…

Q: After 2 days, the temperature drops to -10°C. How much does the height change of the À 10 m…

A: Given data : Coefficient of thermal expansion for aluminum (α)=23×10-6 ∘C-1Length of Flagpole…

Q: 2-64 Nitrogen enters a steady-flow heat exchanger at 150 kPa, 10°C, and 100 m/s, and it receives…

Q: Condensation occurs when the temperature is the dew point temperature (Td).

A: solution Less than or equal to due point actually when the falls below the dew point the excess…

Q: nspiration is confined to

A: When the liquid state transforms to a gaseous state due to boiling point then we call it…

Q: Q/ If the 5-day 20°C BOD is 150 mg/l what world be it's 8-day 15°C BOD? Assume the deoxygenation…

A: Given: 5-day BOD at 20 oC = 150 mg/L Deoxygenation constant k at 20 oC = 0.23 /d The value of 8-day…

Q: Thermometer measures the latent heat. Select one: O True O False

A: Thermometer measures the latent heat.

Q: The SOo concentration in a stack is 500 ppm, the stack diameter is 12 ft, and the stack gas velocity…

A: Calculate volume of the gas Q=AvVt=Av Q=VolumetimeV=AvtV=π4122×6524×3600V=635154636.6 ft3 Convert…

Q: When you touch a hot object with your finger, the heat transferred to your finger is by Group of…

A: When two bodies are direct in contact with each other then heat is always transferred from the body…

Q: possesses no definite volume and is compressible. (Solid) (Vapour) (Liquid) (Gas)

A: Gas posses no definite volume and is compressible . Liquid are in

Q: 2. Domestic "tap" water generally has a conductivity in the range 0.5 - 1.0 ms/cm. Based on your…

A: The total amount of dissoloved salt in water can be easily estimated by measuring the specific…

Q: How to reduce the agitation caused when using the stir tank bioreactor to produce CAR T cells in…

A: Bioreactor system- A bioreactor is any constructed system or apparatus that supports a biologically…

Q: A piston-cylinder assembly contains ammonia, initially at a temperature of -20°C and a quality of…

A: To solve this problem, we can use the first law of thermodynamics, which states:ΔU=Q−W Where:ΔU is…

Q: 27. Approximate percentage range of CaO in OPC is, В. 17-25 28. Approximate percentage range of…

A: As per guidelines we are supposed to answer only first three subparts so please repost rest…

Q: The concentration of SO2 measured at an air monitoring station was 8 mg/m3 at T=30 oC and 1 atm…

A: The U.S. Environmental Protection Agency (EPA) sets National Ambient Air Quality Standards (NAAQS)…

Q: A 10 m aluminium flagpole is installed at 30°C. After 2 days, the temperature drops to -10° C. How…

Q: Two lbs of water vapor in a piston-cylinder assembly expands at a constant pressure of 250 lb/in²…

A: To solve this problem, we can use the ideal gas law and the definition of work for a…

Q: 3. A solution is known to contain 42 mg/L of C6H₁2O6. Determine the theoretical oxygen demand.

Q: .40. A solution is known to contain 50 g/m³ of CH3(CH₂),COOH and 42 g/m³ of NH3-N. Determine the…

Q: 4. Jet propulsion works on the principle of

A: To find: Jet propulsion works on which principle

Q: x8x16-in CMU unit (Kerf type) insulated with 4-cm thick layer of the XPS foam

A: Rigid XPS foam board insulation is an easy-to-install and cost-effective solution when insulating…

Q: What is the pH of a solution made by dissolving 3.71 grams of calcium fluoride in enough water to…

A: Given Data: The mass of the calcium fluoride is M=3.71 g. The volume of resulting solution is V=450…

Q: 1.) Surface aerators were installed at a wastewater treatment plant to provide oxygen to an…

A: Minimum DO = 1.3 mg/LAlpha (α) = 0.85Beta (β) = 0.9Water depth = 3 mWidth = 50 m Length = 80 mTo…

Q: Discuss atleast 6 negative effects of carbon monoxide and 6 negative effects of carbon dioxide

A: 1.Poisoning: Carbon monoxide is highly toxic and can cause carbon monoxide poisoning when inhaled.…

Concept explainers

Thermal Processes

Some of the key areas where thermal processes find their application are:

Question

standard 5 days-biochemical oxygen demand (BOD,) is taken at a temperature of
Select one:
a.
20°C
Ob.
30°C
C.
15 °C
25°C

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

3-Typical asphalt roofing shingles have a thermal conductivity of about 0.79 W/m-k. If the temperature inside the house is 75 F and the temperature outside is 5 F, find the heat flux (the rate of heat transfer divided by the surface area through which conduction occurs ) through a 2 cm thick asphalt shingle roof.
I need the answer as soon as possible
1. Water is frequently disinfected with chlorine gas, forming hypochlorous acid (HOCI), which partially ionizes to hypochlorite (OCI) and hydrogen ions as follows: HOCI H+ + OCI- The concentration of HOCI, which is the desired disinfectant, depends on the water pH. a) Write the equations to express the two ionization fractions for HOCI, that is, ao and ai. b) Plot ionization fractions vs pH, clearly identifying a regions and pKa, at 25 °C. c) Plot speciation of HOCI vs pH (log[OCI] vs pH) for a Croci-= 0.05, clearly identifying regions and pKa, at 25 °C.
list of tools and equipments to undergo an experiment on cryptosporidium parvum in sewages
For distilled water the conductivity is zero. Why?Enlist apparatuses used in titration method.
What category of bacteria does tube "B" represent? High oxygen concentration Low oxygen concentration 0250 bar, (a) (b) (c) (d) O obligate aerobes O aerotolerant O facultative anaerobes O obligate anerobes
None
True/False questions. 1 For filtration process: when the water level rises to the point that the filter bed must be cleaned. This point is called terminal head loss ( 2 As the temperature decreases the detention time in 7 slow-mix tank decreases. ( 6 8 When CO₂ is bubbled in water with carbonate buffer system, the pH will decrease slightly and the reaction will shift to the left. ( ) 9 The lower the water turbidity, the higher the allowable ) scour velocity in sedimentation tank.( For mixed-media filter the layer of garnet is used to catch the very fine particles ( 3 The addition of polymers in coagulation process is called inter-particle bridging. ( ) ) 4 Slow-mixing can be accomplished by hydraulic As the weir lengths become shorter the scouring velocity becomes higher ( jump ( ) ) 5 Water with high turbidity requires more coagulant 10 Aluminum sulfate has a wider pH range for effective to be treated. ( coagulation than fèrric salts ( )
Concentrations of Pb, Cu, and Mn in rainwater collected in Minneapolis were found to be 9.5, 2.0, and 8.6 ug/L, respectively. Express these concentrations as nmale/L.
Wet coal is dried in a continuous rotary dryer that operates at atmospheric pressure. The chips with a water content of 40 wt% and must leave with a moisture content of less than 15%. Hot air is fed to the dryer at a rate of 11.6 m (STP)/kg wet coal. HOT AIR MOIST AIR DRYER WET COAL DRIED COAL To monitor the performance of the dryer by sampling the exiting coal and determining their moisture content directly would be a cumbersome procedure and almost impossible to automate. Instead, wet- and dry-bulb thermometers are mounted in both the inlet and outlet air lines, and the moisture content of the exiting chips is determined by a material balance calculator. (STP: Standard Temperature and Pressure is 0*C and 101.325 kPa) (a) The hot air stream has an absolute humidity of 0.058 kg moisture/kg dry air and leaves with 0.087 kg moisture/kg dry air, calculate the mass of water in the exiting air per kilogram of wet coal fed. (b) Can the dryer reduce the wet coal moisture to 15%? If the answer…
Refrigerant-134a at 300 psia has a specific volume of 0.2235 ft³/lbm. Determine the temperature of the re- frigerant based on (a) the refrigerant tables, (b) the ideal-gas equation, and (c) the generalized compressibility chart.
The treated waste water is being discharged into a river that has a temperature of 15°C. The BOD rate constant determined in the laboratory for this mixed water is 0.12 per day (base e) at 20°C (Temperature coefficient, 1.047). What fraction of maximum oxygen consumption will occur in first four days?