Q4: Consider a steam power plant that operates on an ideal reheat- regenerative Rankine cycle with one open feedwater heater, one closed feedwater heater, and one reheater. Steam enters the turbine at 15 MPa and 600°C and is condensed in the condenser at a pressure of 10 kPa. Some steam is extracted from the turbine at 4 MPa for the closed feedwater heater, and the remaining steam is reheated at the same pressure to 600°C. The extracted steam is completely condensed in the heater and is pumped to 15 MPa before it mixes with the feedwater at the same pressure. Steam for the open feedwater heater is extracted from the low-pressure turbine at a pressure of 0.5 MPa. Determine the fractions of steam extracted from the turbine as well as the thermal efficiency of the cycle. Ikg 15 MP 600C Low-P High-P tartine rbine Boiler Reheater 00 15 MP PP4 MP 6od: 4 MP 1-y- 1-y 1-y 4 MP 05 MP 10 KPa O5 MP 12 Closed FWH Open PWH 1-y- 10 P Mixing chamher 13 Condemset Pump II Pump II Pump1

Q4: Consider a steam power plant that operates on an ideal reheat- regenerative Rankine cycle with one open feedwater heater, one closed feedwater heater, and one reheater. Steam enters the turbine at 15 MPa and 600°C and is condensed in the condenser at a pressure of 10 kPa. Some steam is extracted from the turbine at 4 MPa for the closed feedwater heater, and the remaining steam is reheated at the same pressure to 600°C. The extracted steam is completely condensed in the heater and is pumped to 15 MPa before it mixes with the feedwater at the same pressure. Steam for the open feedwater heater is extracted from the low-pressure turbine at a pressure of 0.5 MPa. Determine the fractions of steam extracted from the turbine as well as the thermal efficiency of the cycle. Ikg 15 MP 600C Low-P High-P tartine rbine Boiler Reheater 00 15 MP PP4 MP 6od: 4 MP 1-y- 1-y 1-y 4 MP 05 MP 10 KPa O5 MP 12 Closed FWH Open PWH 1-y- 10 P Mixing chamher 13 Condemset Pump II Pump II Pump1

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Consider a regenerative power cycle with an open feedwater heater. water vapor enters the turbine at 8.0 MPa, 480°C and expands to 0.7 MPa where part of this vapor is extracted and presented to the open feedwater heater operating at 0.7 MPa. The rest of the steam expands in the second stage of the turbine to the condenser pressure of 0.008 MPa. The condenser outlet is saturated liquid at 0.7 MPa. The isentropic efficiency of each turbine stage is 85% and each pump operates isentropically. If the net power of the cycle is 100 MW, determine:1.Thermal performance and2. The mass flow of steam entering the first stage of the turbine, in kg/h.
PROBLEM: Steam power plant with ideal Rankine cycle. Steam enters the turbine at 4MPA and 700°C. The steam is cooled in the condenser at 20 kPa using cooling water. The net power output of the cycle is 100MW. Determine: a) The power produced by the turbine and consumed by the pump, b) thermal efficiency of the cycle, c) mass flow rate of the steam, and d) the mass flow rate of the condenser cooling water, if the cooling water enters the condenser at 15 °C and exits at 35°C. Draw the T-s diagram.
This is an Open feedwater not a closed feedwater thank you
Q4: Consider a steam power plant that operates on an ideal reheat- regenerative Rankine cycle with one open feedwater heater, one closed feedwater heater, and one reheater. Steam enters the turbine at 15 MPa and 600°C and is condensed in the condenser at a pressure of 10 kPa. Some steam is extracted from the turbine at 4 MPa for the closed feedwater heater, and the remaining steam is reheated at the same pressure to 600°C. The extracted steam is completely condensed in the heater and is pumped to 15 MPa before it mixes with the feedwater at the same pressure. Steam for the open feedwater heater is extracted from the low-pressure turbine at a pressure of 0.5 MPa. Determine the fractions of steam extracted from the turbine as well as the thermal efficiency of the cycle. 1 kg 15 MPa 600°C Boiler 15 MPa 4 MPa 0.5 MPa 10 kPa Mixing chamber (0) Reheater Closed FWH www Pump III 4 MPa High-P turbine 10 P₁0 P₁1=4 MPa 600°C 2 12 1-y (11) 0.5 MPa Open FWH Low-P turbine Pump II Pump I 1-y-z 13 10…
Consider a reheat-regenerative vapor power cycle with two feedwater heaters, a closed feedwater heater and an open feedwater heater. Steam enters the first turbine at 8000 kPa and 480oC and expands to 700 kPa. The steam is reheated to 440oC before entering the second turbine, where it expands to the condenser pressure of 8 kPa. Steam is extracted from the first turbine at 2000 kPa and fed to the closed feedwater heater. The feedwater leaves the closed heater at 205oC and 8000 kPa and enters the boiler to complete the cycle. The condensate from the closed feedwater heater is throttled into the open feedwater heater. Steam extracted from the second turbine at 300 kPa is also fed into the open feedwater heater, which operates at 300 kPa. The stream exiting the open feedwater heater is saturated liquid at 300 kPa. The net power output of the cycle is 100 MW. If the working fluid experiences no irreversibilities as it passes through the turbines and pumps, determine: (a) mass flowrate of…
Please show the solution. Thank you very mmuch
Scenario (1) The first steam power plant operates on an ideal reheat Rankine cycle. Steam enters the first turbine at 8 MPa and 500 C and leaves at 3 MPa. Steam is then reheated at a constant pressure to 500 C before it expands to 20 kPa in the low-pressure turbine. Assuming that heat is being added to the boiler from a high temperature source at 1800 K and the condenser is transferring heat to a temperature sink at 300 K. Task 1 Investigate the effect of changing pump efficiency on the overall thermal efficiency of the thermodynamics cycle (Hint: You will assume different values for the isentropic pump efficiency such as: 70%, 80%, 90%, 95%, and 100%, then observe how it will change the thermal efficiency of the cycle). Representing the results in a plot is recommended.
Scenario (1) The first steam power plant operates on an ideal reheat Rankine cycle. Steam enters the first turbine at 8 MPa and 500 C and leaves at 3 MPa. Steam is then reheated at a constant pressure to 500 C before it expands to 20 kPa in the low-pressure turbine. Assuming that heat is being added to the boiler from a high temperature source at 1800 K and the condenser is transferring heat to a temperature sink at 300 K. Task 1 Investigate the effect of changing turbine efficiency on the overall thermal efficiency of the thermodynamic cycle. (Hint: You will assume different values for the isentropic turbine efficiency such as: 70%, 80%, 90%, 95%, and 100%, then observe how it will change the thermal efficiency of the cycle). Representing the results in a plot is recommended.
Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Consider a steam power plant that operates on a reheat Rankine cycle and has a net power output of 80 MW. Steam enters the high-pressure turbine at 10 MPa and 500°C and the low-pressure turbine at 1 MPa and 500°C. Steam leaves the condenser as a saturated liquid at a pressure of 10 kPa. The isentropic efficiency of the turbine is 72 percent and that of the pump is 95 percent. Determine the quality (or temperature, if superheated) of the steam at the turbine exit. Use steam tables. (You must provide an answer before moving on to the next part.) The temperature of the steam at the turbine exit is °C.
Consider an ideal steam regenerative Rankine cycle with two feedwater heaters, one closed and one open. Steam enters the turbine at 10 MPa and 500 C and exhausts to the condenser at 10 kPa. Steam is extracted from the turbine at 0.7 MPa for the closed feedwater heater and 0.3 MPa for the open one. The extracted steam leaves the closed feedwater heater and is subsequently throttled to the open feedwater heater. Show the cycle on a T-s diagram with respect to saturation lines, and using only the data presented in the data tables given below determine a) the fraction for steam leaving the boiler that is extracted at 0.3 MPa z=0.1425 b) the fraction of steam leaving the boiler that is extracted at 0.7 MPa y=0.06213 c) the heat transfer from the condenser per unit mass leaving the boiler q_out=1509 kJ/kg d) the heat transfer to the boiler per unit mass leaving the boiler qin=2677 kJ/kg e) the mass flow rate of steam through the boiler for a net power output of 250 MW m'=214.1 kg/s f) the…