Q3. In/a three-phase full-bridge inverter circuit, the de voltageV = 250V, the amplitude modulation indexma = 0.8, the frequency modulation index m, = 21, and the frequency of the three-phase sine modulating wave is 50 Hz. The load is a three-phase Y-connected RL load with R-502 and L=40mh. Calculate (a) the switching frequency, (b) the rms value of the output voltage and phase current at the fundamental frequency (c) the rms value of the dominant harmonics (consider only four components). 18 If the amplitude of the sin modulating wave is increased to 3.5 times the carrier frequency amplitude and load is changed to resistive load with R=552, (d) draw the line to neutral voltage (e) draw the line to line voltage (e) express the line to line voltage Vab by the Fourier series (consider the four dominant harmonic order only) (f) determine the active power consumed on three-phase load. ( J.M. Co

Q3. In/a three-phase full-bridge inverter circuit, the de voltageV = 250V, the amplitude modulation indexma = 0.8, the frequency modulation index m, = 21, and the frequency of the three-phase sine modulating wave is 50 Hz. The load is a three-phase Y-connected RL load with R-502 and L=40mh. Calculate (a) the switching frequency, (b) the rms value of the output voltage and phase current at the fundamental frequency (c) the rms value of the dominant harmonics (consider only four components). 18 If the amplitude of the sin modulating wave is increased to 3.5 times the carrier frequency amplitude and load is changed to resistive load with R=552, (d) draw the line to neutral voltage (e) draw the line to line voltage (e) express the line to line voltage Vab by the Fourier series (consider the four dominant harmonic order only) (f) determine the active power consumed on three-phase load. ( J.M. Co

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A three phase inverter below has a Y- connected load. The inverter frequency is fo = 60 Hz and the DC input voltage Vs = 220V. The applied control signal is a 180 deg conduction mode. The RMS Line to Line voltage Vo is equal to 179.63V. The total harmonic distortion (THD) is equal to: Select one: a. 48.34% b. 31.08% c. None of these d. 100%
for square wave PWM inverter, Vdc=100V, L=25mH, R=1002, f=60Hz. draw the spectrum of the output voltage and current and then find the rms current value and the output power. Take n =1-20.
A 1-phase full-bridge inverter is connected to a load of 4.2 . The DC input voltage is 40 V. What is the rms output at fundamental frequency?
Q2: Explain the operating principle of a single-phase half-bridge inverter with a resistive load. Then, (i) derive the rms output voltage, (ii) equivalent circuit for each state, and (iii) sketch the waveforms for the output voltage, output current, drive signals for the switches.
For single phase inverter has the followingparameters ; Vac = 80v , R = 80 , L = 20mHand f = 60 Hz Determine total harmonic distortion for n = 5 ; thenwrite expression for voltage
The output signal from a frequency inverter will appear on a scope screen as a: A. pure sine wave of different frequencies. B. triangular-shaped waveform with distorted peaks. C. distorted square wave. D. distorted sine wave.
#4 the input voltage of a three phase inverter is 600Vdc, what is the duty cycle for phase a as a function of time to generate 270cos(ot)V phase voltage? #5 how to generate 460V 400HZ three phase voltages from 460V 60HZ three phase voltage?