Q2: A buck converter feeding a variable resistive load is shown in the figure. The switching frequency of the switch S is 100 kHz and the duty ratio is 0.6. The output voltage Vo is 36 V. Assume that all the components are ideal, and that the output voltage is ripple-free. The value of R (in Ohm) that will make the inductor current (iz) just continuous is 5 mH 60 V + 36 V Vo R. Answer : 2480 to 2520

Q2: A buck converter feeding a variable resistive load is shown in the figure. The switching frequency of the switch S is 100 kHz and the duty ratio is 0.6. The output voltage Vo is 36 V. Assume that all the components are ideal, and that the output voltage is ripple-free. The value of R (in Ohm) that will make the inductor current (iz) just continuous is 5 mH 60 V + 36 V Vo R. Answer : 2480 to 2520

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

single phase full controlled bridge converter uses a. 4 SCRs and 2 diodes b. 4 SCRs c. 6 SCRs d. 4 SCRs and 2 diodes
What's the peak time for this system with its closed-loop poles as shown? j4 12 -2 Select one: a. 0.154 sec Ob. 0.393 sec O c. 3.14 sec O d. 1.80 sec Oe. 0.607 sec
For the given circuit below, a step down transformer gives an RMS voltage of 230 V/ 14.9-0-14.9 V with a load resistance of 2.2 Kiloohms. Assume Silicon diodes are used. Determine the Peak Inverse Voltage of the diode. D, RL D2 32.63 21.07 42.14 O26.97
Converter control in solar photovoltaic
Draw the schematic diagram of the Regulated Power Supply with the following components: Transformer, Rectifier (bridge type), Capacitor Filter and voltage regulator
An inductive load of 100 Ohm and 200mH connected in series to thyristor supplied by 200V dc source. The latching current of a thyristor is 45ma.and the duration of the firing pulse is 50us where the input supply voltage is 200V. Will the thyristor get fired?
In Boost converter, if the supply voltage is 200 V and the Duty cycle is 50%, the output voltage will be 100 V 200 V 400 V None of the above O O O O
In DC / DC switching circuits, a resistor-inductance (r-l) circuit is usually connected to the load in series, and also a reverse parallel switching diode is connected to this inductance (l). Write down your comments and approaches about the purpose for which these connected resistance, inductance and diode elements are used by an engineer's approach
A single phase full wave rectifier supplies a 20 Ohm load at an average voltage of 15 V. Determine the source rms voltage. O 23.6 V 16.7 V 9.5 V O 33.3 V
13
COMPUTE THE OUTPUT VOLTAGE * +10 V 1.0 k. V out Vin OV -10 V
Quiq