Q:- Prove that the angle of inclination of two fixed parallel plate as shown in fig, so that laminar flow at constant pressure occurs is (12 μ Q 0 = sin" sin-1 y a3 where:- Q:flow rate a:distance between plates

Q:- Prove that the angle of inclination of two fixed parallel plate as shown in fig, so that laminar flow at constant pressure occurs is (12 μ Q 0 = sin" sin-1 y a3 where:- Q:flow rate a:distance between plates

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A hypodermic needle with an inner diameter of 0.3 mm and a length of 60 mm as shown in the figure.…

A: GIVEN: # # Inner diameter of 0.3 mm # Length of 60 mm TO FIND:

Q: A) Figure (2) shows the velocity distribution for flow of water between two parallel plates.…

Q: For Oil (SG = 0.86, p = 0.025 Ns/m2) flow of 0.3 m3/s through a round pipe with diameter of 500 mm,…

A: Given data: The specific gravity of oil, SG = 0.86. Dynamic viscosity of the oil, µ = 0.025 N·s/m2.…

Q: A) Figure (2) shows the velocity distribution for flow of water between two parallel plates.…

A: As per honor code and answering guidelines I can answer first 3 sub parts at a time if you want…

Q: 3. Oil is flowing with 0.001m /s in a conduit with cross section as shown in the Figure where the…

A: Given data oil flow rate:-0.01 m3/secdensity ρ=900 kg/m3viscosity μ=0.05 Pa-slength =(a)=9 cmdia of…

Q: What is the pipe velocity at point 1? Given the specific gravify of pink liquid S=3.9 and height…

A: Given data Specific gravity of pink liquid(S) = 3.9 h = 1.4 m of pink fluid To determine the…

Q: The velocity components in the x and y directions 3 are given by u = Axy3 -x2y, v = xy² -y'. y*. The…

A: For solution refer below images. From the given datau=λxy3-x2y →velocity in x-directionv=xy2-34y4 →…

Q: A fluid of viscosity μ flows in the horizontal cylinder (radius R) shown in the figure under a…

A: The viscosity of the flow is, The velocity at the porous region is, The radius of the porous region…

Q: Problem 5. A thin oil film (u= 0.80 N - 8/m2.p=865 kg/m') of height h = 5.0 mm is squeezed between…

A: Given, Fluid Viscosity μ=0.8 Ns/m2 Density ρ = 865 kg/m2 Height h = 5 X 10-3 m Velocity of bottom…

Q: Q:- Prove that the angle of inclination of two fixed parallel plate as shown in fig, so that laminar…

A: Navier stokes equation for plane Poiseulli's flow is valid for this problem. Several assumptions…

Q: Prove that the angle of inclination of two fixed parallel plate shown in figure, so that laminar…

Q: An oil (viscosity 1 Pa.s, density 800kg/m3) is flowing in an axisymmetric pipe. The flow is fully…

Q: One dimensional flow occurs in the circular tube at the location adequate ly far from the entrance…

Q: As shown in figure 3, water (kinematic viscosity of water v =10 m's) flows out of a reservoir into a…

Q: Some non-Newtonian fluids behave as a Bingham plastic for which ). For laminar flow of a Bingham…

Q: A fluid is flowing in a smooth pipe (inside diameter = 40 mm) with a welocity of 10 m/sec, the fluid…

A: Ans: f= 0.025

Q: Q1 / Show that velocity profile for fully developed laminar flow on an inclined plane, shown in…

A: Apply continuity equation and navier stokes equation to solve this problem

Q: A viscous Newtonian fluid is flowing in a horizontal rectangular duct with dimensions, L=10 m, W=1 m…

Q: Water at 20 deg C flows between two parallel horizontal plates separated by a distance of 8 mm. The…

A: Write the given data. T=20 °Ch=8 mm=0.008 mv=4 m/sτupper=0

Q: Q:- Prove that the angle of inclination of two fixed parallel plate as shown in fig, so that laminar…

Q: dia Y lo psi Q=10,000 gpm flow oil (sy=086b) I 14"' dia Determine the horizontal force on the…

Q: The velocity profile in fully developed laminar flow in a circular pipe of inner radius r., is given…

A: V=9(1-r2/ro2 ) plot velocity profile?The" volume "of water flows out the pipe that in 0.2 min?

Q: Q1: An oil (u = 0.083 N.sec/m2) flows between two inclined fixed and parallel plates %3D 6mm and 1…

Q: A) Figure (2) shows the velocity distribution for flow of water between two parallel plates.…

Q: o indefinitely long flat plates separated by 3 inches in distance but with a thickness of 5inches…

A: Given:Distance between plates, b=3 inThickness of plates, d=5 inVelocity of alcohol, v=5…

Q: A plate of 0.125 mm distant from a fixed plate, moves at 20cm/s and requires a force of 40 N per…

A: Given data, dy= 0.125 mm =0.000125 m du=u= 20 cm/s =0.2 m/s τ= 40 N/m²

Q: SAE-10 oil at 20 deg C fills the gap between the moving 6 cm diameter long cylinder which is inside…

A: Given: Diameter of the inside cylinder→Di=6 Cm=0.06 m Diameter of the outer cylinder→Do=6.8 Cm=0.068…

Q: Water flows through the following circular pipe with a diameter of 30 mm at a speed of 3 m/s, what…

Q: A Newtonian fluid is flowing in an infinitely long round pipe of diameter M or radius N = M/2 and…

Q: The velocity distribution for the fluid flow between two fixed parallel plates, shown in the Fig.…

A: Givenuy=3Umax21-yh2 where y is in mUmax=4m/sh=5mm=0.005mμ=3×10-3 Ns/m2

Q: The velocity profile in fully developed laminar flow in a pipe of diameter D is given by u = U, (1-…

A: Given: velocity profileu=uo 1-4r2D2

Q: Given an open tank filled with oil that is discharging through a 35-meter long commercial annulus…

A: GivenRi=2cm=0.02mdi=0.04mh=5mS.G=0.9L=35mμk=4×10-5 m2/s

Concept explainers

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.

Question

U PO A:E0
O [Template] Q...
Quiz
Q:- Prove that the angle of inclination of two fixed parallel plate as shown in fig, so
that laminar flow at constant
occurs is
12 μ Q%
e = sin-1
y a3
where:-
Q:flow rate
a:distance between plates
fixed plates
II
>
20
...

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Gasoline with a dynamic viscosity of 2.92 x 10 -4 flow at a rate of 2L/s through a pipe of inside diameter 60 mm. Solve for the Reynold's Number. The S.G. of gasoline is 0.719. Choose the correct answer below 104452 O 227894 123456 O 764524
I need the answer as soon as possible
Freshwater (density = 1000 kg/m³, viscosity cm diameter tube with an average velocity of 0.23 m/s. What is the Reynold's number of the flow (first blank)? Is the flow laminar, transitional, or turbulent (second blank)? = 0.001 kg/(m*s)) is flowing through a 2 Blank # 1 Blank # 2
A joining elbow on horizontal plane is shown in the figure. The fluid is water and assumed to be ideal. Pipe 2 is open to the atmosphere. The flow velocity of pipe 2 is given as Uz = [2+ (k/10)] m/s, and pressure at pipe 3 is p3 = 1.6 + k/ 4 kPa. (k=5) a) Calculate the flow velocity at pipe 3 (u3 = ?) b) Calculate the discharge and flow velocity of pipe 1 (Q = ?, ui = ?). c) Calculate the pressure at pipe 1 (p. = ?). d) Calculate the x and y components of the net force acting on the joining elbow by the fluid. Draw the force vector. Atmosfer dz-25 cm d;=40 cm d;=25 cm 3 300
i need the answer quickly
A pipe-line carrying water has average height of irregularities projecting from the surface of the boundary of the pipe as 0.15 mm. What type of boundary is it? The shear stress developed is 4.9 N/m². The kinematic viscosity of water is .01 stokes.
A horizontal smooth-walled cylindrical pipe has diameter 0.04 m. Water flows along the pipe with a flow rate of Q 2 x 10-4 m³ s-¹. = For water, take the kinematic viscosity as v = 10-6 m² s¹ and the 10³ kg m-³. density as p = (a) Calculate the Reynolds number and establish whether the flow is turbulent or not. (b) Show that λ = 0.035 is a good approximation of the Darcy friction factor for this flow. (c) Calculate the shear stress at the wall of the pipe, and hence find the magnitude of the drag force exerted by the water on a length 2 m of the pipe. L =
In a fully developed turbulent flow through a pipe, the shear stress is……… Please fill the blank correctly.
A) Figure (2) shows the velocity distribution for flow of water between two parallel plates. Velocity profile: u = 10(0.01y - y²). Figure (2) Find: 1) The value of Y. 2) Shear stress at the wall. 3) Shear stress at 20μm from the wall. 4) Location of zero shear stress 5) Location of maximum velocity. water at 20°C