Q/ design a suitable main canal head regulator with trapezoidal cross-section area to draw water from river. Used the following data (NOTE: side slope of trapezoidal = 0.085 m/Km, length of approach channel =80 m): %3D data Discharge Bed level Depth of flow River 52 m/sec 42 m 1.9 m Main canal 15 m/sec 41m 2.5 m

Q/ design a suitable main canal head regulator with trapezoidal cross-section area to draw water from river. Used the following data (NOTE: side slope of trapezoidal = 0.085 m/Km, length of approach channel =80 m): %3D data Discharge Bed level Depth of flow River 52 m/sec 42 m 1.9 m Main canal 15 m/sec 41m 2.5 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

I need the answer as soon as possible
Reservoir B receives 0.06 m^3/s of flow. Determine: The flow in line AD. The flow in line DC. The elevation of reservoir B.
Design a semi-modular pipe outlet for the following data: Discharge through outlet == 0.035 cumecs, F.S.L of distr. channel = 110.00 m, F.S.L of watercourse = 109.30 m, Full supply depth of distr. channel -1.2 m. Assume the discharge coefficient = 0.62.
Find the hydraulic potential at point A
Answer question 3 only
For the setup shown, 1-What is the direction of flow? 2- Calculate the rate of flow in cm²/hr. 3-Calculate elevation heads, pressure heads and hydraulic heads at points A, B, C and D take datum as shown Bill 0.4 m 0.6m 03 m K-0.5 cm/sec Cross section area = 1 m² Datum
Fox flowe rate 28 Lis Find pump Power EL. 60M L00 Mm. 150 Mm El. 30M
Problem 14.5 In the problem above the final width was set at = 2m and the maximum Q =12 m/s, find the normal depth for this maximum discharge. OK again, 2/3 AR 1/2 S'2 B-2m A-2y WP 2 Ay
Find
Calculate the drawdown in a drainage well having a radius of (50cm), with a lowering in water, table at point P1 at a distance of (100m) from the well of (1m) lowering, and a lowering of (4m) at point P2 with a distance of (40m)from the well. Saturated thickness is (40m) while pumping is 2000 m³/d. h
A rectangular channel 4m wide with critical depth of 2.5 m. Compute the: a.) Discharge b.) Froude Number
Spring Obs. well Determine: M Recharge area B₂. K₂ Water enters the system in the recharge area and exits as a spring. 1. The piezometric head in the well located at the sketch (express the head in terms of the other variables indicated on) 2. Specify the conditions for the well to become a flowing (artesian) well (water flows from the well without pumping).