PROBLEM 1.Thestructure shown is held in equilibrium by a cable and fixed support at A. Calculate the components of the support reaction at Aif the tension in the cable is 150 kN.

Q: SOLVE the location of the Centroid from column ABC

A: Given data in question  Frame Point loads Span member lengths  Uniform columns   To find out…

Q: The rigid bars shown are separated by a roller at C and pinned at A and D. A steel rod at at B helps…

A:

Q: The uniform 6000N bar ABC is supported by a pin at C and a cable that runs from A to B around the…

A: the uniform weight of bar =60000NThe diameter of cable, ∅ =18mmThe length of span, L=4m

Q: Draw the shear force and bending moment diagrams for the beam.

A: Hi! Thank you for the question As per the honor code, We’ll answer one question since the exact one…

Q: A 2 kN 3 m C 2 kN 3 m E 4 m A pin-jointed tower truss is loaded as shown in the above figure. The…

A:

Q: Q: The rigid beam shown is supported by a pin at A and wires BD and CE. If the load P on the beam…

A:

Q: Determine the reactions at A and B for the steel bar and loading shown, assuming a close fit at both…

A: Given data:- Conditions given-Remove restriction at A and solve for the reactions Below bar figure…

Q: Q4/ The rigid beam is supported by a pin at A and two steel wires BD and CE. Each rod has a diameter…

A: Given Esteel=200 Gpa  a= 1 m, b= 1.5 m, d= 40 mm, h= 10 mm

Q: The beam is supported and loaded as shown. Determine the reactions at hinge A and roller B.

A: ###Determination of Reaction  at Hinge A and Roller B####

Q: in Figure A truss is supported by a pin at A and a cable attached at Q2(b). Determine the reactions…

A: To find the support reaction at A and force ni cable -

Q: Q2/ The cable of the tower crane is subjected to 840 N force. A fixed base at A supports the crane.…

A:

Q: Question 3 The rigid structure BCD is supported as shown. Assume a = 6.7 ft, b = 4.8 ft, c = 3.0 ft,…

A: Given data,  a = 6.7 ft b = 4.8 ft c = 3.0 ft d = 1.8 ft Angle = 30° FOS = 1.9   To find out the…

Q: The 510-kg uniform beam is subjected to the three external loads shown. Compute the reactions at the…

A:

Q: Determine the magnitudes of tension forces in rope AB, AC and AD for equilibrium of the ring A. (b)…

A:

Q: Uniform slender bar ABC of mass m = 5 kg and length L = 3m is pinned at A and supported by a cable…

A: Given Data: The mass of the bar ABC is m=5 kg. The length of the bar ABC is L=3 m. The coefficient…

Q: RAH A 60⁰ RAV 500 N E 60° 3m 60⁰ RAV = 106.2 N O O RAV = 201.8 N O RAV = 365.72 N RAV = 123.5 N C D…

A:

Q: 6 m 1 5 m ho = 2m ihD 4 m B

A:

Q: ecause the cable passes over a small pulley at B, the tension may be as he cable. Assume a = 3 in. A…

A:

Q: C 105° SIMPLE STRESSES 50° D 65° 1. Two steel bars are connected by two 20 mm 60 KN 15° BLOCK E…

A: At joint B Consider the summation of forces in the vertical direction TBC sin65o+TBD…

Q: EDetermine all forces acting on body A Fort A for the System shown in Fignreca). Body A weighs(200N…

A:

Q: The roof of a single-story storage building shown is subjected to a uniformly distributed load of…

A: Given Data: UDL=2.4kPah=6mL=8m Required- To find the maximum bending moment (kN-m) in beam BE of a…

Q: B

A:

Q: The arch structure is subjected to the loading shown. Determine the tension in the rod AD in kips.…

A:

Q: Question1 The uniform rectangular plate of mass m is suspended by three cables. Determine the…

A:

Q: We have a table that we seek to lift with a pulley. The table is uniform, with a weight of 73…

A:

Q: 2. Determine the reactions at supports A and B. 700 Ib/ft 500 Ib/ft 6 ft 9 ft 6 ft 6 ft 8 ft

A: Consider the following free body diagram: Consider member BD as follows:

Q: For truss shown, use method of section. A)Compute the reaction at B? (Bv and Bh) B)What is the…

A:

Q: 5. Bar ABD and bar CEF are connected using a pin at point C and a strut member BE to support a 9000…

A:

Q: 3. The bars AB and AC are joined by a pin at A and a horizontal cable. The vertical cable carrying…

A:

Q: Problem 4. The Warren truss loaded as shown in the figure supported by a roller at C and a hinge at…

A:

Q: The bent rod ACDB is supported by a sleeve at A and a ball-and-socket joint at B. Determine the…

A: suppose tension in cable DE is T→D tension in cable at C is W→  Reaction force at A is only in Y and…

Q: 1m B. 0.5 m 0.5 m D 100 kg

A: Free body diagram of BED

Q: Container W weighs 376 N. It is suspended from ring A. Cable BAC oases through the ring and is…

A: W=376 NTo find- Force vector for P and Q

Q: eering  If the tension in the gantry crane lifting cable is T = 14 kN.Define force T how as a…

A: Given:- T=14kN To find:- T

Q: 3m 3m H. D. 3m 9m | 9m 9m 3m A 9m- 10 kN 10 kN 1. For the truss shown, Determine the Bar Forces AB,…

A:

Q: Pr: Determine al forces acting on body A for tue System shown in Figureců). Body A weighs (200N and…

A: its a problem of mechanics simply analysing forces on a body given surface is smooth so no friction…

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.