Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator temperature is -30°C. Saturated vaporenters the condenser at 36°C, and saturated liquid exits at the same temperature. The mass flow rate of refrigerant is 10 kg/min.Determine the refrigeration capacity, in tons,(A) 7.4B 6.6C) 6.9D 6.4

Answered: Image /qna-images/answer/df3f97c3-0d60-48c3-b048-0c684ffd91e1.jpg

Answered: nters the condenser at 36°C, and…

nters the condenser at 36°C, and saturated liquid exits at the same temperature. The mass flow rate of refrigerant is 10 kg/min. etermine the refrigeration capacity, in tons, A) 7.4 B) 6.6 6.9 6.4

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: 1. Refrigerant-134a is fed into an adiabatic compressor as saturated vapor and at 160 kPa pressure.…

Q: Refrigerant 134a inside an insulated piston-cylinder assembly initially occupies 0.017 m at 0.6 MPa,…

Q: A liquid enters a pump and saturates at 10 psia, and leaves at a pressure of 500 psia. If the…

A: State 1: P1= 10 psia and saturated liquid State 2: P2= 500 psia Isentropic efficiency of the pump,…

Q: This is part two of a two-part problem. Water at 2.0 kg/s enters the boiler at 40°C and 2000 kPa and…

A: Given:Mass flow rate of water, m˙=2.0 kg/sWater temperature and pressure at boiler inlet, T1=40oC,…

Q: 17-Initial pressure of 900 kPa and 80°C in a piston-cylinder assembly There is 734 grams of…

A: From steam table properties for R134a - The entropy at 900kPa and 80°C is 1.8552 kJ/kgKThe entropy…

Q: 3. An ideal reheat regenerative unit receives 18 Mpa of steam at 780°C. Reheat occurs at the first…

A: Now calculate enthalpies at all states through steam tableAt stage 1 P=18Mpa…

Q: in a steam power cycle, steam enters the turbine at 20 bar with the following different conditions…

Q: 2. A boiler produces a steam at 2.417 Mpa and 468.9oC. The steam enters a turbine where after the…

Q: 10- Argon enters an isentropic turbine at 450°C and exits at 150°C. If the turbine power is…

Q: J 5 A Carnot refrigeration cycle is used to maintain a room at 23 °C by removing heat from…

A: Given: The room temperature, T2 = 23 C The ground water temperature, T1 = 15 C The refrigerant…

Q: Water vapor at 20000kg /hour flows into a steam boiler with a specific volume of 225 kPa 0.7565 m ^…

A: Write the given information.

Q: HW Q) A gas turbine power plant operate at a pressure ratio of 9. Air enters the compressor at 1.0…

A: INTRODUCTION : The heat energy gained from the combustion of solid fuels is utilized in thermal…

Q: 10 .In a certain refrigeration system for low temperature application , a two- stage operation is…

Q: An ideal gas-turbine cycle has two stages of expansion and two stages of compression. The pressure…

A: Pressure ratio = 8:1 Inlet compressor pressure ,P1 = 14 lbf/in2 Inlet compressor temperature, T1 =…

Q: An ammonia simple saturation cycle operates at 35 psia suction pressure and 172 psia condenser…

Q: A refrigeration system is designed to cool 10,000 lb per hour of water from 60 deg F to 40 deg F .…

A: Given DataT1=60F=15.55°CT2=40F=4.44°CCP=4.18m˙=10000 lb/hr=1.26kg/s

Q: Air at a dry bulb temperature of 80 ° C and RH 8% is passed over the cooling coil so that the air…

A: T1=Air at a Dry Bulb Temperature=80°CR.H=Relative Humidity= 8 % T2=Air dry boal temperature…

Q: Qin > Qout in (mark all that apply):

Q: 1. Steam enters an adiabatic turbine at a pressure of 7 MPa, a temperature of 500 °C and a velocity…

A: Given-Information: Inlet Pressure is p1=7MPa Inlet Temperature is T1=500°C Inlet Velocity is…

Q: An ammonia simple saturation cycle operates at 35 psia suction pressure and 172 psia condenser…

Q: A heat exchanger has the objective of condensing 5 kg/s of water vapor and taking it from a pressure…

Q: Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator…

A: Answer: The net work in the cycle is 6.08 kW.

Q: There is a steam power cycle that uses water as the working fluid, where the condenser pressure is…

A: Note: As per our guidelines we are supposed to answer only the first 3 sub-parts. Kindly repost…

Q: Refrigerant 22 is the working fluid in a Carnot refrigeration cycle operating at steady state. The…

A: To find : The work developed by the turbine. Given : The entering temperature at condenser T=36°.…

Q: Please choose the right answer for each question as below:

A: Correct option are:

Q: The output of a compressor plant delivering 600 m3 of free air/hr at 7 bar gauge at 20 oC passes…

Q: A power plant uses steam flowing at 75kg/s to perform power cycle. Both the turbine and the pump…

A: It is given that the turbine and pump are adiabatic in nature. Thus, it can be considered that the…

Q: The pressure ratio of a Brayton cycle with a regenerator whose working fluid is air is 8. The air…

A: Given data: The pressure ratio of the Brayton cycle is rP = 8 The value of the adiabatic constant…

Q: H1. . If methane is used as a working fluid in a standard refrigeration cycle to condense a separate…

A: Refrigeration systems are used extensively in the natural gas processing business, as well as…

Q: A boiler produces 5000kPa steam which is 67% dry, from boiler feed water @ 100°C. flow rate is 960…

Q: Ethyl glycol is cooled with water (Cp=4.18 kJ/kgºC) in a heat exchanger. The inlet temperature of…

Q: Octane is used as the working fluid in a gas-flow refrigeration cycle. The pressure ratio of the…

Q: a) Find COP of the R12 Refrigeration System b) Draw the h-p diagram and explain each step

A: Condenser temperature, Tc=40oCEvaporator 1 temperature, T1=-10oCEvaporator 2 temperature,…

Q: Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator…

Q: |Qout| > |Wcycle| in (mark all that apply): a) Refrigeration cycle b) Power cycle c) Heat pump cycle

A: |Qout| > |Wcycle| in (mark all that apply): a) Refrigeration cycle b) Power cycle c) Heat pump…

Q: 4. Inis question requires you to demonstrate your knowledge and understanding of gas turbine…

A: The aircraft velocity, Vo = 226 ,/sThe altitude of the aircraft, P = 79500 PaThe engine intake…

Concept explainers

Heat Exchangers

Heat exchangers are the types of equipment that are primarily employed to transfer the thermal energy from one fluid to another, provided that one of the fluids should be at a higher thermal energy content than the other fluid.

Heat Exchanger

The heat exchanger is a combination of two words ''Heat'' and ''Exchanger''. It is a mechanical device that is used to exchange heat energy between two fluids.

Question

Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator temperature is -30°C. Saturated vapor
enters the condenser at 36°C, and saturated liquid exits at the same temperature. The mass flow rate of refrigerant is 10 kg/min.
Determine the refrigeration capacity, in tons,
(A) 7.4
B 6.6
C) 6.9
D 6.4

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

37 - Water vapor enters a continuous flow adiabatic nozzle at a temperature of 350ºC and a pressure of 4.5 MPa. What is the specific volume at the inlet? a) 0.07343 m³/kg B) 0.05784 m³/kg NS) 0.06647 m³/kg D) 0.05842 m³/kg TO) 0.05197 m³/kg
22 - Refrigerant – 134a (refrigerant, R–134a) is used in a refrigeration machine working with an ideal vapor compression cycle, the condenser is kept at 1000 kPa pressure and the evaporator is at 6ºC. If the cooling load is 450 kW, which of the following is the mass flow rate? a) 6.43 kg/h B) 3.07 kg/h NS) 3.39 kg/h D) 2.75 kg/h TO) 6.58 kg/h
an ideal reheat turbine with one stage of reheat receieves steam at 8 mpa, 480 degrees celsius. reheat pressureis 0.83 mpa and exhaust pressure is 0.0007 mpa. determine A) heat added B) effeciency cycle C) energy chargable D) engine thermal effeciency
Work is done on a system in (mark all): a) Refrigeration cycle b) Power cycle c) Heat pump cycle
8 - Water vapor enters an adiabatic nozzle with a continuous flow at a temperature of 350ºC and a pressure of 4 MPa. What is the specific volume at the inlet? a) 0.06647 m³/kg B) 0.07343 m³/kg NS) 0.05842 m³/kg D) 0.05197 m³/kg TO) 0.05784 m³/kg
A refrigeration systerm using refrigerant 11 is lo have a refrigerating capacity of 80 kW. The cycle is a standard vapor-compression cycle in which the evaporating temperature is -15°C and the condensing temperature 30°C. Determine the volume flow of refrigerant measured in liters per second at the inlet to the compressor. 213.02 B) 123.01 c) 62.61 314.84
12
Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator temperature is -10°C. Saturated vapor enters the condenser at 36°C, and saturated liquid exits at the same temperature. The mass flow rate of refrigerant is 10 kg/min. Determine the COP, (A) 5.72 B) 8.53 Ⓒ10 D) 3.68
R A machine working on a Carnot cycle operates between 300 K and 250 K Determine the COP when it is operated as i) a refrigerating machineii) a heat pumpiii)a heat engine