Let the voltage passing through a resistance R = 1000 ± 20 ohm is 10.0 ± 0.1 Volt. The average power percentage error band are:

Q: What does a vector network analyser do to a PCB?

A: We need to explain vector network analyser do to a PCB.

Q: Write shortly about the instrumentation of FT-IR?  Please shortly answer at your own words. Answer…

A:

Q: Discuss whether NEC provides the maximum requirements or minimum requirements.

A: NEC is the acronym of National Electrical Code.

Q: Explain Hartley configuration?

A: The circuit diagram of a Hartley oscillator is given as:

Q: Describe about the smoke alarm experiment.

A: Smoke detectors are used to detect the smoke. When there is a fire and smoke arises, then these…

Q: What are the implications of having a damaged VRM (Voltage Regulator Module) on a motherboard?

A: What are the implications of having a damaged VRM (Voltage Regulator Module) on a motherboard?

Q: Draw the instrumentation of FT-IR? Please answer at your own words (To the point).

A:

Q: Match the signal state with its description. READY=1 A. The MPU has put valid data on the bus B.…

A: Here in left side specific signal is given in which * indicates the active low signal means it can…

Q: Using two pairs of emitters and detectors allows turning an incremental shaft encoder into an…

A: The answer is option 2 2. Usually the two emitter/detector pairs are out of phase by an angle of 90…

Q: Explain the concept of "frequency hopping" and its advantages.

A:

Q: Describe the significance of power phases and voltage regulation modules on a motherboard,…

A: Power Phases and Voltage Regulation Modules (VRMs) play a critical role in a computer's motherboard,…

Q: In processing geomagnetic data, known to the term reduced to pole (RTP) a. What are the limits of…

A: Earth's magnetic field is responsible for many of the applications in life of living organisms. some…

Q: Why we use FT-IR instrumentation?  Please shortly answer at your own words.

A: The explanation is as follows.

Q: Describe what a Q-Point is, and what is its purpose.

A: Q point is also called as the operating point of a device or a bias point.

Q: What causes ground loops in an instrumen­tation system? What are the effects of a ground loop?

A: Given:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.