Is the (Percentage error in R) correct? Use the figures below of voltmeter and ammeter to find the following:7.20 v48.0 mANA20 A ACOM VW20 A A COM vwAccuracy of voltmeter is 0.01Accuracy of ammeter is0.1v mAUse the ammeter and voltmeter reading from above to find :where V=RI NANA20 A A COM vw20 A A COM VWAccuracy of voltmeter is 0.01v VAccuracy of ammeter is 0.1v mAUse the ammeter and voltmeter reading from above to find :where V=RIvalue of resistance R = 150Percentage error in R = 0.3

SOlution given that V = 7.2 V accuracy =0.01 % I =48 mA accuracy = 0.1

Jse the figures below of voltmeter and ammeter to find the following: 7.20 v 48.0 mA V 20 A A COM VW 20 A A COM VW Accuracy of voltmeter is 0.01 v V Accuracy of ammeter is 0.1 v mA Jse the ammeter and voltmeter reading from above to find:

Jse the figures below of voltmeter and ammeter to find the following: 7.20 v 48.0 mA V 20 A A COM VW 20 A A COM VW Accuracy of voltmeter is 0.01 v V Accuracy of ammeter is 0.1 v mA Jse the ammeter and voltmeter reading from above to find:

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: A stretched string has a mass per unit length of 5.27 g/cm and a tension of 10.5 N. A sinusoidal…

A: Answer:- (a) The amplitude of the wave (Ym) = 0.150 mm (b) we know that The wave Speed (V) =( T/u…

Q: a) -3 -5 = = (-³) ₁4 = (²³) 5 Show steps (Your score will not be affected.) What is p₁ when po 43…

A: Given That: p0→=-31 d→=-55 The velocity is given by: v→=d→|d→| v→=-55(-5)2+(5)2 v→=-7.0717.071

Q: A hockey puck (5g) slides horizontally without friction across the ice from position A to E. Draw…

A: We are given the hockey puck which is sliding on horizontal without any friction. Thus there will no…

Q: In a Measurement ,the Expected value is 56 V and the measured value is 52 V. Find (i) Absolute error…

A: Given Expected value. Is 56 Measured value is 52.

Q: A sphere of mass 4.9× 10-4 kg is suspended from a cord. A steady horizontal breeze pushes the sphere…

Q: In an experiment four quantities a, b, cand d are measured with percentage error 1%, 2%, 3% and 4%…

Q: (d) An air compressor tank reads 40 psig and the atmosphere is 15 psia. What is the absolute…

A: Given, PGauge=40 psigPatm=15 psia

Q: What is fractional error or percent error?

A: Fractional error is the ratio of the value of error to the value of the quantity.

Q: Rank these SI distance units from smallest to largest: μm, am, fm, nm, mm, cm, m, km, Gm, Tm, Mm,…

A: Rank these SI distance units from smallest to largest: μm, am, fm, nm, mm, cm, m, km, Gm, Tm, Mm,…

Q: f (Hz) 50 100 150 (Vind) meas 11.91 22.99 34.17 ● ● slope = Lcalc Lmeas (from slope) = HoNcNsAc ls %…

A: The slope of a graph is a measure of how steeply the graph changes between two points. It is defined…

Q: ' Find the relative error in Z, if Z and CD 3/2 4%, 2%, 3% and 1%, respectively.

A: Given relation : Z = A4 B1/3C D3/2Percentage error in A = 4% Percentage error in B = 2% Percentage…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A: Draw the free-body diagram of the system.

Q: In an experiment to measure the value of pi, the following results are obtained for pi: 3.14…

A: The computation of percent error helps to determine how near a measured number is to a real value.…

Q: Which of the following expressions accurately describes how these two distinct waves will combine?…

Q: The error in two readings of A are 0.01 and -0.03, then mean absolute error is ?

A: The error in two readings of A are 0.01 and -0.03 First, the absolute value of the errors is taken…

Q: An electron that has a velocity with x component 2.0 x 10° m/s and y component 3.2 × 106 m/s moves…

Q: If u⃗=<8,5>and v⃗=<−9,−2>, find projv⃗u

A: Basic Details The projection of the vector v over u is orthogonal projection of an onto vector on…

Q: The uniform beam has a mass of 55 kg per meter of length. Determine the reactions at the supports. A…

A: The reactions at the supports. Given, mass per unit lengthmL=55 kg·m-1mass of blockmb=250 kgLength…

Q: Determine the values of I, and I, that satisfy the following two equations. 8.15 + 3.40/, - 2.101, =…

Q: In the figure four particles are fixed along an x axis, separated by distances d = 5.30 cm. The…

Q: bottom of the what distance

A: GivenA cylindrical tank filled with water to depth, D=0.35 mCrossectional area of hole, A=6.67…

Q: Q.11. The radius of a sphere is measured to be (2.1± 0.5) cm. Calculate its surface area with error…

A: radius = 2.1 ± 0.5 cm Area of sphere = 4 π r2 4 x 3.14 x (2.1)2 area=55.4 cm 2 Calculating the error…

Q: if v is in meters per second, B in teslas, and L in meters, then the units of the right-hand side of…

A: It is given that the unit of velocity (v) is m/s, unit of magnetic field (B) is tesla and unit of…

Q: Give brief description on Absolute, Relative and Percentage error.

A: Absolute error is difference between estimated value and the true value.

Q: H'(0) = H"(0) =

Q: In the figure the current in resistance 6 is ig = 1.39 A and the resistances are R, = R2 = R3 = 2.40…

Q: Q.11. The radius of a sphere is measured to be (2.1± 0.5) cm. Calculate its surface area with error…

A: Given data, Radius of sphere, r=2.1±0.5 cm

Q: where a = i+2j+3k and b= 2i -3j +k, -1 * calculate R=Da.b

Q: In a Measurement ,the Expected value is 72 V and the measured value is 63 V. Find (i) Absolute error…

A: (i) The absolute error is given by : (ii) The relative error is given by :

Q: What is the value of the following integral? 100/2 pz/2 I = xô(2 sin x– 2)dx |

Q: why did you do times 3.2?

Q: Question 2 ICE MELLEM Connect the two batteries as shown. This is known as a parallel connection.…

A: Battery is devise which is used to supply the voltage to the circuit. Connection may have two types…

Q: One long wire lies along an x axis and carries a current of 31 A in the positive x direction. A…

Q: Do random errors contribute to % error and/or standard deviation? Why?

A: Random errors are inherent fluctuations in experimental measurements caused by various unpredictable…

Q: A commercial airliner with four jet engines, each producing 64 kN of forward thrust, is in a steady,…

A: Given Four jet engine provide forward thrust, F=64KN In this case, we have a commercial jet with…

Q: Give an educated guess for the requested values of in Volts expressed as integer numbers, i.e. no…

A: Expression of current in a series LR circuit is given as- It=VR(1-e-RtL)

Q: The cable AB carries a tension of 540 N. Determine the moment about O (positive if counterclockwise,…

A: Given dataT=540NOB=700mmOA=490mmθ=90-26=64°

Q: Two particles are fixed to an x axis: particle 1 of charge q cm. At what coordinate on the x axis is…

A: Givenq1=1.69×10-8 Cat x1=22 cm=0.22 mq2=-4.84 q1x2=66.0 cm=0.66 m

Q: Determine the magnitude F and direction (measured clockwise from the positive y-axis which is…

A: We have four forces given by F1=8.8 kN making an angle 31o with +x axis, F2=14.4 kN making an angle…

Concept explainers

Half Life

The concept of Half Life has numerous practical applications some of them includes figuring out the effective drug dosage to finding out when a radioactive becomes safe to use. If you look for a career in Nuclear Physics you will need this concept.

Question

Is the (Percentage error in R) correct?

Use the figures below of voltmeter and ammeter to find the following:
7.20 v
48.0 mA
NA
20 A A
COM VW
20 A A COM vw
Accuracy of voltmeter is 0.01
Accuracy of ammeter is
0.1
v mA
Use the ammeter and voltmeter reading from above to find :
where V=RI

NA
NA
20 A A COM vw
20 A A COM VW
Accuracy of voltmeter is 0.01
v V
Accuracy of ammeter is 0.1
v mA
Use the ammeter and voltmeter reading from above to find :
where V=RI
value of resistance R = 150
Percentage error in R = 0.3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The flanged steel cantilever beam with riveted bracket is subjected to the couple and two forces shown, and their effect on the design of the attachment at A must be determined. Replace the two forces and couple by an equivalent couple M and resultant Rat A. The couple is positive if counterclockwise, negative if clockwise. 2.01 KN 0.49 m 1.52 m- 76⁰ A 6 Answers: M= kN.m R=( i i+ i L-- 500 N·m 10.17 m 0.17 m 1.05 KN j) kN
Given that sin u = 1> V5 and cos u = -2>V5, use trigonometric identities to find the values of tan u, cot u, sec u, and cse u.
My answer is 1.38x10^-11. but it is wrong. Also x10 output is not accepted. The tolerance is positivenegative 1 in the 3rd significant figure
A series of four measurements of g are made in the physics lab. The results of these measurements in ms2/ are: 9.63, 9.58, 9.71, 9.68. The average of these four measurements is the experimental value of g and the accepted value is 9.80 ms2/. What is the percent error of these measurements?
(a) Number i Units (b) Number i Units (c) (d) (e) > > > >
1Pa = 1N/m true or false?
please put the exact number
Carry out the arithmetic operations (5.0x10^O)+(3.000x10^-1) , apply the significant figure standards. Note: Your answer is assumed to be reduced to the highest power possible. Your Answer: x10 Answer
y1 = sin(pi(x) - 2(pi)(t))......y2 = sin(pi(x)/2 + 2(pi)(t))