It is the measure of denseness of granular soil. Select one: O a. Dry unit weight O b. Unit weight c. Dry density d. Relative density The compacted field dry unit weight must be between the range of in the laboratory to be considered satisfactory. _% of the max. dry unit weight determined Select one: a. 75-79 b. 80-84 C. 85-89 d. 90-95 In the modified compaction test, soil is compacted in the mold layer by layer. How many layers are required? Select one: a. 10 b. 3 C. 8 d. 5

It is the measure of denseness of granular soil. Select one: O a. Dry unit weight O b. Unit weight c. Dry density d. Relative density The compacted field dry unit weight must be between the range of in the laboratory to be considered satisfactory. _% of the max. dry unit weight determined Select one: a. 75-79 b. 80-84 C. 85-89 d. 90-95 In the modified compaction test, soil is compacted in the mold layer by layer. How many layers are required? Select one: a. 10 b. 3 C. 8 d. 5

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A sample of saturated soft clay has a moisture content of w. The specific weight of solids é ys em g-f/cm' (Table 1). What is the void index, porosity and saturated specific weight of the soil (in g-f/cm). Adopt water specific weight of 1 g-f/cm3.
The laboratory compaction test of a certain type of soil gives a max dry density of 1.486 gm/cu.cm with an optimum water content of 12.5%. The ff are the results of a field density test using sand code equipment: Volume of soil excavated from the hole= 0.001337 cu.m. Weight of wet soil from the hole- 2220 grams Weight of soil after oven drying= 1890 grams a. Determine the field unit weight of the soil in gm/cu.cm. b. Find the water content of soil. c. What is the relative compaction?
The total weight of soil sample is 56.7lb and the total volume is 0.5ft3 the dried weight is 48.7lb. specific gravity of soil is 2.69. Which of the following gives the dry unit weight of the sample? Ans: 97.42 pcf
A 1972 kg/mᶟ wet unit weight and 5.5% average actual moisture content were obtained from a laboratory data during the conduct of FDT on an aggregate base coarse materials, what is the dry unit weight of the soil? From the above laboratory data and the obtained dry unit weight of soil, What will be the degree of compaction of the compacted materials when a 1960 kg/mᶟ maximum dry density is used as a reference Laboratory compaction data?
Q2. Atterberg limits tests were performed on samples of a fine-grained soil with a natural water content in the field of 32.5% and the following results were obtained: a). b). c). UNIVERSITÉ D'OTTAWA - CONTENU PROT LE DROIT D'AUTEUR 8 0 VAVILO SEND ERIAL Test # (-) 1 2 3 4 Total wet mass (soil + tare) (g) 25.50 CONTENU PROTE vez pou C Plastic limit determination Total dry mass (soil + tare) (g) 22.30 2 3 4 28.40 22.20 26.30 Liquid limit determination Test # No of blows Water content (-) (-) 1 15 24.50 19.10 22 23.20 33 55 (%) 45.3 Mass of tare (g) 1.80 39.4 34.8 27.0 1.90 Determine the PL of the soil (average of all four tests). Plot the flow curve and determine the LL of the soil. Calculate the PI and the liquidity index, LI of the soil. What is the soil state in the field? (Liquid, plastic, solid?) e). What is the predominant mineral in this soil? 1.50 1.80 XIAL are protected by copyright and o not have permission to upload the you require clarification, please PROTÉGÉ PAR
solution of subpart e,f of question?
6. Following is the result of 8 trials of a standard proctor test. Determine the optimum water content and maximum dry unit weight. Determine also the amount of energy expended in the compaction of one of the trials assuming that the test done is standard proctor test. Proctor Mold Volume Mass of wet soil in the Moisture Content Trial (cm³) mold (kG) (%) 1 943.3 1.68 9.9 943.3 1.71 10.6 3 943.3 1.77 12.1 4 943.3 1,83 13.8 943.3 1.86 15.1 6 943.3 1.88 17.4 943.3 1.87 19.4 8 943.3 1.85 21.2
Soil Mechanics
The result of the particle-size analysis of a soil are as follows: Sieve No. % Passing 10 40 200 100 80 58 7. The liquid limit and plasticity index of the soil are 30 and 10, respectively. Classify the soil by AASHTO Classification system. а. А-4 (3) b. A-4(4) A-5(3) d. A-5(4) C.
Approximate the maximum dry unit weight in kN/cu.m. Approximate the optimum moisture content. And If the required relative compaction in the field is 95%, what must be the required dry unit weight of the soil in the field in kN/cu.m.? NEED ASAP. THANK YOU
1.5 cm datum The following are the results of a compaction test; Mass of mold+wet soil(g) 2925 3095 3150 3125 3070 Water content% 10 12 14.3 16.1 18.2 If the volume of mold = 1000 ml, and mass of mold = 1000 g, and Specific gravit of solids = 2.70. G4 Wc a. Find the compaction curve showing the optimum moisture content and maximu dry density. b. Plot the zero air void line. c. Determine the degree of saturation at the maximum dry density. Sr P COONCOM
Please answer both.... Pleaseee give me both answers.. help me... Thank you