In an ideal Rankine cycle with reheat, which of the following statements is wrong? a. A mixture of liquid and vapor is found at the exit of the first turbine if saturated vapor enters this turbine b. The temperature at the inlet of the second turbine is lower than the temperature at the exit of the first turbine C. The isentropic efficiency of the turbine and that of the pump are equal to 100% d. 3 isobaric curves are khown on the TS diagram

In an ideal Rankine cycle with reheat, which of the following statements is wrong? a. A mixture of liquid and vapor is found at the exit of the first turbine if saturated vapor enters this turbine b. The temperature at the inlet of the second turbine is lower than the temperature at the exit of the first turbine C. The isentropic efficiency of the turbine and that of the pump are equal to 100% d. 3 isobaric curves are khown on the TS diagram

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Which one of the statements is false about the Regenerative Rankine cycle? a. Regenerator operates at constant temperature Regenerator reduces the heat input to boiler C. Steam from turbine and water from condenser are mixed in Regenerator
Instructions: solve problems under the concept of Reheat, Regenerative and Reheat-Regenerative Cycle in Rankine cycles (set the values to 4 decimal places for consistency) Review Questions (M.1) Steam at 10 MPa, 600 °C enters the first-stage turbine of an ideal Rankine cycle with reheat. The steam leaving the reheat section of the steam generator is at 500 °C, and the condenser pressure is 6 kPa. If the quality at the exit of the second stage turbine is 90%, determine a) the mass flow rate of the steam in kg/h and b) thermal efficiency (%) of the cycle c) mass of the cooling water in kg/ h, if the temperature rise in the cooling water is 20 °C.
B-Correct the wrong sentence: 1. Adiabatic compression is the most desirable process to get minimum work in the compressor. 2. The thermal efficiency of constant pressure cycle is depends on the compression ratio 3. The most important fuel elements are carbon and ash. 4. The pressure of a mixture of gases is equal to the sum of partial masses of the constituents. 5. The Rankine cycle is the most efficient cycle
why does q surrounding not need to be delivered reversibly?
Identify the eftectiveness of a regenerator and demonstrate why the enthalpy value before the turbine expansion process is important.
A gas turbine cycle with two stage of compression and two stage of expansion, the overall pressure ratio is 9, air enters each stage of compression at 298 K and each stage of turbine at 1200 K. Determine the thermal efficiency of the cycle under the following conditions:- 1- no heat exchanger is used. 2- ideal regenerator is used
Consider the operation of the ideal Brayton cycle with a regenerator. The maximum temperature in the cycle is set. What happens with increasing pressure ratio? Group of answer choices The amount of heat added in the cycle up to a point will decrease with net work output remaining the same and thermal efficiency will increase. Thermal efficiency will increase Compressor exit temperature will increase with turbine exit temperature remaining the same. When the two temperatures are equal, the benefit of the regenerator will be zero. Thermal efficiency will decrease
In a Brayton Cycle air enters the compressor at 101.32 kPa, 32 °C and leaves at a pressure of 808 kPaa. The air is heated to 717 °C in the combustor. For a net output of 2125 kW, compute: a) mass flow rate of air (kg/s), b) thermal efficiency of the cycle. use k = 1.4 for all problems
What’s the correct answer for this please ?