In a landfill site, composted organic material (compost) is being used as a daily cover. Calculate the landfill gas potential (as m3 CH4) of 2000 tons of composted material using Tabasaran-Rettenberger Model. G:=1,868.C.(0,014.T+0,28)(1-10-k.t)

In a landfill site, composted organic material (compost) is being used as a daily cover. Calculate the landfill gas potential (as m3 CH4) of 2000 tons of composted material using Tabasaran-Rettenberger Model. G:=1,868.C.(0,014.T+0,28)(1-10-k.t)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: H.W : The losses per unit length pipe Ah/l in turbulent flow through small pipe depend upon…

Q: MOITAKIMAKS MUERT GIM 1.) DETERMINE THE COEFFICIENT OF PERMEABILITY FROM THE FOLLOWING DATA (MM/S)…

Q: A: Density bottle test: Sample 1: Dal = 0.9982 x (83.49-62.12) (251.31-62.12) - (264.41-8 = 2.58…

A: SampleDensity, g/cc12.5822.6132.6242.5352.5662.57

Q: By constructing flownets for the section shown in Figure, plot a curve explained the relation…

A: A flow net is generally a graphical representation of two-dimensional and also the steady-state…

Q: stimate the theoretical production of landfill gas (CH4 only) from the degradation of 20.3 kg of…

A: Density of metahne = 0.7177kg/m3We have to determine the theoritical production of landfill gas CH4…

Q: 2. A suspension of particles with a particle density of 2796 kg/m³ is settling in water with a…

A: Given Specific gravity G = 2796/1000 = 2.796 Kinematic viscosity of water at 20 ° C = 1.004 × 10 -6…

Q: A very small drop of fluid 1 immersed in fluid 2 is sitting on a solid surface. Based on the image…

A: A contact angle less than 90 indicates wetting liquid or hydrophilic liquid and lower density as…

Q: Please solve both questions.... Please answers both one.... Urgent Thank you

A: Ans 21) The answer to the above statement is option(d). Because Environment impact assessment is a…

Q: H=81.137 O H=91.137 O H=71.137 C H=61.137 Exz- If the lowrate between two tanks is (o.s m/s), And…

A: To Determine Head loss, H

Q: (b) Specify the values of: 1. initial concentration, Co (mg/L). II. loading, L (mg/L-day). III. rate…

A: Initial Concentration, C0(mg/L): An instantaneous loading of 0.25kg and a continuos load of…

Q: Suppose that a1.69 m and bs13 m. (Egute D Part A Determine the moment of inertia for the shaded area…

A: Given:- A shaded area is given with equation y = x1/2 The value of a = 1.69 m The value of b = 1.3…

Q: Calculate the approximate viscosity of oil. 0.6x0.6 m sauare plate W 15kgr 13 5 12 -0.12 cm oil film…

A: Introduction : The viscosity of oil is the ease with which it pours at a given temperature. Thin…

Q: Q1 A gravitational settling chamber is to be installed in a factory to remove particulate matter. As…

Q: Before Impact VA VB After Impact VA' V'E

Q: An activated sludge system is composed of four aeration tanks, each of 18 m length 12 m width and…

A: Given;Tank size,Length = 18 mwidth = 12 mDepth = 4.5 mAvg. flowrate of sewage = 9000 m3/dayInfluent…

Q: For a waste pipe, 32 m long, the maximum slope available with a space to the false ceiling of 384…

A: Given data, Pipe length = 32 m Space available = 384 mm = 0.384 m

Q: (d) COD levers of 60 mg/L were measured in groundwater. contamination is the main cause. It is…

A: It is assumed that fuel hydrocarbons have an average unit formula of CH2

Q: The losses per unit length of pipe in turbulent flow through smooth pipe depend upon velocity V,…

A: step 1-

Q: of particulate matter left in soluthon during a filtering pro p(n)=400(2)-0.4n, where nis then ps.…

A: This question is related to Filtration from Environment Engineering from Civil Engineering. In this…

Q: A RSF is to be designed to treat 4MLD of water, 4% of filtered water is required for washing of the…

A: Given: ROF = 4000 lt/hr/m2 A RSF is to be designed to treat 4 MLD of water L:B = 2:1 To find the…

Q: 24. An activated sludge system is designed to treat 30. MLD of sewage. Based on the following…

Q: Determine the total mass of solids removed over the entire 8-hour period, in kg.

A: A table is shown in the given figure as need to findThe total mass of solids removed over the entire…

Q: Which of the following equations is the Hazen-Williams equation for calculating energy loss due to…

Q: There is sedimentation tank that is used to remove suspended solid particles from an incoming…

A: Given Discharge= 150m3/hr surface area= 15m2

Q: Solve the points in the hand

A: 4.4 C-ThOD for Lysine Wastewater:Find the Theoretical Oxygen Demand (ThOD) of Lysine:Search for…

Q: 46 A municipal corporation is required to treat 1000 m³/day of water. It is found that an overflow…

A: Given - quantity of water, Qo = 1000 m3/d Overflow rate = 20 MLD To find - The diameter (in…

Q: The duration of activity 10-30 is: 8 17 T=8 40 T=8 60 10 T=9 T=4 T=6 30 50 T.F.=4 10 8. O 5 20

A: Given information Duration Total float To find Duration of 10 - 30

Q: 6- A water plant is designing disinfection process using ozone as a major disinfectant. Based on the…

A: To find:a) Using Chick's law, calculate contact time T (in minutes) for 3 log inactivation of the…

Q: During the Storm sewer system (design for sewer pipes) shown in the figure 1 below using rational…

A: Given, Intensity I=20.2td0.52 Manning's n = 0.012

Q: Check the accuracy of the water analysis given in Problem, CONSTITUENT Ca Mg K Na HCO, CIT CO SO₁…

Q: 10

A: Given:- a1=0.2ppm/ton a2=0.2ppm/ton background pollution is 40 ppm, pollution from source 1 is 100…

Q: Samples of water are tested for total dissolved solids (TDS). TDS is normally distributed. The…

A: Given Data:TDS2480 2440 2400+34 2360+37 2320Frequency2335402221

Q: H1 H2 Toe filter H1 12m and H2 2m Calculate head loss and head available at red, blue, green, purple…

A: H1=12m H2=2m

Q: lut. a. cercle around the correct AN Evapo-Transpiration is denoted by a) ET b)PT c) TE…

A: Note-Note: As per authoring guidelines, if the question is not mentioned, attempt the first question…

Q: Q3. according to the data of water depths in figure below that collected in the cans test find: - 1-…

A: By deducting the minimum water level from the highest water depth and dividing the result by the…

Q: Approximately 505 gallons of liquid gasoline have contaminated the soil underneath an existing…

A: Given data, Total amount of gasoline contamination = 505 gallons Amount of gasoline to be extracted…

Q: 10. Compute BOD5-20 if BoD1-25 = 95 mg/L for a waste water sample? %3D

A: Given:- BOD1-25=95 mg/L To find:- BOD5-20

Q: A two-dimensional conduit has the velocity distributions shown in figure (a) and (b). Calculate the…

A: Correction factor--- The mean velocity is defined for discharge. The momentum transfer rate and…

Q: 500 gm of dry soil was poured into a 2 L cylinder. The cylinder is partially filled with water. The…

A: Given data- weight of the dry soil-Ws=500 gmvolume of cylinderV=2 LSoil replaces 188 cm3 of waterTo…

Concept explainers

Collection Systems

The collection systems form a part of sanitary engineering, which is a sub-branch of civil engineering. It is also known as public health engineering and wastewater engineering. It is a methodology followed to remove and properly dispose of human waste, along with creating systems to provide safe and clean usable water. These measures ensure a hygienic and disease-free community. Sanitary engineering, apart from building sewer disposal units, is also involved in plumbing, fire protection, hydraulics, life safety, environmental protection, information technology, microbiology, pathology, and so on.

Question

In a landfill site, composted organic material (compost) is being used as a daily cover.
landfill gas potential (as m3 CH4) of 2000 tons of composted material using Tabasaran-Rettenberger
Calculate the
Model.
Gt=1,868.C.(0,014.T+0,28)(1-10-k.t)
Assumptions must be indicated.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1 Assumptions

VIEW

Step 2 Calcu;ation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

(Same given conditions as the previous problem) Convert one hr UH to 2 hr UH. What is the value of "C" in the table? time (hr) 0 0.5 1 1.5 2 2.5 3 3.5 1-hr UH, cfs 0 32 44 52 36 22 10 O 2-hr UH, cfs 0 A B CO С
B4
If the viscosity of a certain liquid of water is 13,391 poise and its specific weight is 18,783.65 N/m3. Determine its kinematic viscosity in m2/s. 1 poise = 0.1 Pa-sec
The air pollution emission rate E in a parking lot may be approximated by the step function shown in the figure below. Assuming a constant airflow F and zero initial pollutant concentration, determine C(t) and plot it. E E1 t1
Please give me both a and b solutions A settling tank with (L=6m, W=4 m , H= 4 m) treats a waste stream (60,000 l/min) and removes suspended solids with 200 micrometer diameter that have a settling velocity of 0.04 m/s. a. What is the removal efficiency of his tank? b. If a 100% removal efficiency is to be achieved, How long should the settling tank be?
(a) Sketch a typical Streeter-Phelps oxygen-sag curve and state its limitations. dD (b) The rate of change of the dissolved oxygen deficit, ", is the net effect of the rate of dt re-aeration, given as – k D, and the rate of oxygen utilization, given as k,Le , where ko, ka and Lo are the re-aeration rate constant, the decay constant, and the ultimate BOD, respectively. Write the expression for the rate of change of the dissolved oxygen deficit. Then argue why the maximum deficit, De, occurring at the critical time, to, is given by: ka Le D. k.
PST . Civil,
Compute the sonic velocity of
Calculate the aerosol scavenging coefficient ^ as a function of the diameter d of the scavenged particle over a size range of P 0.01 -0.1μm diameter for drops of diameter D = 5mm P falling at their terminal velocity in the air at 25°C. Assume that P = 1mmh¹ 0
Conclusion about learning DETERMINATION OF EVAPOTRANSPIRATION and estimating the evapotranspiration using FAO Penman-Monteith,Modified Penman, Jensen-Haise, and Hargreaves, and how will you apply this as an agricultural engineering student
Use the Liquid Limit
The following data was obtained from a field study to determine how a toxic pollutant reacts. Determine the order reaction and the rate constant, with proper units. day time (d) 0.25 0.5 1 2 2.5 3.5 concentration (mg/L) Ct (mg/L) 15 12 10 8. 3 1 0.5 0.02 3.