In a given sandy soil, e max=0.82 and emin=0.42, if G,= 2.66. In the field the soil is compacted to a moist density of 1720 kg/m³ at a moisture content of 9%. Determine 8) In situ void ratio (e) ? a) 0.978 b) 0.686 c) 0.553 d) 1.00 9) What is the relative density of compaction? a) 43.50 % b) 33.50 %

Q: Answer 4.3

A:

Q: The dry density of a sand with porosity of 0.37 is 1.61 Mg/m. Calculate the void ratio of the soil:…

A: Introduction : In this question we have to determine the value of void ratio . Void ratio is defined…

Q: FOR A GIVEN SOIL SAMPLE, THE FOLLOWING ARE KNOWN. ES=2-74, MOIST UNIT WEIGHT = 20 6 kN/m²³, AND…

A:

Q: 1. The maximum density corresponds to (maximum/minimum). 2. An increase in the degree of saturation…

A: Triaxial test- This test is done on a cylindrical core soil sample to find its shear strength.

Q: A stratified soil has the following properties: h1 = 1.75m h2 = 2.5m h3 = 4.35m k1 = 2.25E-03 cm/sec…

A: What is the equivalent coefficient of permeability if the water flows parallel to the layer of soil…

Q: The moist unit weight of a soil is 119.5 lb/ft*3. For a moisture content of 12% and G=2.65…

A: The given data is: The moist unit weight of a soil=119.5 lb/ft*3 moisture content=12% G=2.65

Q: A clayey sand (SC) was compacted into a 1/30th cubic foot cylindrical Proctor steel mold with the…

A: Given:Volume of the mold (V) = 1/30 ft3 Weight of dry soil (Wd) = 4.18 lbWeight of wet soil (W) =…

Q: The maximum and minimum dry unit weights of a sand were determined in the laboratory to be 16.9 kN/m…

A:

Q: The maximum and minimum void ratio of the sandy soil is 0.837 and 0.414, respectively. It has been…

A:

Q: For a given soil, show that 1 + W sat w Yw Ysat = n( = n(¹ Won)y. W sat where wsat = moisture…

A: Prove the given relation between different quantities.

Q: A sample of sandy soil has the value of the void ratio in loosest condition of 0.78 and a void ratio…

A:

Q: 9. A cubic meter of a saturated, normally consolidated clay has a dry mass of 4 kg and a porosity of…

A: Since we know that                 Void ratio (e) = Porosity1- porosity = n1-n Here porosity (n) =…

Q: he dry unit of a sand with a porosity of 0.387 is 1600 kg/cu.m. Determine the following: a) Void…

A: Given-  Porosity n=0.387Dryunit weight γd=1600Kg/Cu.m Unit weight of water γw=1000Kg/m3=10Kn/m3…

Q: A saturated 100cm^3 clay sample has a natural water content of 30% . It is found that the shrinkage…

A: Use formula of shrinkage limit Ws=1/R - 1/G

Q: 9. A cubic meter of a saturatod, normally consolidated clay has a dry mass of 4 kg and a porosity of…

A:

Q: A silty clay has a plastic limit of 29.0 and a plastic index of 34.0. If the clay has a liquid index…

A: It is required to determine the liquid limit. PI=LL-PL Here PI is the plasticity index, LL is the…

Q: 1. The maximum density corresponds to (maximum/minimum)_ 2. An increase in the degree of saturation…

A: Note- It has been asked to solve question 7. Sand Cone Method- In this method, a hole is dig and…

Q: A saturated soil specimen has w = 36% and ᵞd = 85.43 lb/ft3. Determine: i) Void ratio ii) Porosity

A: Given: Water content, w = 36% = 0.36 Dry unit weight = 85.43 lb/ft3 Degree of saturation, S = 100% =…

Q: Consistency index for a clayey soil is [LL = Liquid Limit, PL = Plastic Limit, PI = Plasticity…

A: Index properties show significant information about the state of soil. Among various index…

Q: For a 4-m thick sandy soil deposit, laboratory tests indicate that its minimum and maximum void…

A: Kindly Note: As per our guidelines, we are supposed to solve the first 3 sub-parts. Kindly repost…

Q: 2.A. What is the difference between the flocculated structure and dlsp B. Classify the soil having…

A: Flocculated structure : It has high surface area  It has a negative charge on the face and a…

Q: 1. The maximum density corresponds to (maximum/minimum)_ 2. An increase in the degree of saturation…

A: 1.The maximum density corresponds to (maximum/minimum)__  void ratio. 2.An increase in the degree of…

Q: What is the value of the natural water content in percentage? B) What is the value of the in-situ…

A: SOIL MECHANICS:

Q: Problem. 2, A soil has void ratio = 0.72, moisture content = 12% and G₂= 2.72. its Determine

A:

Q: Q4: the moist unit weight of a soil is 19.2kN/m³. Given that Gs =2.69 and w=9.8%, determine a. Dry…

A: The given data is as follows: Moist unit weight of soil=19.2 kN/m3Gs=2.69w=9.8%

Q: The dry density of a sand with porosity of 0.37 is 1.61 Mg/m. Calculate the void ratio of the soil:…

A: The porosity of the sand is = n = 0.37  The relationship between void ratio (e) and porosity (n) is…

Q: Situation 1 - The void space in a soil samp The dry unit weight is yd = 14.5 k Determine the…

A: We knowusing equation :γd=γwG1+e14.5=2.729.811+ee=0.84

Q: A silty clay has a plastic limit of 25 and a plasticity index of 30. If the clay has a liquidity…

A: To find water content, degree if saturation, and moist unit weight

Q: Problem: The moist unit weight of a soil is 18.5 kN/m3. Given that Gs = 2.60 and w = 12%, determine:…

A: given data: YTotal=YMoist=18.5 KN/m3specific gravity (Gs)=2.60water content (w)=12%unit weight of…

Q: Sand is used in the cone is known to have a bulk density of 15.74 kN/m3 Wet weight=20.601 N Dry…

A:

Calculation of Settlement

The vertical displacement of the structural foundation due to the loading from the superstructure is known as settlement. It is due to the reduction of air voids present in the soil. The amount of vertical displacement depends on the bearing capacity of the soil on which the foundation is laid. The effect of the settlement depends on the magnitude of settlement, uniformity, and the structural design of the structure. The maximum allowable settlement for residential and office buildings should be less than 18 mm, for industrial buildings, it is 38 mm and for commercial buildings, it is 25 mm.