Q1) In a cylinder-piston arrangement shown (D1mm), the piston is moving downwards at Vp = 0.5mm/s, and as it does, the water flows outward throughthe side orifice (D2 = 10 mm) of the cylinder to fill thetank (D3 = 50 mm) state below it. Determine the rate= 100%3Dat which the depth z of the water in the down tank ischanging.

Given: Diameter of Piston, D1=100 mm Velocity of Piston, Vp=0.5 mm/sec Diameter of orifice , D2=10…

In a cylinder-piston arrangement shown (D1 = 100 hm), the piston is moving downwards at V, = 0.5 %3D m/s, and as it does, the water flows outward through he side orifice (D2 10 mm) of the cylinder to fill the ank (D3 50 mm) state below it. Determine the rate t which the depth z of the water in the down tank is hanging.

In a cylinder-piston arrangement shown (D1 = 100 hm), the piston is moving downwards at V, = 0.5 %3D m/s, and as it does, the water flows outward through he side orifice (D2 10 mm) of the cylinder to fill the ank (D3 50 mm) state below it. Determine the rate t which the depth z of the water in the down tank is hanging.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Supposed to use Bernoulli’s theorem for incompressible fluid.
A pump draws water from a reservoir A and lifts it to reservoir B as shown. The loss of head from A and lifts it to reservoir B as shown. The loss of head from A to (1) is 5 times the velocity head in the 12-inch pipe and the loss of head from (2) to B is 23 times the velocity head in the 7-inch pipe. Compute the pressure heads (2) in ft when the discharge is 447 gpm. Round your answer to 2 decimal places.
Determine (a) the discharge in the tube immediately after it is opened. Determine (b) the time for the water surface in each tank to be at the same level. Determine (c) the time for the difference in the water surface to be 4 meters.....
Q3
I need help for this question. Thank youu
Water at 20°C flows through a 300-mm-diameter pipe that discharg sphere as shown in Figure 4.61, When a partially open val the top of the pipe, the flow rate in the pipe is 0.2 m*s and the (gauge) pressure just upstream of the valve is 600 kPa. Estimate the force partially open valve, es into the atmo- ve extends 200 mm from exerted by the water on the —Valve 0.2 mYs —» Atmosphere Figure
Consider the figure shown below. If the flow rate of water from the tank is 0.03 m/s, the pressure at point 2 is 120kPa. Height of water in the tank is 4m and the pipe diameter is 160mm with a friction factor of 0.020. Solve for the height h if the branch line is shut off, and if the branch line is open so that half of the flow from the tank goes into the branch and half continues in the main line. Determine the difference in the head losses in both directions. Neglect minor losses. Vent | 4m 160mmø pipe Branch Line B A 1.75m Main Line 300m 200m ANSWER: a. h = 13.918m, b. h = 10.585m c. HL = 3.2479m