From the following differential leveling notes, compute the difference in elevation between stations 5 and 6.a. 2.62b. 1.61c. 3.51d. 1.87 Elev.23.6223.63524.66529.95532.04530.43526.725Sta.1B.S2.6355.156.523.61F.S2.624.121.231.526.127.1244.513.41

Data for the Differential leveling is given in the question

Answered: From the following differential…

From the following differential leveling notes, compute the difference in elevation between stations 5 and 6. a. 2.62 b. 1.61 c. 3.51 d. 1.87

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Complete the following level notes. Show your detailed solution and checking. Double Rodded…

A: Objective: To complete the given leveling observation table and perform the checks. Given:…

Q: stadia reduction table, what is the difference in elevation if the observed vertical angle is…

A: Vertical angle 19°24" Staff intercept =s Difference in election v

Q: From the given differential leveling notes, compute the difference in elevation between stations 5…

Q: Find the corected level for point (A) if you know that the true level of (A) is 30 m according to…

A: Given, FS = 1.365 m BS = 1.762 m True level of A = 30 m Correct level = ?

Q: Reduce the set of differential leveling notes in Table 2-11, and perform the arithmetic check.…

Q: finite element method (FEM) at AB? a. 141.67 kN-m b. 145.67 kN-m c. 155.67 kN-m d. 167.55 kN-m…

A: Anwer The fixed end moments of the beam are shown in the below image

Q: 1. Determine the reduced level of B. The level was set up at a point in the middle of A and B gives…

A: Levelling is the procedure of determining the height or elevation of the different point on the…

Q: A tilting level is used to run a set of precise levels to a construction project from benchmark DAM,…

A: BS IS FS HI RL 50 151.865 101.865 20 131.865 13.634 145.499 50 95.499…

Q: 1. DIFFERENTIAL LEVELING STATION BACK SIGHT HEIGHT OF INSTR. FORESIGHT ELEVATION BM 10 4.64 209.65 m…

Q: From the given Leveling Notes below, answer the following questions: What type of leveling is…

A: To find the Unknown Values from the leveling experiment values

Q: 10. Complete the following table using the knowledge obtained in class about differential leveling…

A: Given Data Total 5 stations has been given and we are asked to calculate the Elevations, adjusted…

Q: 1. Complete the following differential level notes for a double-rodded line from BM1 to BM2. Show…

A: 1. Complete the following differential level notes for a double-rodded line from BM1 to BM2.

Q: The following readings are taken from an Auto level from an uneven field. Find the Reduced Level of…

A: At point where instrument shifted that point it is FS. St.point BS IS FS HI RL REMARK 1 1.20…

Q: This type of leveling method is used when running a line of levels across wide rivers, lakes and in…

A: Reciprocal levelling is the method of levelling applied when an obstruction like a wide river or…

Q: BC (m) 8.26 FS (m) Elevation (m) 458.45 STATION 1 2.39 2.26 9.98 12.87 8.65 3. 11.36 5.32 45

A: To find the solution, I have used Rise and Fall method. Please refer the below mentioned table

Q: Reciprocal levelling is done to test a dumpy level, along a chain line, at a common interval of 25m,…

A: Given DatReduced Levels (RLs) at first station = 97.535 mReadings (BS, IS, FS) = 3.200, 2.135,…

Q: Two pegs 'P' and 'Q' were fixed on opposite banks of a river and the following measurements were…

A: Given- Two pegs P & Q fixed on opposite banks of a river- Measurement values- R.L of station P…

Q: 1. From the given data of differential leveling as shown in the tabulation. B.S FS. STA. ELEV. S87…

A: To find the unknown HI and elevation To find the elevation difference from station 7 and 4

Q: RL2=152.5 Q4). The following staff readings in meter were obtained when leveling along the center…

Q: The readings from a level instrument are booked from a survey along the line collimation method. If…

Q: A.) Determine the difference in elevation between TP1 and TP3

A: Profile leveling is used to determine the elevation of various locations along a line at a uniform…

Q: Which type of leveling is carried out to get the rough idea about the profile of the ground in a…

A: Fly levelling is used to get rough idea about the profile of ground in short time. In fly levelling,…

Q: 4. The slope distance (L1) measured between A and B is 28.533m. Determined the correction necessary…

A: Correction = True value - Measured value In given question , Horizontal equivalent = true value…

Q: From the given leveling notes, compute the elevation of BM2 ELEVATION OF BM1 IS EQUAL TO 149.20

A: Given:- Station BS HI FS Elevation BM1 0.57 TP1 1.15 2.93 TP2 0.65 2.70 TP3…

Q: From the given Leveling Notes below, answer the following questions: a. What type of leveling is…

A: When 2 or more turning points present in the levelling sheet then it is classified as differential…

Q: Reciprocal levelling is done to test a dumpy level, along a chain line, at a common interval of 15m,…

A: The readings from the dumpy level are given with 135m as the starting point with 15m intervals,…

Q: STA BM 1 2 TP 3 4 5 6 7 TP₂ 8 9 10 11 TP3 TP BS FS IFS 0.95 3 2.3 3.13 0.64 2.7 2.8 3.1 0.5 0.8 2.16…

Q: From the given Leveling Notes below, answer the following questions: a. b. C. d. STA BM1 1+100 1+120…

Q: 0.9 (IFS) 1.7 (IFS) 3.43 TP1 2.77 (BS) (FS) 2.32 (BS) BM1 EL. 328.70m 2.2 (IFS) BM2 2.45 3.7 (FS)…

A: Given question belongs to levelling topic. Here the back sight , intermediate fore sight and…

Q: Q3) leveling staff setup on a BM of elevation of 89.90 m is observed from point A where the three…

A: Given: Inst. at Staff point Staff reading (m) Vertical angle A BM 1.00,2.37,3.75 5o32' B…

Q: The distance between two points A and B measured along a slope was 270 m. Determine thehorizontal…

Q: UEBE1843 SITE SURVEYING Q1. A group of students conduct a practical on a sloped area, it was found…

Q: a = 30°22' hi - 4.72' 2 + 72.32 S= 82.18 ft Elevation = 361.29' Rod 4.00R.R.

A: Given data Elevation of instrument Staff readings Angle of depression To find R.L. of rod

Q: Engr. Madrid performed differential levelling between two benchmarks, she then set up a dumpy level…

A: To find Missing reading on turning point 2. Given Elevation of Benchmark 1 Elevation of Benchmark 2…

Q: then RL (in m) of R is

A: Given data. Rl of point R with respect to the bench mark at P.Staff reading is shown in graph…

Q: corrected level for point (A)

Q: DIFFERENTIAL LEVELING For the given differential level notes. Determine the station with the highest…

A: Differential Levelling

Q: What type of leveling is presente What station has the highest elevation? (Indicate the letter onl…

Concept explainers

Methods of Surveying

Surveying is the practice to determine the relative three-dimensional positions of various points on the earth’s surface. This is done by computing the vertical and horizontal distances, angles between the points, collecting the observations, and plotting them on a map of any appropriate scale. Accuracy can be achieved by using the latest instruments like a theodolite, tachometer, etc. Leveling is a subdivision of surveying where the objective is to locate the elevation of objects considering a datum level.

Question

From the following differential leveling notes, compute the difference in elevation between stations 5 and 6.

a. 2.62

b. 1.61

c. 3.51

d. 1.87

Elev.
23.62
23.635
24.665
29.955
32.045
30.435
26.725
Sta.
1
B.S
2.635
5.15
6.52
3.61
F.S
2.62
4.12
1.23
1.52
6.12
7.12
4
4.51
3.41

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Prepare a set of level notes for the data listed. Perform a check and adjust the mis- closure. Elevation of BM 7 is 852.045 m. If the total loop length is 1500 m, what order of leveling is represented? (Assume all readings are in meters.) +S (BS) -S (FS) Point 4.388 6.907 ВМ 7 TP1 4.538 as BM 8 4.680 8.800 TP2 3.730 5.978 5.245 3.598 ТРЗ 8.464 ВМ 7
Q2: The level is setup at 20 m from point A and 200 m from point B. The staff reading at point A is 2.3157, then the staff is putting in inverse situation on point B that lie on the lower surface of a bridge and the staff reading at point B is 3.6723. Find the difference in level between the two points taking into account the effect of curvature and refraction.
Given the following differential notes for a three-wire leveling from BM1 to BM2, compute for the elevation at BM2 and solve for the horizontal distance between TP1 and TP2. Assume stadia interval factor equal to 100 and instrument constant equal to zero. STATION BS МEAN HI FS МEAN ELEVATION 5.27 BM1 3.97 54.38 2.67 3.27 3.81 ТР1 2.01 2.55 0.75 1.3 3.18 8.52 ТР2 1.88 7.16 0.58 5.81 2.91 8.5 ТРЗ 1.515 7.13 0.325 5.77 3.68 8.29 ТР4 2.56 6.92 1.43 5.56 7.81 6.67 ТР5 6.49 5.15 5.16 3.63 4.25 BM2 2.7 1.16 О а. 44.78/654 O b. 41.24/523 O c. 40.35/533 O d. 40.06/512
2- using the method of differential levelling to establish the BM. A loop network was run counter-clockwise beginning and ending on BM whose known elevation is 689.36. 2.84 11.73' 5.64 7.23 O TP2 BM 689.36 8.59' 7.69 3.56' 8.02'
Planar Coordinates If the X and Y coordinates of A and the grid azimuth aAR are known and the horizontal distance DAB is determined , we can calculate the departure and latitude of AB , the X and Y coordinates of B as in following DAg x cosa N AB Ay AB x sina 48 AB Xg = x, + Ar Ys = yA + Ay AB AB
- In reciprocal leveling across a deep ravine the following sets of rod readings were taken: Instrument set-up near A : BS on A = 1.719m, FS on B = 2.578m Instrument set-up near B : BS on A = 1.335m, FS on B = 2.176m Point A has a known elevation of 197.428m. Determine the elevation of point B.
Answer with detailed solution
Given: L=2000 ft., G1 = +1%, G2 = -3%; What is the elevation difference from a point 8 stations back from the PT to the PT station?
From the given Leveling Notes below, answer the following questions: a. b. C. d. e. STA BM1 1+100 1+120 1+140 TP1 1+160 1+180 BM2 What type of leveling is presented? What station has the highest elevation? (Indicate the letter only corresponding to the station - use capital letter) What station has the lowest elevation? (Indicate the letter only corresponding to the station - use capital letter) What is the elevation (in meters - 3 decimal places) of the line of site when the FS was taken at TP1? (Do not include the unit) What is the elevation of BM2 (in meters - 3 decimal places)? (Do not include the unit) BS (m) 1.670 1.875 HI (m) FS (m) IFS (m) 1.257 || 1.350 1.230 1.450 0.975 1.250 1.670 ELEV (m) Remarks 108.750 A BCDEFGH с н
Situation A. Given the Levelling Notes: Sta. B.S. H.I. F.S. Elev. BM 1 1.21 50.00 ТР 1 ТР 2 ТР 3 ВМ 2 1. Determine the height of instrument between TP1 6.20 4.65 4.82 3.11 3.03 5.22 3.16 and TP2 2. Determine the elevation of TP 3. 3. Determine the elevation of BM 2.