1 For many purposes we can treat nitrogen (N) as an ideal gas at temperatures above its boiling peint of-196. "C.Suppose the temperature of a sample of nitrogen gas is raised from -21.0 C to 11.0 C, and at the samne time the pressure a changed. I the intul presurewas 0.80 kPa and the volume increased by 45.0%, what is the tinal pressure? Round your answer to 2 significant digtsDP

Given: Initial pressure = 0.80 kPa Initial temperature = -21°C Or initial…

For many purposes we can treat nitrogen (N.) as an ideal gas at temperatures above its boling peint of 196. "C. Suppose the temperature of a sample of nitrogen gas is raised from -21.0 °C to 11.0 C, and at the same time the pressure a changed. Ifthe intul presure was 0.80 kPa and the volume increased by 45.0%, what is the fnal pressure? Round your answer to 2 significant digits

For many purposes we can treat nitrogen (N.) as an ideal gas at temperatures above its boling peint of 196. "C. Suppose the temperature of a sample of nitrogen gas is raised from -21.0 °C to 11.0 C, and at the same time the pressure a changed. Ifthe intul presure was 0.80 kPa and the volume increased by 45.0%, what is the fnal pressure? Round your answer to 2 significant digits

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter5: Gases

Section: Chapter Questions

Problem 35Q

See similar textbooks

Similar questions

A typical barometric pressure in Redding. California, is about 750 mm Hg. Calculate this pressure in atm and kPa.
In the Mthode Champenoise, grape juice is fermented in a wine bottle to produce sparkling wine. The reaction is C6H12O6(aq)2C2H5OH(aq)+2CO2(g) Fermentation of 750. mL grape juice (density = 1.0 g/cm3) is allowed to take place in a bottle with a total volume of 825 mL until 12% by volume is ethanol (C2H5OH). Assuming that the CO2 is insoluble in H2O (actually, a wrong assumption), what would be the pressure of CO2 inside the wine bottle at 25C? (The density of ethanol is 0.79 g/cm3.)
A 36.0—L cylinder of a gas used for calibration of blood gas analyzers in medical laboratories contains 350 g CO2, 805 g 02, and 4,880 g N2. At 25 degrees C. what is the pressure in the cylinder in atmospheres?
5-107 If 60.0 g of NH3 occupies 35.1 L under a pressure of 77.2 in. Hg, what is the temperature of the gas, in °C?
You have a gas, one of the three known phosphorus-fluorine compounds (PF3, PF3, and P2F4). To find out which, you have decided to measure its molar mass. (a) First, yon determine that the density of the gas is 5.60 g/L at a pressure of 0.971 atm and a temperature of 18.2 C. Calculate the molar mass and identify the compound. (b) To check the results from part (a), you decide to measure the molar mass based on the relative rales of effusion of the unknown gas and CO2. You find that CO2 effuses at a rate of 0.050 mol/min, whereas the unknown phosphorus fluoride effuses at a rate of 0.028 mol/min. Calculate the molar mass of the unknown gas based on these results.
Nitrogen gas can be obtained by decomposing ammonium nitrate at high temperatures. The nitrogen gas is collected over water in a 500-mL (three significant figures) flask at 19C. The ambient pressure is 745 mm Hg. (Vapor pressure of water at 19C is 16.48 mm Hg.) (a) What is the partial pressure of nitrogen? (b) How many moles of water are there in the wet gas? (c) How many moles of dry gas are collected? (d) If 0.128 g of Ne are added to the flask at the same temperature, what is the partial pressure of neon in the flask? (e) What is the total pressure after Ne is added?
Xenon and fluorine will react to form binary compounds when a mixture of these two gases is heated to 400C in a nickel reaction vessel. A 100.0-mL nickel container is filled with xenon and fluorine, giving partial pressures of 1.24 atm and 10.10 atm, respectively, at a temperature of 25C. The reaction vessel is heated to 400C to cause a reaction to occur and then cooled to a temperature at which F2 is a gas and the xenon fluoride compound produced is a nonvolatile solid. The remaining F2 gas is transferred to another 100.0-mL nickel container, where the pressure of F2 at 25C is 7.62 atm. Assuming all of the xenon has reacted, what is the formula of the product?
What is the temperature of an 11.2-L sample of carbon monoxide, CO, at 744 torr if it occupies 13.3 L at 55 C and 74-4 torr?
he following demonstration takes place in a two-step process: rst, solid calcium carbide (CaC2j)reacts with liquid water to produce acetylene gas (C2H2)and aqueous calcium hydroxide. Second the acetylene gas produced is then ignited with a match, causing the combustion reaction of acetylene with oxygen gas to produce gaseous carbon dioxide and gaseous water. Write the balanced equations for each reaction that is occurring, including all phases. If a 100.0gsample of calcium carbide (CaC2)is initially reacted with 50.0gof water, which reactant is limiting? Now imagine that the final gases produced are collected in a large bulkier and allowed to cool to room temperature. Using the information from part b ( l00.0gof Cec2reacting with 50.0gof H2O), how many liters of carbon dioxide gas were produced in the balloon at a pressure of 1.00atm and 25C?
5-114 Carbon dioxide gas, saturated with water vapor, can be produced by the addition of aqueous acid to calcium carbonate based on the following balanced net ionic equation: (a) How many moles of wet CO (g), collected at 60.°C and 774 torr total pressure, are produced by the complete reaction of 10.0 g of CaCO3 with excess acid? (b) What volume does this wet CO2 occupy? (c) What volume would the CO2 occupy at 774 torr if a desiccant (a chemical drying agent) were added to remove the water? The vapor pressure of water at 60.°C is 149.4 mm Hg.
perform stoichiometric ca1cu1uions for reactions involving gases as reactants or products.