For a trapezoidal open channel, the total discharge is 28 m^3/sec, bed width 6.0 m, side slope 3H:1V, manning's coefficient 0.015, slope of the channel is 0.0005, find water depth, and type of flow. If the channel is replaced with a concrete pipe (n=0.012) and with the same slope of channel, determine the pine diameter for max velocity

For a trapezoidal open channel, the total discharge is 28 m^3/sec, bed width 6.0 m, side slope 3H:1V, manning's coefficient 0.015, slope of the channel is 0.0005, find water depth, and type of flow. If the channel is replaced with a concrete pipe (n=0.012) and with the same slope of channel, determine the pine diameter for max velocity

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Water Resources Engineering: Open Channel Flow A 3.7 meter wide rectangular channel with with a bed slope of 0.00019 and a depth of flow of 2.2 meters. Manning's roughness coefficient is 0.019. Find: a) Can Manning's equation be applied to this system (i.e. Is the flow fully turbulent)? b) Regardless to the answer to part a, determine the steady uniform discharge in the channel (i.e. the "normal depth")
Please answer with explanation Thanks
please help with hydrology problem. make sure it is correct, will thumbs up if correct.
A concrete lined channel is to be constructed. For concrete in this case take Manning’s n to be 0.014s/m1/3 The slope of the ground surface is 1 in 450. The design discharge is 8.5m3/s. The channel is to be designed with the optimum hydraulic section, but the exact dimensions and profile of the channel are yet to be determined. Calculate the optimum hydraulic section for a circular pipe with a depth of 0.90D Shape of section Area of flow Wetted perimeter Hydraulic Radius Surface Width Hydraulic mean depth Circle: depth of flow 0.90d 0.245πd2 0.856πd 0.286d 0.436d 0.562πd
The discharge in an open trapezoidal channel was measured by slope area method. Depth of water = 2.50m, Bottom width of channel 3.10m, Width of channel at the water surface = 5.10m. Determine the wetted perimeter. Select the correct response: 10.20m 7.25m 8.48m 9.10m
Pls correct and ASAP
A discharge of 1.2 m3/s flows on an open channel with a slope of 0.0062. If the coefficient of roughness is 0.0123, compute the depth of the channel for an optimum discharge for a triangular section. Select the correct response: 0.69 m 0.51 m 0.41 m 0.49 m
Question 4 The flow rate in a wide rectangular channel is 5.0m³/sec/m. The channel bed slope is 0.0035. The manning's coefficient is 0.016. The slope of channel is classified as-
Determine the normal depth in a triangular channel with bed slope of 0.0005, n = 0.013 and central angle of 90° if it carries a discharge of 2.2 m³s-¹.
1. Dikes are to be installed on both channel banks of the 1.2 km long river section. The river width is 60 m, and 50% of the river width should be secured for flow passage. Determine the number of dikes can be installed in this section. Use the Winkel's formula and the angle from the front of the dike to the bottom of the next dike is 10 degrees.
A rectangular channel Carrie's water to a depth of 1.8m. In order to measure the discharge, the channel width reduces to 2.4m and a hump of 0.3m height is provided in the bottom. Calculate the discharge if the water surface in the contracted section drops by 0.15m
An urban drainage consists of an underground pipe of diameter d=0.9m laid on a slope of 0.002 and discharges the flood discharge at a depth of 0.8d. If the Manning’s roughness coefficient of the pipe is n= 0.015, what is the magnitude of the flood discharge. Determine also: i) the normal depth flow ii) ) the critical depth corresponding to this flow iii) the Froude number of flow and iv) the type of flow