find the mass of water in every tank at the start. give the 2 properties that determines the ultimate state Determine the heat transfer required There are 2 rigid tanks stuffed with water. tank A is zero.2 m^3 at one hundred kPa, 150C and tank B

Q: pressure in the smaller pipe are provided. Determine the pressure after the expansion including the…

A: For pipe 1 Diameter D1 = 8cm = 0.08 m Velocity V1 = 10 m/s Pressure P1 = 410 kPa For pipe 2 Diameter…

Q: Which of the following whose values are  not depend on the transition of a system from the initial…

A: State functions are those functions whose values are not dependent on the transition path of the…

Q: Write all steps in paint making process.

A: Pigments, binders, and solvents are properly weighed, milled, and blended in the paint industry.…

Q: Water flows through a horizontal coil heated from outside. During its passage, it changes state from…

A: Inlet enthalpy (Hinlet) = 334.9 kJ/kgOutlet enthalpy (Houtlet) = 2726 kJ/kgInlet velocity (Vin) = 3…

Q: 1. Cold water is heated from 10 °C to 43.33 °C in the annular space of a double-pipe heat exchanger…

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want…

Q: Given: Plate thickness: 30 mm k = 45 W/m°C Uniform volumetric heat generation: q, = 25 MW/m3…

A: i) Let A be the cross-sectional area perpendicular to the direction of heat flow S (W/m3) is the…

Q: Air enters a diffuser at 102 KPa , 57 Celcius , and 285 m/s and exits at 303 KPa , 10 Celcius , and…

A: Let the inlet conditions be represented as ‘1’ and outlet conditions by ‘2’.   Given specifications…

Q: Write a process path for the heating and compressing of nitrogen. Include the state of the coumpound…

A: Given, Initial temperature, T1 = 293.15 K Initial pressure, P1 = 2×105 Pa Let the moles of the gas…

Q: In the heating mode a heat pump has a COP = 4.45. a) Determine the COP if the heat pump were…

A: Since you have posted a question with multiple sub-parts, we will solve the first three subparts for…

Q: Find the specific work done in a Rankine cycle if the steam supplied at 650 kPa and 0.9 dry and the…

A: The given parameters are:Pressure at which steam is supplied (P1) = 650 kPaDryness fraction (x) =…

Q: The expansion of a closed system occurs at a constant pressure, there is no change in their kinetic…

A:

Q: In regions where the temperature does not change much throughout the year, the surface water…

A: A power plant is to be designed, and the best suitable energy engine is required that could be used…

Q: Define C.O.P. of the simple vapor compression refrigeration cycle R-134a. The evaporation…

A: The equation for C.O.P of refrigerator is given by:- C.O.P=TCTH-TC---(1) Where, Tc (condenser…

Q: 2.6 A cylinder 10 m high, with a cross-sectional area of 0.1 m², has a mass-less piston at the…

A:

Q: A piston-cylinder device initially contains gas at 200 kPa. The system showed an expansion due to…

A:

Q: 5. Variable Heat Generation and Equation of Energy Change. A plane wall is insulated so that…

A: The plane wall is insulated and conduction occurs only in x direction The heat generation per unit…

Q: Which of the following is not an intensive

A: Intensive property is a thermodynamic property which does not depend on the amount of material in…

Q: a. Compute the Jakob number, Ja = 2,A b. The effective latent heat, li h(1+0.68Ja) (kJ/kg) c. The…

A: Given that  Temp,T1 =60 c Length = 2 m mass flow rate ,m =300 kg/hr hfg = 2257 kj/kg Cpj = 4.217…

Q: For a certain experiment, Freon-12 vapor is contained in a special glass tube at 30 C. It is desired…

A:

Q: 6. Hot water at 90°C heats air from a temperature of 0°C to 20°C in a parallel flow heat exchanger.…

A:

Q: An oil is being cooled in certain equipment. It was observed that a 7.94 bmin of hot oil enters a…

A: Given: The mass flow rate of oil and water entering the heat exchanger equipment is m* = 7.94 lb/min…

Q: Consider 2 kg of air has a decrease of internal energy of 25 kJ during a reversible non flow…

A:

Q: Initially, a piston device contains 0.55 m³ of saturated water vapor at 300 kPa and at this state,…

A:

Q: What is the log mean temperature difference in °C of a double pipe counterflow heat exchanger where…

A: The log mean temperature difference of counter current heat exchanger is given by:-…

Q: Consider the compression of air from 10³ Pa at 27°C to 3x 10° Pa in an ideal two stage compressor…

A:

Q: 02: How much thermal energy must be supplied by an electric immersion heater if you wish to raise…

A:

Q: 4. Two coaxial cylinders, r: = 3.5 cm, r2 = 8 cm, of equal length (3.5 m) are placed inside a very…

A: Given : Two coaxial cylinders radius r1=3.5cm r2=8cm Length of cylinders L=3.5 cm The inside…

Q: Two coaxial cylinders, r1 = 3.5 cm, r2 = 8cm, of equal length (3.5 m) are placed inside a very large…

A: Given: Two coaxial cylinders have radius equal to r1 = 3.5 cm = 0.035 m and r2 = 8 cm  = 0.08 m…

Q: Steam in a heating system flows through a 1-m long tube whose outer diameter is D1 = 3 cm andwhose…

A: Given: diameter D1 = 3 cm = 0.03 m Radius r1 = 1.5 cm = 0.015 m Circular fins (k = 46 W/m. °C) of…

Q: Prove that the dimensionless temperature through the Plane wall with heat generator is: T(X) - T(S)…

A: we need to determine the dimensionless temperature distribution in plane wall and prove the given…

Q: How do you comment on the amount of Qh that A and B give to the hot source

A: Solution This question solution is from thermodynamics step 1 Explanation - Both receive same Q1…