Find P₂ in the following pipe.

Q: 1. At time t = 0 a tank contains Q, Ib of salt dissolved in 100 gal of water. Assume that water…

A: We have given the problem

Q: A pitot tube is manometer as shown in figure find velocity of fluid at 'A' in (m/s). to find…

A: Given  Height, h = 20 cm                 = 0.2 m Gravity, g = 9.81 m/s2 Find   Velcoity, V

Q: At one point in a pipeline the water's speed is 3.00 m/sand the gauge pressure is 5.00×10^4 Pa a)…

A:

Q: is it correct?If this is correct, please help me to see the red line which has a question mark.…

A: For Velocity ratio:=0To determine:Velocity ratio for optimum performance of wind turbine.

Q: A brand of toothpaste is made using a mixture of white and red paste. During the manufacturing…

A:

Q: A vertical pipe is shown in figure 1 below. The pipe tapers from 50 mm in diameter to 25 mm in…

A: Given, Q=2 L/min=2×10-360 m3/s=3.333×10-5 m3/s d1=50 mmd2=25 mm hl=kv22-v122g z1-z2=1.5 m

Q: 53. Find the volume of the piece of tubing in the oil distribution line shown in the figure. All…

A:

Q: A piping system has a Y-configuration for separating the flow as shown in Figure 4. The diameter of…

A: Given data:

Q: The pressure at the suction of the pump reads 6 psi vacuum, while at the discharge is 43 psi. The…

A:

Q: A brand of toothpaste is made using a mixture of white and red paste. During the manufacturing…

A:

Q: if v=5s where s in meters finf a

A: Given:  v = 5 s where s in m

Q: B-In Oil Refineries the wastewater unit have flow rate 600 m3/hr. the oil have density 0.77gm/cc,…

A: Given:Volumetric Flow rate ,V.=600m3hrDensity of oil,ρo=0.77gcm3=0.77×10-3Kgm3Viscosity of…

Q: Internal energy is equal to heat addition at constant temperature constant pressure constant density…

A:

Q: A pipe AB branches in to two pipes C and D as shown in fig. The pipe has diameters of 0.45m at A,…

A: We have given DA=0.45mDB=0.3mDC=0.2mDD=0.15mVA=2 m/sVC=4m/s

Q: The diameter of the pipe at the larger end is 0.50 cm and at the smaller end is 0.20 cm, the larger…

A: Larger end: D1= 0.50 cmZ1= 7 mV1= 1.2 m/sP1= 5200 kN/m2 Smaller end: D2= 0.20 cmZ2= 3 m   To find:…

Q: if the velocity of a liquid is 1.65 ft / s in a 12-inch diameter conduit. What is the velocity in a…

A:

Q: The energy loss due to the immediate increase of pipe diameter a known as a minor loss. Select one:…

A: Given Data⇒ Energy loss due to the sudden increase of pipe diameter among fluid particals.

Q: The specific gravity of the 200ft^3 oil that weighs 10 520 lb is

A:

Q: If the velocity of a liquid is 1.65 ft/s in a 12-inch diameter pipe  What is the speed of a 3-inch…

A: The initial velocity v1=1.65 ft/s The initial diameter d1=12 in The final diameter d2=3 in

Q: Q1: If flow rate in pipe shown is (0.5m'/s) find the (H). H. water D=300 mm

A: Given data Volume flow rate = Q = 0.5 m3/sDiameter of pipe = 300 mm = 0.3 m

Q: What is the difference in potential energy per pound of mass of fluid at A and at B. STORAGE TANK…

A:

Q: Find the velocity of car Mass=2 kg K.E=40 J

A: Given data : Mass=m Kinetic energy=K.E   Required : Velocity of car

Q: | 3.00 cm 100. kPa 1.50 m .00 cm 4.00 m/s

A: For solution refer below images.

Q: A 12" pipe carrying 3.93 cfs connects to a 6" pipe. Find the velocity head in the 6" pipe.

A: Given: Discharge, Q=3.93 cfs (cubic feet per second) Diameter of pipe=6 inch

Q: Q1: Water is flowing from tank A to tank B as shown in the following figure. The flow is steady so…

A: To findFind out the distance..given Height, Diameter, diameter,

Q: The diameters of a pipe at the sections 1 and 2 are 0.1 m and 0.15 m respectively Find the discharge…

A: Given data⇒ Diameter of pipe at section 1 is d=0.1 m Diameter of pipe at section 2 is D=0.15 m…

Q: A fluid is being pumped through a pipe. The density of fluid is 872 kg/m³. The viscosity is 2.8x10²…

A: Given data: The density of the fluid is = 872 kg/m3 The viscosity of the fluid is = 2.8 x 10-2…

Q: On average, you inhale approximately 1 L of air every 2 seconds. The pressure difference between the…

A: Given:To find:

Q: The energy is transferred from the shaft to the water and from the impeller to the water. Select…

A: Correct option: False.

Q: 2. A perfect venturi with the throat diameter of 1.8 inches is placed horizontally in a pipe with a…

A:

Q: Water flows through a pipe that enlarges from 154 mm diameter at A to 249 mm diameter at B which is…

A:

Q: Water flows through a pipe as shown in Figure 1 at the rate of 80 L/s. If the pressure at Point 1 is…

A: Given that, Flow rate from the pipe, Q = 80 L/sec, Pressure at point 1, P1 = 180 kPa, Radius at…

Q: The product of velocity and mass of fluid particle is known as momentum. Select one: True False

A: We know  The product of velocity and mass of fluid particle or body is called momentum.…

Q: 1.Find the diameter of a pipe of length 3000 m when the rate of flow of water through the pipe is…

A:

Q: a. Calculate the distance AB. b. The section BC is to be drilled in the direction of the vector…

A:

Pressure Vessels

The term pressure vessel refers to a closed container that contains gas or liquid at a different pressure than environment pressure. The pressure vessels have a wide scale of applications in our day-to-day lives and other industrial places. Some common examples of pressure vessels are gas cylinders, autoclaves, compressor vessels, etc.