ExJA 20° straight-tooth bevel pinion having 14 teeth and a diametral pitch of 6 teeth/inch drives a 32-tooth gear. The two shafts are at right angles and in the same plane. The pinion is to transmit 1800 rpm and transmitting 50 hp. Find: a) the cone distance; b) the pitch cone angles; c) the pitch diameters; and d) the tooth loads of the pinion. Solution: (To be discuss during the lecture period)

ExJA 20° straight-tooth bevel pinion having 14 teeth and a diametral pitch of 6 teeth/inch drives a 32-tooth gear. The two shafts are at right angles and in the same plane. The pinion is to transmit 1800 rpm and transmitting 50 hp. Find: a) the cone distance; b) the pitch cone angles; c) the pitch diameters; and d) the tooth loads of the pinion. Solution: (To be discuss during the lecture period)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A steel spur pinion and gear have a diametral pitch of 13 teeth/in, milled teeth, 19 and 34 teeth, respectively, a 20- pressure angle, and a pinion speed of 540 rev/min. The tooth properties are Sut = 76 kpsi, Sy = 42 kpsi and the Brinell hardness is 149. For a design factor of 2.25, a face width of 7/ 8 in, what is the power rating of the gearset? Attach File Browse My Computer
A pair of gears with 14.5° full-depth teeth are to transmit 5 hp at 1800 rpm of the pinion; mw= 2.5; Np = 20 teeth; carefully cut teeth; intermittent service; Kf= 1.45. A. Determine the diametral pitch, B. face width, C. and tooth numbers if the pinionis to be made of phosphor gear bronze (SAE 65, Table AT 3
I need the answer quickly
Solve correctly please.
A spur pinion rotating at 20 rad/sec and having 20 teeth transmits 20 kW to a gear wheel. The pressure angle is 20° and module is 20mm. The reaction exerted by the pinion at the centre of thc shaft is
A spur gear reducer is to transmit 4 kW at 1500 rpm of the pinion of cast steel ( So=138 MPa). The gear is made from phosphor bronze (So=83 MPa). The velocity ratio is 3.5 to 1.0. Assume a pressure angle of 20°. Design the gears for strength only.
Draw a front section and profile for a worm and gear in an interlocking position according to the following data: 1- Center distance (center distance = 50 mm) 2- The outer diameter of the worm = 32 mm %3D 3- The step diameter of the worm = 26 mm 4- The root diameter of the worm = 20 mm 5- The width of the face = 22 mm 6- The length of the worm = 54 mm 7- The diameter of the worm shaft = 16 mm %3D 8- The length of the shaft Worm = 45 mm on each side 9- The diameter of the gear hole = 24 mm 10- The diameter of the hub = 42 mm 11- The width of the hub = 10 mm on one side 12- The type of key is the Gib With dimensions on the drawing