empting question 1 out of 12 For the same alternator, the ratio of rated KVA, when connected as 3-phase winding alternator to when connected as single phase alternator (by utilizing all the coils) is, (a) 1.33 (b) 0.50 (c) 0.67 (d) 1.50 Answer O A O D

empting question 1 out of 12 For the same alternator, the ratio of rated KVA, when connected as 3-phase winding alternator to when connected as single phase alternator (by utilizing all the coils) is, (a) 1.33 (b) 0.50 (c) 0.67 (d) 1.50 Answer O A O D

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 6. Transformers have the capability to step up or step down AC voltage True False

Q: In single phase power factor meter there is error due to frequency and waveforms but not in three…

A: It is given that:Why there is an error due to frequency and waveforms in the single-phase power…

Q: Loss of excitation is one of the stator faults of alternator which is operational at power station O…

A: 1)Loss of excitation is one of the fault on rotor. 2)Loss of excitation is a very common fault in…

Q: 4. A 3-phase 50 Hz star connected alternator has 180 conductors per phase and flux per pole is…

A: The objective of the question is to calculate the electromotive force (e.m.f) generated per phase…

Q: In two winding transformers, windings are electrically isolated and magnetically connected. Select…

A: Transformer works on the principle faradays laws of electromagnetic induction. Transformer consist…

Q: A load impedance of 52 ohms is connected to the secondary winding of the transformer with 208 volts.…

A: Using ohms law I=V/R Given voltage is 208 volts And impedance of 52 ohms

Q: In a single phase transformer, if the RMS value of emf is 240 V, then the average value is.

Q: A 400 v, 50 Hz, three phase alternators, rated at 75 kVA, is star connected and driven at 1000…

A: According to the question we have to find the smallest lagging power factor at which the alternator…

Q: For the same alternator the ratio of rated kva ,when connected as a three phase winding alternator…

A: For 3-phase operation of the alternator. Phase spread ψ=π3 So, Kd3ϕ=sinψ2ψ2=sinπ32π32=3π Let…

Q: What are the uses of three-phase transformers?

A: In this question, We need to determine the uses of three phase transformer. We know Three phase…

Q: A 400/200 volts transformer has pu impedance of 0.05. The HV side voltage required to circulate full…

A: Turns ratio 400/200 i.e. Base voltage for HV, VHV(base)= 400 V Base voltage for LV, VLV(base) = 200…

Q: A 400 V, 3-phase alternator is subjected to an unsymmetrical fault. The

A: Ia=Ia0+Ia1+Ia2Ia=-j10+j6+j4=0Therefore , it is Double line to ground fault Fault current is -…

Q: A three phase generator is operating at 1500rpm and has a no-load voltage of 7 kV. What would be the…

A: In this question, we need to choose the correct option.

Q: For the same alternator, the ratio of rated KVA, when connected as 3-phase winding to when connected…

A: Given three phase alternator is connected to single phase alternator by utilizing all the coils

Q: Why rating of an Alternator is expressed in terms of VA,KVA or MVA ? Option 1: As losses are square…

A: The Rating of alternator is expressed in terms of VA, KVA Or MVA because ______.

Q: 4- With the increase of the winding of a d.c. generator, terminal voltage wil c) Remain same a)…

A: (4) With the increase of winding of a dc generator, the armeture resistance of winding also…

Q: Connect three single-phase transformers in Y-Y, with subtractive polarity, so that the line-to-line…

A: Given: Connect three single-phase transformers in Y-Y, with subtractive polarity, so that the…

Q: A parallel connection of a RL branch with a C branch is connected across a 100V AC mains. At first R…

A: In RL parallel connection branch resistor and inductor are connected in parallel with each other and…

Q: Draw three transformers for each of the different three-phase connections. That is, draw three…

A: It has been asked to draw three transformers for each of the different three-phase connections.Means…

Q: Three phase alternators are invariably connected in star so as to a. Reduce the size of stator…

Q: A 3.phase, star.connected,50HZ alternatorhas 96 conductorsperphase and a flux/pole 0.1 Wb.The…

A: It is given that: Frequency=f=50 HzConductors per phase=Zph=96 Flux/pole=ϕ=0.1Xs=5 Ω/phRL=10…

Q: Eddy current losses can be reduced by making the core of a stack of plates electrically insulated…

Q: A star connected Alternator excitation voltage and terminal voltages per phase respectively are 180V…

A: Alternator: It is used to convert the mechanical energy to electrical power in the form of…

Q: In medium transformers, the total iron losses may vary from. rated output. % of the 0.4 to 1 O 0.2…

A: The iron loss of the transformer is defined as the sum of the hysteresis current loss, eddy current…

Q: circuit connection diagram on how to synchronize an alternator to the grid using lab volt. using…

A: The purpose of the synchronization is to ensure that during the circuit breaker closure (closing the…

Q: The winding data for three different alternators are as follows 1. 60 slots, four poles, span 1 to 9…

A: We will find the pitch factor in each case as shown below.

Q: a)Why are transformers generally connected in parallel at a substation? b)What conditions must be…

A: Transformers are generally connected in parallel at a substation to increase the overall power…

Q: - A3-phase, star-connected alternator is rated at 15000 kVA, 11 k V. The armature resistanc and…

A: The alternator is an electrical device used for the conversion of mechanical to electrical energy. A…

Q: If the core loss of single phase transformer at full load is 98 W, then the core loss at 25% of load…

A: In the transformer core losses independent of load. We can also say in the transformer core losses…

Q: 2A. What is another term for "shunt"? a) in series b) in parallel c) compounded d) none of the above…

Q: 3. Single-phase T1-transformer with a power of 500 kVA and a single-phase T2- with a power of 400…

A: Power factor: This tells how much active power is utilized by the circuit from the apparent power.

Q: Draw and explain the phasor diagram for two transformers in parallel.

A: Transformer connection in parallel : The parallel Operation of a Single Phase Transformer means…

Q: 2. What are the necessary conditions for successful operation of two single- phase transformers?

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: The distribution factor for 90 slots, 10-pole, 3-phase winding is A 0.90 B C D 0.895 0.959 0.978

A: Given: A 3-phase winding machine with, Slots = 90. Pole = 10.

Q: explain why Transformers are necessary in all stages of power distribution systems. Three-phase…

A: Given: Transformer: Transformer is a static device used for the transfer of varying voltage and…

Q: Q5/C: Compare between Auto transformers and 2 winding transformers.

A: The transformer is a static electrical device in which is used to step up/down the current and…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Step by step

Solved in 6 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

In small transformers, the total copper loss may vary from the rated output. % of O 0.2 to 0.6 O 0.5 to 1 O 0.8 to 1.5 O 0.4 to 1
Three single phase transformers each having a 240 V primary and two 250 V secondaries, as shown in the figure below, is to be connected to a 400 V, 3–phase supply to give a six phase output. A d e В f Show how this is done and find the voltage between adjacent phases of the 6-phase output.
For the same alternator the ratio of rated kva, when connected as a three phase winding alternator to when connected as a single phase alternator by using all the coils is
If a 3-phase short circuit occurs at the terminals of an alternator, the current in the armature circuit increases suddenly to a large value. Select one: True False
what are the advantages and Disadvantages Connecting transformers 3 Phase between (delta to Star)
Two three-phase alternators operate in parallel. The rating of one machine is 50 MW and that of the other is 100 MW. Both alternators are fitted with governors having a droop of 4 per cent. How will the machines share a common load of 100 MW ?
Why are alternators connected in parallel? What are the conditions for parallel connection? Explain.
Alternator A(100 kVA,3-phase, 240V,60HZ,1800 rpm) is operating with alternator B(125 kVa,3- phase,240 V,60 Hz,1800 rpm). The load of alternator A is 60kW at 90% pf lagging and the load of alternator B is 80kW at 70% lagging. Determine pf of load.
In the medium and large transformers, the total copper losses should be A2 % of the rated output. (a) 0.7 to 0.9 (b) 0.5 to 2 (c) 0.2 to 0.6 (d) 0.4 to 1 In DC machines, provides the magnetic path as well as the
Please solve d, e, f ONLY.
3- Determine the coil span for 3-phase, two pole alternator, the pole pitch is equal to 18 slots and the coil span factor is
A 9.9 kV, Y-connected, 3 phase alternator has a synchronous reactance of 8 ohms per phase and negligible resistance. At a certain field current the armature is known to induce 8.2 kV per phase. Calculate the power that can be developed by the alternator at this excitation.