Answered: Determine the second law efficiency of…

Name: Determine the second law efficiency of the heat engine operating betwe
Uploaded: 2022-11-30T03:40:23.000Z
Channel: Bartleby
Description: Determine the second law efficiency of the heat engine operating between“700” ºC and “30” ºC. The heat engine has efficiency of “40” %

Engineering

Mechanical Engineering

Determine the second law efficiency of the heat engine operating between “700” ºC and “30” ºC. The heat engine has efficiency of “40” %

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Heat transferred from the higher and lower temperature reservoirs are and , respectively. Select the coefficient of performance for a heat pump___________ A. 0.67 B. 0.5 C. 1.5 D. 2.0
A heat engine input heat 20 kJ and gives an output of 6000 J. Determine the thermal efficiency and rate of heat rejection. Select one: O a. 50% and 26 KJ O b. 30% and 14 KJ O C. 42.85% and 14 KJ O d. 30% and 26 KJ
None
Question 1: An air cooling system is to be used to cool a storage facility. The facility is to be maintained at 10°C at all times. It is estimated that the facility is absorbing heat at a rate of 100 MJ/hr when the outside temperature is 35°C. a. Draw the system that includes the facility and a cooling unit. b. Write the energy balance for the storage facility and determine Wnet, Qin and Qout- c. Under this condition, determine the minimum power required to drive the cooling system and calculate cooling capacity (ton of refrigeration) and SEER rating. d. What is an additional information that you need in order to calculate the actual power required? Give an example of calculation.
There is a steam power cycle that uses water as the working fluid, where the condenser pressure is 20 kPa. The pressure in the boiler is 4 MPa. The steam that comes out of the boiler is saturated steam and the quality at the outlet of the turbine is x4 = 0.65. The water enters the pump as a saturated liquid and exits at a temperature of 48 ° C (T2). Determine a) Work at the pump b) Heat transfer in theboiler c) work on the turbine d) The heat in the condenser e) The thermal efficiency of the cycle
1.3 An arbitrary heat engine is operating with the average heat addition and heat rejection temperatures Tin, and Tout,1 of 600 and 360 K, respectively. The thermal efficiency of the cycle should be increased by 25% (i) by increasing the heat addition temperature or (ii) by decreasing the heat rejec-
I need answer within 20 minutes please please with my best wishes
1) A geothermal facility operates at 1/3 of the Carnot efficiency. If the cold reservoirhas a temperature of 70°C, calculate and plot the efficiency of the facility as afunction of the geothermal fluid temperature from 100°C to 300°C. (remember toconvert to Kelvin!)1b) If a minimum efficiency of 5% is needed for this facility to be economicallyviable, what is the required minimum temperature of the geothermal fluid?
150W of energy is used to run a household refrigerator and 400W of heat is dissipated into the environment. a) Calculate the heat absorbed by the refrigerator. b) Calculate the COP value of the refrigerator
The following data for the R-12 refrigeration system as shown are as follows: Evaporator 1 0 OC 30 TOR Evaporator 2 -10OC 20 TOR Evaporator 3 -20OC 10 TOR Condenser 20OC Assume simple saturation and isentropic compression and determine the following: a) Draw the h-s diagram b) The refrigerant flow in each evaporator c) Total work of compression, WC in kW d) Heat rejected in the condenser, QR in kj/min e) Coefficient of performance