D: What is the capillary effect? What is its cause? How is it affected by the contact angle?

Q: Density and viscosity oleic acid at 20 degree celcius and 1 atm

A: Oleic acid is an mono-unsaturated long chain fatty acid which is generally found in liquid state at…

Q: Sometimes cos o cosa in Equation 7.2 is termed the Schmid factor. Determine the magnitude of the…

A: Given,

Q: Define the two types of stress waves ?

A: The two types of stress waves are to be defined.

Q: 5. Two immiscible fluids of equal density are flowing down a surface inclined at a 30° angle. The…

A: Two immiscible fluids 1-Lower layer 2-Upper layer ρ1=ρ2 θ=30° h1=h2=2.5mm 2ν1=ν2 ν1=2×10-4 m2/s…

Q: 16. What is the unit of resistance in SI? O w O W/K O m-K/W O W/m^2-K O K/W

A: Asked;  SI unit of resistance

Q: A 2 mm diameter glass tube is inserted into an open glass of water (contact angle between the tube…

A: Diameter of glass tube =  2 mmContact angle,  = 0

Q: 5. List the relations that control the connection of pipes in parallel, and explain the two types of…

A: Introduction: Pipe Flow: In fluid mechanics, pipe flow is a sort of liquid flow inside a closed…

Q: A B Rate of deformation, duldy Shear stress, 7

A: There are several properties defined for fluid such as density, specific gravity, viscosity, etc. In…

Q: In general, why should the operating pressure be high and the operating temperature be low for an…

A: The reason for the high pressure and low temperature for the absorption process is to be mentioned…

Q: Briefly explain the concept of steady state as it applies to diffusion

A: Diffusion is the process through which particles, molecules, or substances spread or travel from a…

Q: t types of ideal flow patterns in gas

A: Membranes are used in the mass transfer as a barrier in the separation processes. A membrane…

Q: What is the basic equation for computing the rate of mass transfer through a membrane?

A: Consider mass transfer through a membrane of area Am takes place from one container with…

Q: Cone has top and bottom diameters of 10 and 20 cm and a height of 10 cm. Calculate the shape factor…

A:

Q: If the shear stress profile of a fluid flows within laminar boundary layer is given by (1-) 21 U T =…

A:

Q: How is compressed gas released?

A: The compressed gases are hazardous while handling as the are stored under containers in very high…

Q: Explain flow rate in relation to fluid mechanics

A:

Q: Rate of movement of fluid passing one another. * O surface tension Shear O Rate of shear O Viscosity

A:

Q: 4- If the surface tension of water y, is 72.6 dynes/cm and of liquid, L, is 30.0 dynes/cm, and the…

A: Given  Surface tension of water=72.6 dynes/cm Surface tension of liquid=30 dynes/cm Interfacial…

Q: Why are Vertical flow-through beds preferred in RTO technology?

A: Regenerative Thermal oxidizers are used to remove air pollutants. The oxidizers will help in the…

Q: What is Outlet Gas Velocity in a cyclone seperator?

A: In mechanical operation, Cyclone separators are separation devices that use the principle of inertia…

Q: Liquid Properties a. Define (note: your definition must be based on the closed conduits/pipe flow):…

A: The definitions of all the terms are written below:

Q: on control, with no datum features, can be applied to two or more

A:

Q: Which of the following does not affect the rate of liquid flow on porous media A) Type of fluid B)…

A: according to Darcy's law where Q is flow rate K is Permeability is viscosity which is dependent on…

Q: irregular shape powder

A: A particle at most basic level can be defined as a discrete portion of any substance. Particles may…

Q: Consider a colloid particle whose dimensions are 50x30x10 µm. Calculate the surface to volume…

A: Given data: Dimension of colloid particle = 50 × 30 × 10 μm

Q: As shown in figure below, oil can be siphoned from a tank using a flexible hose, provided that the…

A: Taking point B as the reference plane that is height at B, hB = 0 Hence, Height at point A, hA =…

Q: Using a flow chart, show how a lubricant oil with high viscosity index can be manufactured from…

A: In petroleum industries, Crude oil is a type of fossil fuel that is a naturally occurring petroleum…

Q: Given a single particle with shape and dimensions as in the image below, compute for the (a) Volume…

A: Given, The radius of the base of the cone, r = 5 cm The height of the cone, h = 12 cm the slant…

Q: 1. Determine the maximum allowable vacuum that can be applied to a low-carbon-steel cylindrical…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 23. Show that in the limit of infinite dilution, the reduced viscosity and inherent viscosity are…

A: Reduced viscosity is defined as the ratio of specific viscosity to the concentration of the…

Q: QUESTION 7 Tube vibration analysis is not done in calculations.

A: Type of calculation in which tube analysis is not performed is asked.

Q: How is pump impeller size calculated

A: The two industrially used pumps are: Positive displacement (PD) pump and Centrifugal pumps. In a…

Q: Traces of solids are removed from, liquid in a a. Rotary vacuum filter b. Clarifier c. Classifier d.…

A: The correct option for the removal of the traces of the solid is to be chosen.

Q: What

A: The hydrosphere is combined mass of water on ,above and below surface of earth.

Q: What is the maximum radial distance traveled by any particle in cyclone seperator?

A: Chemical processes consist of the separation stages in which the process streams are separated and…

Q: A mirror produces an image that is located 41.0 cm behind the mirror, when the object is located…

A: Given : The image distance, Object distance,

Q: Please order the following apparatus in ASCENDING order of resolution; when comparing resolution,…

A: (1) Optical Microscope An optical microscope's highest resolution is about 0.2 microns (200 nm). The…

Q: What is the difference between permeability and permeance?How are they analogous to diffusivity and…

A: The difference between the permeability and the permeance is to be mentioned along with the relation…

Q: Derive the three laws of crushing from fundamental equation

A:

Q: The solution seems to be cut off to the right hand side. I cannot see it fully

A: The redlich Kwong equation of state is given by :where , R = The gas constant [= 0.518 kJ/(kg K)],T…

Q: What type of line corresponds to an f value of 0?   a horizontal   b leaning towards the left…

A: Generally the f line or q line represents the quality of feed.