Compute the pressure at point B

Q: 1) II) Find the depth D, in which the wood will be submerged. Is the wood cylinder stable? Show your…

A:

Q: Water flows through a 100 mm diameter pipe with a velocity of 0.015 m/s. If the kinematic viscosity…

A:

Q: Question 16 The pipe diameter is 800mm. The ultrasonic measurements recorded are: • Pipe centerline…

A:

Q: A closed tank contains 0.5 m thick layer of mercury (specific gravity = 13.6) at the bottom, A 2.0 m…

A: Given: A closed tank contains 0.5 m thick layer of mercury (specific gravity = 13.6) at the bottom,…

Q: How high will the water jet reach, under the conditions shown in the figure?  (WORK LIKE NEW PLEASE

A: Applied pressure=12*144 lb/ft2 Z1= 12/12=1 ft Z2=3.5ft

Q: Water from a reservoir flowing through a pipe having a diameter of 500 mm with a velocity of 2.75…

A:

Q: Find the total friction loss in 120 mm diameter G.I. pipe discharging 6 L/s in a total length of 350…

A:

Q: 6. Determine the hydraulic conductivity of a clay soil if the absolute permeability K = 0.4642 *…

A:

Q: 4. A welded cylindrical drum is made of steel plate. It has an internal diameter of 1.50 m and its…

A: Given Data Diameter of cylinder (d) = 1.5 m = 1500 mm  Thickness of wall (t) = 12 mm  Internal…

Q: A circular, downward water jet impacts a horizontal plate as shown in the figure below. The exit…

A: A vertical downward jet flow from the pipe impacts a plate kept at a certain distance. The velocity,…

Q: SIT G. Kkkj = 2 x10-4 H=3 m Kkk2 = 3 x102 cm/s H= 4 m Kkk3 = 4 x10“ cm/s H= 5 m a. Compute the…

A: Permeability is given

Q: where r, is the pipe radius. Calculate the shear stress (a) at the centerline, (b) at r = 0.25 cm,…

A:

Q: 5. According to the constant-head permeability test, calculate the hydraulic conductivity in cm/sec.…

A:

Q: A cylindrical tank of oil (sg 0.8) is 8m in diameter and 15mm thick. If the tank is to be completely…

A: D=8m t=15mm

Q: The pipe diameter is 800mm. The ultrasonic measurements recorded are: • Pipe centerline velocity =…

A:

Q: :-For the horizontal water pipe shown , find the change in diameter if the far and of pipe is : a)…

A: given data h= 85m   we have to determine the change in diameter

Q: Example ( 8) Steel tube shaft having length 3mm and diameter 50mm subjected to axial compressive…

A: there are some errors in question 1.the length of rod cant be 3mm , it is 3m ie 3000mm 2. the…

Q: 3m 9m W2 8m W1 6m

A:

Q: 3. Taking the coefficient of compressibility of water to be 2200 MPa, determine the pressure…

A:

Q: 1. The Dam ABC has a width of 30 m into the paper and the dam bottom length is 60m. The dam material…

A: We will calculate each moment and find FOS.

Q: (4) The cross section of a given column is shown in the figure, b.-24cm, x-2.02cm, the angle for the…

A: Solution: Design of lacing: Lacing provided at 45o to horizontal: Horizontal spacing = bo + 2xo =…

Q: Compute for the unknown pressure at A. = 90 cm; h2 = 150 cm; h3 = h4 =65 cm). Encode your answer…

A:

Q: differential manometer is attached to the two tanks, as shown. calculate the pressure difference…

A:

Q: Show step by step solution

A: When water flows downward, the shear stress on the boundary acts in the direction opposite to the…

Q: Example ( 8) Steel tube shaft having length 3mm and diameter 50mm subjected to axial compressive…

A:

Q: To measure a base line, a steel tape 30 m long, standardised at 15º C with a pull of 80 N was used.…

A:

Q: A hydraulic pipeline 3 km long and 50 cm in diameter is used to convey water with a velocity of 1.5…

A:

Q: Determine the absolute pressure at A in kPa. Oil, SG = 0.866. a = 26 cm., b = 37 cm., c = 48 cm. Use…

A: Atmospheric pressure, Patm =101.339KPa =101.339 KN/m2Specific gravity of oil, SGoil =0.866Specific…

Q: A 6cm diameter horizontal water pipe expands to a 10cm diameter pipe. The average velocity and…

A:

Q: Water at 10°C has a kinematic viscosity of 1.30 X 10-6 m2/s flows at the rate of 896.61 L/min from…

A: Given data  Height of liquid  Discharge  Outer diameter  Pipe roughness Temperature  Kinematic…

Q: As shown in the figure compute the amount and location of the vertical and horizontal components of…

A:

Q: For the same condition as the previous problem (After a solid block is put on a scale in the water…

A:

Q: Problem 8: EGL and HGL (IV) Consider a storage reservoir with a water surface elevation of 270 m. It…

A: At storage:At turbine:Head loss due to friction

Q: The pressure gage in the experimental setup shown below shows a pressure of 100 kPa. Determine the…

A: Given, γw=10 KN/m2 P=100 KPa

Field applications of hydraulic conductivity

Hydraulic conductivity is one of the hydraulic properties of soil defined as a measurement of the ability of a porous medium to permit water movement or fluid flow through it. It is denoted by the letter K. It is influenced by the density and viscosity of the fluid. It is also called permeability. Hydraulic conductivity is defined as the ratio of velocity to the hydraulic gradient. The different methods used to determine the hydraulic conductivity are laboratory methods (constant head permeability tests and falling head tests), in-situ field methods (pumping in and pumping out tests), small scale field tests (infiltration tests and slug tests), and indirect methods such as estimation from grain size, consolidation test data, and horizontal capillary test. The pedotransfer function (PTF) method is a specific empirical estimating approach employed in the soil sciences is also used to determine the hydraulic conductivity of the soil.