B): Find out the time required to irrigate a strip of area of 100*10 m by a stream of discharge of 0.05 m/s. Average depth of water to be applied may be assumed as as 10cm and the average rate of infiltration as 8cm/hour?

B): Find out the time required to irrigate a strip of area of 100*10 m by a stream of discharge of 0.05 m/s. Average depth of water to be applied may be assumed as as 10cm and the average rate of infiltration as 8cm/hour?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

8.16. Wastewater effluent is to be discharged through a diffuser 50 m long having 30 ports, each 0.125 m in diameter. The maximum flow rate will be 1 m³/s. The diffuser is set parallel to the beach because of an onshore current of 0.15 m/s. If the ocean floor slope is 1.5 percent, determine the length of the outfall necessary to provide a dilution factor of 200. Assume a wastewater density of 990 kg/m³ and a seawater density of 1020 kg/m³. (Courtesy of Jim Hunt.)
The discharge requirement to irrigate a strip of area 0.2 ha in 120 minute with the average depth of water in the field as 15 cm is m3/s. Take, infiltration rate as 8 cm/h.
Paragraph Problem 1: A pipe is laid horizontally and filled with soil, with its open end being saturated. With the given data, solve for its infiltration in 36mins if the soil column had been initially placed upright with its upper surface saturated. Area of the pipe's cross section = 212.6cm2 Infiltrated by 2126cm? of water after 26mins Hydraulic conductivity is 0.001cm/s (Final answer should be in 4 decimal places.) Problem 2: With the given data, solve for the infiltration rate and cumulative infiltration after 360mins on a sandy clay soil. Assume water is ponded to a small but negligible depth on the surface. Moisture Content of the soil = 34.5% Residual Moisture Content of the soil = 26% (Final answers should be in 4 decimal places.) The table will be provided in page 2 Problem 3: Using the data from Problem 2. What is its ponding time if: a) Intensity of rainfall is 0.000126cm/s. b) Intensity of rainfall is 5.8344cm/d. (Final answers should be in 4 decimal places.) Problem 4:…
Compute for the discharge at the outlet of canal to drain a waterlogged area of 100 ha. Drainage coefficient (rate at which water is drained from the field per day) is 10 mm. Ans. 115.7 lps.
Question- A water pump is installed on a well to lift water and to irrigate wheat crop, sown over 4 hectares of land. The duty for wheat is 1728 hectares / cumecs on the field and pump efficiency is 46%. If the lowest water level is 8 metres below the highest portion of the field and assuming negligible field channel losses, find the minimum required input (HP) of the pump.
Ex 12-6: agricultural land subjected to heavy rainfall of 10 days duration which caused groundwater recharge of 3mm/day. This water was drained by perforated pipes 20cm diameter laid at 2m depth below soil surface. If the depth of impervious layer 8m .find the spacing of drains to maintain the permissible groundwater table 1.5 m below soil surface. The hydraulic conductivity 0.5 m/day. Use any available equations (Hooghoudt Kirkham and Dagan)
Design the pipe that will connect two reservoirs for a water distribution system of a certain sitio. It was found out that the water source can sustain the water demand of the place for the next 25 years. Data: Elev. Of Reservoir A = 1050 m Elev. Of Reservoir B = 1000 m Total length of pipe (corrugated G.I.) = 2.5 km Current Population = 150 Design Period = 25 years Annual Population Growth Rate = 2.5% Per Capita Water Consumption (PCWC) = 100 liters/person-day You may use any method that is most suitable for the problem. (PLEASE INCLUDE COMPLETE SOLUTION AND DRAWING)
The details of a new developed area are given below: Premise Details Houses 2,000 units 2 hotels, 100 rooms/hotel (area = 1,200 m?) 1 hospital, 300 beds (arca = 3,000 m2) 2 terminals, 16 bays/terminal 1 mall, 5,000 customer/day (floor area = 2,500 m²) Hotel Hospital Bus terminal Shopping mall (3 levels) a. Estimate the average and peak water consumption of the area. b. If the STP was then designed suitable for 150% of the PE, how many houses can be added? 3.
PLease help
The water need of a district with a future population of 38800 and average daily water consumption qort = 189 lt / N / day will be met by leakage pipes fed double-sided (at the end of the collection box). Water layer thickness H = 5 m, k = 0.0018 m / s and n = 0.02 are given. Standard pipe diameters and costs are given as follows: 0.4 m (60 TL / m), 0.7 m (70 TL / m), 1.0 m (80 TL / m) and 1.3 m (85 TL / m). Size the leaking tube so that it is most economical (diameter, length and slope). Average flow velocity is between 0.2-0.4 m / s.
Assume that the ESP of Problem 5.1 is built with an actual collection area of 5400 m2, Now suppose that the actual drift velocity turns out to be 5,0 cm/s and the actual gas flow turns out to he 5500 m3/mtn, Calculate the actual efficiency, 5.1 A 98% efficient ESP is to treat a gas stream flowing at 5000 m3/ min. If the effective drift velocity is 6.0 cmf% calculate (a) the plate area {required and actual) in m2, and (b) the number of plates if each plate is 6 m hy 10 m, and there are 3 mechanical fields.
I need answer. Please avoid handwritten solution