a. A vane shear test was conducted in a saturated clay. The height and diameter of the rectangular vane were 4 in. and 2 in., respectively. During the test, the maximum torque applied was 230 lb-in. Determine the undrained shear strength of the clay. b. The clay soil described in part (a) has a liquid limit of 58 and a plastic limit of 29. What would be the corrected undrained shear strength of the clay for design purposes? Use Bjerrum's relationship for A [Eq. (3.40a)]. Cu(field) OCR = B σο (3.42) 1 (3.45) 0.08 + 0.0055(PI)

a. A vane shear test was conducted in a saturated clay. The height and diameter of the rectangular vane were 4 in. and 2 in., respectively. During the test, the maximum torque applied was 230 lb-in. Determine the undrained shear strength of the clay. b. The clay soil described in part (a) has a liquid limit of 58 and a plastic limit of 29. What would be the corrected undrained shear strength of the clay for design purposes? Use Bjerrum's relationship for A [Eq. (3.40a)]. Cu(field) OCR = B σο (3.42) 1 (3.45) 0.08 + 0.0055(PI)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Given the soil profile below, estimate the consolidation coefficient of the clay if Ao_z = 500 psf at the middle of the clay. Use one layer for the clay in your calculation. он 10 ft 20 ft וד Incompressible Sand' V Clay sat = 120 pct CR = 0.3 TIT RR = 0.15 Pp = 1776 pst 8 Sat 120 pct
A huge marble boulder on a quarry site sits on the ground. This marble is 10 m by 10 m and has a height of 16 m. The boulder is situated on a 6 m thick soil with e = 0.70, S = 65%, and G, = 2.68, then by a 5 m thick clay with e = 0.80, G, = 2.71 and LL = 48. The water table exists in between the sand-clay interface. The specific gravity of the marble is 2.60. Assuming that the clay is normally consolidated... Q: What is the primary consolidation settlement of the clay layer in mm using approximate method? Round off your answer to the nearest whole number.
1. A soil profile is shown in the figure. A uniformly distributed load of 75kPa is applied at the ground surface. The clay is normally consolidated. Compute the compression index Compute the primary consilidation settlement
2.2 A consolidated-drained triaxial test was conducted on a normally consolidated clay. The results are: 03=140 kN/m? (Aga) f=104KN/m2 Please determine oi and 3.
Q2: Available field data indicate that the permeahility for the clay is varies with depth. For layer 1: ku = 3.2 x 10 cmis; k = 1.1 x 10 cmis. For layer 2: kg - 1.7 x 10 em's; ka - 3.4 x 10" cm/s. For layer 3: kg - 1.4 x 10 cmis; ka - 44 x 10* cm/s. Compute the equivalent permeability for flow parullel and perpendicular to the clay layers shuwn in Fig.2. Layr 1 L 2 Layer a Fig.2 180 m
A settling basin is designed with a loading rate of 25 m³ /m².day. The depth of 0.997, the basin is 2 m deep. If the specific gravity of the particles is 1.2 and water = and u= 1.027. Determine the overall removal obtained for a suspension for data are shown below. Time (min) Concentration (ppm) 80 100 180 168 0 60 189 300 130 156 420 27 240 200 111 78
Need asap pls. Thanks.
For a silty clay soil given LL = 43 and PL = 18. Estimate the maximum dry unitweight of compaction that can be achieved by conducting a modified Proctor test. Use Eq attached.
Refer to Figure below. Estimate the primary consolidation settlement in the clay layer. Given: Δσ = 150 kN/m2; H1 = 3 m; H2 = 4 m; and H3= 5 m. Soil characteristics are as follows: • Sand: γdry = 15 kN/m3, γsat = 19 kN/m3 • Clay: LL = 65; e = 0.65; γsat = 18 kN/m3; ; Cs =1/6cc σʹc = 200 kN/m2
the soil profil shwon in figure BI below.determine total and effective vertical stresses and powr water Pressure at Points A, B, and C. For the soil 3m 4m 6m I Sand A5=2167 €=0.69 B C w=9% Silt Gs =2170 = 2₁70 e=0.60 clay = 2.72 @= 0.5 G₁ 5 = 70%
A soil formation is composed of 5 m thick clay and 5 m thick sand being the sand above the clay. The ground water table (GWT) is located at 2 m below the ground surface. 40 kPa 2 m Sand Ydry = 17.66 kN/m^3 VGWT Sand 3 m Y sat = 20.93 kN/m^3 LI = 64% PL = 20% w = 40% 5 m Clay eo = 0.60 G. = 2.60 1. Calculate the primary compression index. [ Select ] 2. Calculate the primary consolidation settlement of the normally consolidated clay layer if there is a surcharge of 40 kPa acting on the ground surface. [ Select] 3. Calculate the secondary settlement of the clay layer 5 years after the completion of the primary consolidation settlement. Time for completion of primary settlement is 2 years. Use C, = 0.02. [Select ]