A single drum drier, operating at atmospheric pressure, is being used to dry a wet slurry, containing 2.0 kg water per kg dry solids, to a final moisture content of 0.1 kg water per kg dry solids. The drum is heated internally with saturated steam at 500 kN/m², has a diameter and width of 0.5 m. The load factor on the drum is 0.05 kg/m² of dry solids. The product is removed from the drum at a point 2/3 of the circumference from the feed point. Calculate the speed of rotation of the drum in r.p.m. and the rate at which dry product is produced in kg/h. The overall heat transfer coefficient for the complete drying cycle is 850 kJ/m² h °C.

A single drum drier, operating at atmospheric pressure, is being used to dry a wet slurry, containing 2.0 kg water per kg dry solids, to a final moisture content of 0.1 kg water per kg dry solids. The drum is heated internally with saturated steam at 500 kN/m², has a diameter and width of 0.5 m. The load factor on the drum is 0.05 kg/m² of dry solids. The product is removed from the drum at a point 2/3 of the circumference from the feed point. Calculate the speed of rotation of the drum in r.p.m. and the rate at which dry product is produced in kg/h. The overall heat transfer coefficient for the complete drying cycle is 850 kJ/m² h °C.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Please answer asap.. I will rate helpful thankyou
Is induced draft cooling tower a type of evaporative cooling tower? Subject : Heat Transfer
The sensible heat-transfer coefficient for a dry surface has been determined to be 50 W/(m2-C) at a certain Reynolds number. Estimate the total heat transfer to the surface per unit area at a location where the wall temperature is 10 C and the state of the moist air flowing over the surface is given by 24 C dry bulb and 18 C wet bulb. Assume that the Reynolds number does not change and the Lewis number is 0.82. Assume that the condensate present on the surface will increase the transfer coefficients by about 15 percent.
A 5.092 m3 rigid tank contains 100 Kg of saturated water vapour, What is the temperature of this water? If the tank is now cooled to 200 °C, what is the new dryness fraction?
Winter air is heated & humidified thru steam heated coil and humidified using water sprayer. Air is flowing at a rate of 750 cubic meter per minute. Winter air is initially at 10 C dry bulb and 90 % RH. The final condition of air after the process is 30 C dry bulb & 60 % RH. Consider normal atmospheric pressure. Determine: rate of saturated steam injected in the sprayer per second with steam temperature of 30 C (INCLUDE THE PYCHROMETRIC CHART PLS)
I need help. Please answer this ASAP. Thank you!
Can you assist me with the HW problem.
An auditorium to be air-conditioned for the following conditions, Outdoor dry-bulb temperature 40 °C Outdoor wet-bulb temperature 20°C Expected comfort condition 20 DBT 60%RH Seating capacity of the auditorium 1500 persons Air supplied from outdoor 0.3 m¥min per person fthe required condition is achieved first by adiabatic humidification and then by cooling, determine () the capacity of the cooling coil in tonnes and (i) the capacity of humidifier in kg/h.
The sensible heat-transfer coefficient for a dry surface has been determined to be 50 W/(m2-C) at a certain Reynolds number. Estimate the total heat transfer to the surface per unit area at a location where the wall temperature is 10 C and the state of the moist air flowing over the surface is given by 24 C dry bulb and 18 C wet bulb. Assume that the Reynolds number does not change and the Lewis number is 0.82. Assume that the condensate present on the surface will increase the transfer coefficients by about 15 percent
Determine the enthalpy of steam at 127 degrees celsius, at 80% quality, and flowing at the rate of 80kg/h, if it is used to heat fluid soup. What is the volume in m3 of steam required per hour of operation?
Air at a dry bulb temperature of 40℃ and a wet bulb temperature of 20℃ is first heated in a heater to a dry bulb temperature of 90℃. Then it is passed through a bed of apricot slices to dry them. The air exiting from the top of the apricot bed is at a dry bulb temperature of 60℃. Clearly show the various paths of the process on a psychrometric chart! Determine the amount of moisture removed, in grams of water/second from the apricot bed!
What is the equivalent evaporation of the boiler? Determine the specific heat capacity of the delivered steam