A signal xi(t) is band-limited to 4.5 kHz and the three other signals x2(t), x3(t), and x4(t) are band-limited to 1.5 kHz each. Assume these signals are transmitted by TDM. A. Set up a scheme TDM for realizing this multiplexing requirement with each signal sampled at the Nyquist rate. B. Identify the required speed of the commutator in samples/sec. C. Identify the minimum bandwidth requirement of the channel.

A signal xi(t) is band-limited to 4.5 kHz and the three other signals x2(t), x3(t), and x4(t) are band-limited to 1.5 kHz each. Assume these signals are transmitted by TDM. A. Set up a scheme TDM for realizing this multiplexing requirement with each signal sampled at the Nyquist rate. B. Identify the required speed of the commutator in samples/sec. C. Identify the minimum bandwidth requirement of the channel.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

What is meant by the envelope of the AM signal? How can it be described mathematically? M SUVA
Digital signal process subject , need quick amd correctly
4. The information in an analog voltage waveform is to be transmitted over a PCM system with a F 0.2% accuracy (full scale). The analog waveform has a bandwidth of 200 Hz, and an amplitude range of -5 to +5 V. determine the following: - The minimum sampling rate needed. - The number of bits needed in each PCM word. - The minimum bit rate in the PCM signal. - The minimum channel bandwidth for transmission of this PCM signal.
[Q2] Answer the following: (a) Explain the effect of the value of u on the modulation quality of AM-DSB-LC. (b) Explain the frequency conversion of the carrier.
An analog television signal containing frequencies up to 4.5MHz is to be coded by an ADC. The sampling frequency is 20% above the Nyquist rate. If there are 1024 quantizing levels, determine the rate of transmission.
QAM is a combination of ASK and FSK. Select the correct response: True False
4. What do you mean by over modulation?
7) Suppose we have a message signal that is a sinusoid and we quantize it using a quantizer of L levels. Assuming that the quantization error for each sample is uniformly distributed in the interval , determine the signal to quantization noise ratio (SNR) in terms of L. Determine the SNR in terms of L if the message is changed to a triangular wave, again assuming that the errors are uniformly distributed.
q14- Direct sequence spread spectrum (DSSS) system spreads the baseband signal by ________ the baseband pulses with a pseudo noise sequence Select one: a. Addition b. None c. Dividing d. Subtracting
Digital signal process subject , need quick amd correctly
For single sideband (SSB) modulation d) Explain with drawing the demodulation process of SSB signal.e) How many single sideband (SSB) stations can be accommodated in a 180 KHz bandwidth if the highest modulating signal frequency fmax is 9 KHz?f) What are the main advantages and disadvantages of single sideband (SSB) modulation compared with ordinary amplitude modulation (AM).
C- Put TRUE or FALSE for only TWO of the following and say why: 1. PCM modulation is very complex technique compared to DM. 2. Envelope detection for PSK signal is possible via using DPSK. 3. A frequency reuse factor can be reached to "1" as a maximum value.