A mixture of gaseous reactants is put into a cylinder, where a chemical reaction turns them into gaseous products. The cylinder has a piston that moves in or out, as necessary, to keep a constant pressure on the mixture of 1 atm. The cylinder is also submerged in a large insulated water bath. (See sketch at right.) 1 atm pressure piston cylinder From previous experiments, this chemical reaction is known to absorb 185. kJ of energy. water bath gases The position of the piston is monitored, and it is determined from this data that the system does 397. kJ of work on the piston during the reaction. O exothermic Is the reaction exothermic or endothermic? O endothermic O up ? Does the temperature of the water bath go up or down? O down O neither

A mixture of gaseous reactants is put into a cylinder, where a chemical reaction turns them into gaseous products. The cylinder has a piston that moves in or out, as necessary, to keep a constant pressure on the mixture of 1 atm. The cylinder is also submerged in a large insulated water bath. (See sketch at right.) 1 atm pressure piston cylinder From previous experiments, this chemical reaction is known to absorb 185. kJ of energy. water bath gases The position of the piston is monitored, and it is determined from this data that the system does 397. kJ of work on the piston during the reaction. O exothermic Is the reaction exothermic or endothermic? O endothermic O up ? Does the temperature of the water bath go up or down? O down O neither

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

You may also assume X behaves as an ideal gas in the vapor phase. Suppose a small sample of X at 50 °C is put into an evacuated flask and heated at a constant rate until 10.0 kJ/mol of heat has been added to the sample. Graph the temperature of the sample that would be observed during this experiment. temperature (°C) 150- 140- 130- 120- 110- 100 90 80- 70- 60 50 0 heat added (kJ/mol) 10. X
Ammonia burns in air as follows:NH3(g) + O2(g) → N2(g) + H2O(g) (unbalanced)If x liters of N2(g) are formed by burning 9.8 L of ammonia and 9.8 L of oxygen with all species at the same temperature and pressure, what is the value of x?
Most of the sulfur used in the United States is chemically synthesized from hydrogen sulfide gas recovered from natural gas wells. In the first step of this synthesis, called the Claus process, hydrogen sulfide gas is reacted with dioxygen gas to produce gaseous sulfur dioxide and water. Suppose a chemical engineer studying a new catalyst for the Claus reaction finds that 592. liters per second of dioxygen are consumed when the reaction is run at 195. °℃ and the dioxygen is supplied at 0.48 atm. Calculate the rate at which sulfur dioxide is being produced. Give your answer in kilograms per second. Be sure your answer has the correct number of significant digits.
Every day a certain amount of water evaporates from Earth’s oceans, lakes, and land surface and forms water vapor and clouds in the atmosphere. Every day a certain amount of rain falls back to Earth. Make the reasonable assumption that, on average, the energy absorbed by the evaporation and lifting of the water is equal to the energy released by its condensation and falling back to earth. The evaporation of one mole of water requires approximately 40.6×103 J of heat. An equal amount of heat is released when a mole of water condenses. The annual volume of rainfall on Earth is approximately 4.9×105 km3 and the average cloud altitude is 8.9 km above Earth’s surface. How much energy, in joules, is required every day to evaporate and lift the water?
What amount of heat is required to convert 10.9 g of an unknown liquid (MM 83.21 g/mol) at 19.2°C to a gas at 93.5 °C? (heat capacity of iquid 1.58 J/g.C; heat capacity of gas 0.932 JIg.°C; AHvap 22.5kJ/mol, Tb= 57.3°C) kJ
Assuming that the natural gas used in a lab is pure methane, CH4, write a balanced chemical equation for the reaction of natural gas with each of the copper oxides, (Red copper oxide Cu2O, and Black copper oxide, CuO). Assume the products for both reactions are copper metal, water vapor, and carbon dioxide gas. Include all phases in the reactions.
Essential oils are concentrated liquid containing metabolites extracted from plant sources and are widely used in the production of perfumes. Most of these substances are soluble in organic solvents, such as acetone. The structures of some of these compounds present in essential oils are presented below. نلود H LIQUID A MW: 132.16 g/mol H Н' H H H- C- H -H H H LIQUID C MW: 136.23 g/mol H- H H H- LIQUID B MW: 164.20 g/mol H HH H acetone MW: 58.08 g/mol H Possible vapor pressure values: 0.0221 mm Hg, 0.0750 mm Hg, 1.689 mm Hg, 225 mm Hg A. Given the molar mass and molecular structures of the compounds, determine their most possible vapor pressure for each substance. B. For each pair of liquids, identify which of them has the indicated physical property.
1a. Calculate the pressure of a sample of 1 mole of argon gas in a 0.1500 L flask at -10.2 ℃ using the ideal gas law and the Van der Waals equation. The a value for argon is 1.34 (L 2 ∙ atm/mol2 ) and the b value is 0.0322 (L/mol). Show all work Ideal pressure= ? real pressure =? 1b.Why is there a difference in the real gas pressure and the ideal pressure? Explain what assumption(s) of the kinetic molecular theory of gases break down under these conditions.
An electric heater supplies 43.3 joules of energy to 27.3-g sample of H2 gas originally at 27.6 °C. Compute the final temperature (in °C). i °C
7. When detern ing the mass of a liquid, ras in a hurry and did not allow enough time for the temperature of the flask to reach the temperature of the boiling water bath. The student recorded the temperature of the gas as 100.0°C when it was only 80.0°C, Is the molar mass calculated by the student higher or lower than the accepted molar mass, or does this error have no effect on the calculated result? Briefly explain your answer # 2/HB Office DEPOTS b) If the student assumed the volume of the flask was 125 mL (as marked by the side of the flask) rather than measuring the volume experimentally, would the unknown's calculated molar mass be too high, too low, or unaffected? Explain. # 2/HB 4
1. A 1.0L flask contains equal amounts of O2 and CO2 at 25°C. a. Which molecules have the greater average speed or are they the same? b. Which molecules have the greater average kinetic energy or are they the same?
Ancient Romans built often out of bricks and mortar. A key ingredient in their mortar was quicklime (calcium oxide), which they produced by roasting limestone (calcium carbonate). 1. Write a balanced chemical equation, including physical state symbols, for the decomposition of solid calcium carbonate (CaCO2) into solid calcium oxide and gaseous carbon dioxide. C 2. Suppose 86.0 L of carbon dioxide gas are produced by this reaction, at a temperature of 260.0 °C and pressure of exactly 1 atm. Calculate the mass of calcium carbonate that must have reacted. Round your answer to 3 significant digits.