A hydraulic jump occurs in a trapezoidal channel with side slope of 1V:2H and base width of 3.8m. If the upstream depth is 1.1m and the downstream depth is 2.2m a) Compute for the discharge (m/s) b) Compute for the power (hp) lost in the jump a) Discharge b) Power Lost

Q: A liquid having specific gravity of 2.0 is flowing in a 50mm diameter piper. The total head at a…

A: step 1-

Q: Background: Water towers are elevated water storage construction that are built at a certain height…

A:

Q: 16. A stone is dropped into a deep well and is heard to hit the water 3.41 s after being dropped.…

A:

Q: A cantilever beam of 1.5 m span is loaded as shown in Fig. Draw the shear force and bending moment…

A: We have to find Bending moment of cantilever beam and Draw shear force and bending moment diagram.

Q: An sewer pipe (n=0.015) is designed to carry a flowrate of 83.5 cfs when the pipe flows 0.90 full.…

A:

Q: ▼ Pump GND GWT ▼ Tank

A:

Q: Instruction: Evaluate and find all the requirements with proper, neat, and readable handwriting…

A:

Q: Calculate the pressure at B.

A:

Q: Discuss water hammer and its effect in pipes. What are the major functions of surge tanks?

A:

Q: Illustrate and explain the steps involve in centering bubble with four leveling screws. Answer in…

A: Leveling: The order to determine the altitude of one level in response to others is known as…

Q: V2/2g (cm) Device V t(s) Q Vel hL(cm) hF(cm) f favg Kavg hm (cm) (cm3) (cm3/s) (cm/s) " Diameter…

A: Q = Volume/timeVelocity = QA Assuming the head loss isdue to friction loss onlyso Hf =HLHead loss…

Q: Support straps are used for this duct. Each support strap is made from twopieces of metal each 213⁄8…

A: Support straps: Support straps are used for supporting other materials. It is made up of various…

Q: What diameter (to the nearest inch) of new cast-iron pipe 1 mile long is required to discharge 4.4…

A:

Q: Urgent Hello please answer this problem as soon as possible. Topic is 'Fluid flow measurement' in…

A: Given data- Diameter of orifice d1 =75 mm = 0.075 mOrifice discharge Q = 23.41…

Q: A reducing elbow deflects the water upwards at angle of 45 degree and discharge it to the atmosphere…

A:

Q: Enumerate all types of valves used in a plumbing System. Define and list all its uses for each type

A: Types of Valves- 1) Sluice valve 2) Air Relief valve 3) Air Inlet valve  4) Check valve/ Reflux…

Q: ich has a specific gravity of cm. The meter is mercury specific gravity is flow rate at entrance…

A:

Q: Estimate the height to which water will rise in a capillary tube of diameter 4mm of the surface…

A: Given data in question  Surface tension Diameter  Water Angle of contact To find out  Height of…

Q: Define Hydraulics. Briefly explain minor head losses in pipes.

A: Hydraulics is the science of conveying the motion or force of the liquid and the liquid is confined.…

Q: PERFORM PRESSURE TEST ON POTABLE WATER PIPELINE?.

A: PRESSURE TEST ON POTABLE WATER PIPELINE 1.SUPPLY PRESSURE: The pipelines usually have small…

Q: 1. Water flows through a 12 inches by 6 inches venturi meter at the rate of 1.49 ft/s and the…

A:

Q: Urgent, need correct answer as soon as possible with complete solution. Box final answer in 4…

A:

Q: You are the engineer supervising the layout of a piping system. In a certain portion of the pipe,…

A:

Q: Identify the type and size (mm diameter) of the Drainage Pipe in the figure. Show your solutions,…

A: Factors Affecting the Usage of Drainage Pipes Drainage of water is done through pipes in a house…

Q: hoose the letter of the correct answer. Pipe fittings are attached to the end of pipes to allow it…

A: The part which is attached to pipe is known as pipe fitting.

Q: At what depth in a stand pipe containing water will cause a pressure of 30 lb/in 2 ? a. Write the…

A:

Q: EXAMPLE: Waterworks of a town treat 35 x 106 litres/day. The water is treated by…

A: Given data - Q = 35×106 L/day Consumed filter alum = 20 mg/L Alkalinity of water = 4.5 mg/L of CaCo3…

Q: Using illustrations, explain the practical use of creating a hump or a sudden drop in the bed of a…

A: We are considering a situation in which flow has already been established after the creation of…

Q: What are types of water tanks? Explain design procedure of circu water tank

A: A water tank is a storage container for water. Water tanks are used to store water for a variety of…

Q: Please give me right answer  Draw a flowchart on how to analyze a tension member, it's gusset…

A: The structural elements that are subjected to direct axial tensile loads and tends to elongate the…

Q: 14. The observation deck of tall skyscraper 370 m above the street. Determine the time required for…

A:

Q: Problem II. Frictionless, incompressible, one dimensional flow of the water passes through the…

A: Given,

Q: For a pipe that has a length 3,943 in feet, diameter 24 in inches, and flowrate 17 in ft3/s. The…

A:

Q: Describe the working principle of screw compressor with figure.

A: Screw compressor It is a type of rotary compressor which help s in compressing air due to screw…

Q: Given all information above Find the flow rate

A: Answer We are given  upstream depth of water y1 = 7 ft downstream depth of water y2 = 0.8 ft width…

Q: C-4 m- T .G 60° 4.5 m

A:

Q: 2 Cable- Water Gate Diameter (D)- Winch H Hinge Open Pipe H in O D in 60 50 30 A tank has a circular…

A:

Q: Describe about the Smooth-drum vibrators.

A: Smooth-drum vibrators is an equipment which is used for heavy compaction of th field for improving…

Q: Calculate flow, velocity, and headloss in each pipe and pressure at point B in ft, if supply…

A:

Q: A closed tank with air pressure of 9 kPa contains water at a constant head of 3.5m. A jet stream…

A:

Q: What is the hydraulic radius of a rectangular air duct 300mm by 500mm?

A: Appreciate if there is detailed work with explanation and finds you helpful for ease of…

Q: What should you do if the ladder you're about to use is damaged? Do your best to fix the damage and…

A: Ladders that are weak, improperly repaired, damaged, have missing rungs, or appear unsafe shall be…

Q: Q2: What is the difference between pump station and turbine?

A: Introduction- Pumps and turbines are two common equipment in numerous industries. The turbines is a…

Q: A rectangular gate of width "a", length "b" and inclined at an angle "A", with water on one side is…

A: a=3mb=2mz=1.5m∠ A=65°Total pressureP=wAxwhere weight of waterw=9.81KN/m3area of the…