A cylindrical drum (2-ft diameter, 3-ft height) is filled with a fluid whose density is 40 lb/ft 3 . Determine (a) the total volume of fluid, (b) its total mass in pounds and slugs, (c) its specific volume, and (d) its specific weight where g= 31.9 fps 2 .

A cylindrical drum (2-ft diameter, 3-ft height) is filled with a fluid whose density is 40 lb/ft 3 . Determine (a) the total volume of fluid, (b) its total mass in pounds and slugs, (c) its specific volume, and (d) its specific weight where g= 31.9 fps 2 .

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The Venturi meter shown in the sketch below, contracts the flow down to one quarter of its original area. Cold air at 0 deg C flows in the pipe through the Venturi meter. The velocity of the air upstream of the Venturi meter is equal to 40 ft/s and the pressure at the same point is equal to 30 psia. What is the manometer reading if the fluid of the manometer is water with density 1000 kg/m3 . Assume that the air behaves as an ideal gas with molecular weight equal to Mw=29 kg/kmol and constant density evaluated at upstream conditions. Use Bernoulli's equation for your calculations. please respond asap!
1. The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. The tank is A deep and is contaminated with B of water. The specific volume of gasoline is 0.00147076 m /kg and that of air is 0.0008313 m³/kg. Unit weight of water is 9790 N/m3 a. Determine the gage reading when the tank is full of gasoline b. How many cm of air remains at the top when the gage indicates full if the tank is A deep and is contaminated with B of water. c. Determine the pressure at the interface of the gasoline and water when the gage indicates full A = First name in inches Vent B = A/10 in inches Air h A Gasoline Pgage Water B
The mass of a fluid system is 4.2kgm, its density is 32.2 lb/ft3 and g is 31.90ft/s2. Find a) the specific gravity, b) the specific weight, and c) the total volume.
Q 1 A
A nozzle of inner radius 1.04 mm is connected to a hose of inner radius 8.83 mm. The nozzle shoots out water moving at 25.0 m/s. 1. Required information At what speed is the water in the hose moving? cm/s Required information What is the mass flow rate? g/s 2.
1) A manometer is attached to two pipes as shown. If knowing mercury SG is 13.6, sea water SG is 1.035, and fresh water p is 1,000 kg/m³, determine the pressure difference between two pipelines at the centers. Fresh Water h. -60 cm Air hair -70 cm hea <- 40 cm Mercury Sea Water hi -10 cm
A cylindrical tank that is 2ft in dia. and 3ft tall is filled with a fluid with p=64lbmft3. find its density in slug/ft3, specific volume in in3/slug, specific weight in Ibf/ft3, total weight in pdl, and find the specific gravity of the substance compared to water.
Question 12 of 25 If a depth of fluid of 1 m causes a pressure of 7 kPa, what is the specific gravity of the fluid? Select the correct response: 0.795 0.828 0.632 0.646 0.714
Q4: A 7-cm diameter solid aluminum ball (SG = 2.7) and a solid brass ball (SG-8.5) balance nicely when submerged in a fluid as shown in figure. a) If the fluid is water, what is the diameter of the brass ball? b) If the brass ball has a diameter of 3.8 cm, what is the density of the fluid? 2 pulleys Fluid brass aluminum D= 7 cm +
Open Open Water 5.5 in. 4.9 in 3.3 in. Unknown fluld 1.4 in. For the configuration shown in the figure above what must be the value of the unit weight of the unknown fluid? Express your answer in Ib/ft3.
A cylindrical tank that is 2ft in dia. and 3ft tall is filled with a fluid with p = lbm 64 ft3' find its density in slug/ft3, specific volume in in³/slug , specific weight in Ibf/ft3, total weight in pdl, and find the specific gravity of the substance compared to water.