A beam of rectangular cross section (60mm x 120mm) is simply supported at the ends and subject to the single concentrated force of 27 kN located 1m from the right support. The distance of the load from the left support is twice that of its distance from the right support. Calculate the shear stress in MPa at a point 3cm below the top of the beam at a location 1m from the left support.

A beam of rectangular cross section (60mm x 120mm) is simply supported at the ends and subject to the single concentrated force of 27 kN located 1m from the right support. The distance of the load from the left support is twice that of its distance from the right support. Calculate the shear stress in MPa at a point 3cm below the top of the beam at a location 1m from the left support.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

For the beam below, (a) draw the shear and moment diagrams and (b) determine the maximum normal stress in the beam due to bending. 20 kN A B -2.5 m-3 m 40 kN C -2 m- D 250 mm 80 mm
Determine the maximum shearing stress of the beam
For the beam below, (a) draw the shear and moment diagrams and (b) determine the maximum normal stress in the beam due to bending. 20 kN A B -2.5 m-3 m 40 kN C -2 m- D 250 mm 80 mm
Determine the maximum bending and shearing stresses developed in the beam 5. Ans.: (o)max = 149.45 MN/m? (O)max = 290.1 MN/m? (t)max = 5.77 MN/m2 %3D 10 kNim 200mm 20 kN.m B 2m A 4m 50mm Beam cross-section
Determine the moment M in kN-m that must be applied to the beam to create maximum stress of 98 MPa. Where tf = 19 mm and d = 306 mm
3. In the figure shown: a) Draw the Shear and Moment Diagram, and determine the maximum moment. b) Determine the Maximum Tensile and Maximum Compressive Flexural Stress developed. P1 27 kN P2 11 kN A 225 mm P2 3m 3m W
Determine the maximum shear stress in the T-beam at point C. 150 mm 10 kN/m T 150 mm 30 mm |C --30 mm 5m +₁. 3 m- -1.5 m-1.5 m- A B
569
B6
Bar (1) has a cross-sectional area of 0.75 in.?. If the stress in bar (1) must be limited to 35 ksi, determine the maximum load P that may be supported by the structure. (1) 6 ft 4ft O 15.75 kips 18.32 kips O 9.55 kips O 14.24 kips O 19.92 kips
A steel shaft must transmit 150 kW at a speed of 360 rpm. Knowing that G = 77.2 GPa, design a solid shaft so that the maximum shearing stress will not exceed 50 MPa and the angle of twist in a 2.6-m length must not exceed 3°. Consider the frequency fto be 6 Hz. The diameter of the solid shaft is 71.4542 mm.
Determine the maximum flexural stress and maximum shear stress of the beam