A 5 mm diameter steel suspension cable fixed at the upper end with length 20 m is subjected to load P= 5 kN at its lowest end. If the cable weighs 7850 kg per cu.m and modulus of elasticity is 200 GPa, what is the deformation of the cable due to its weight in mm? Round your answer to 3 decimal places. Add your answer

A 5 mm diameter steel suspension cable fixed at the upper end with length 20 m is subjected to load P= 5 kN at its lowest end. If the cable weighs 7850 kg per cu.m and modulus of elasticity is 200 GPa, what is the deformation of the cable due to its weight in mm? Round your answer to 3 decimal places. Add your answer

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Problem 2. A steel tape weighing 0.85 kg has a cross-sectional area of 0.05 cm². The tape measures exactly 30.00 m when supported throughout its length under a standard pull of 5.5 kg. If the modulus of elasticity is 2.10x106 kg/cm², determine the tension required to make the tape equal to its nominal length when supported only at the end points.
Solve the following problem and show your complete solutions. Illustrate a free body diagram for better understanding
T:39)
A flanged bolt coupling consists of eight d-mm diameter steel bolts on a bolt circle 300 mm in diameter, and four d-mm diameter steel bolts on a concentric bolt circle 193 mm in diameter. If the torque that can be applied is 7947 Nm without exceeding a shearing stress of 57.09 MPa in the bolts, what is the diameter of the bolts? Round off the final answer to two decimal places.
I need the answer as soon as possible
A wood beam carries the loading shown in the figure. calculate the magnitude of the bending stress (in Pa) at a point 14 mm from the top of the beam on a section 3.4 m from A if P = 4619 N, W = 1991 N/m, a = 0.82 m, b = 1.77 m, c = 1.13 m, L = 68 mm and h = 197 mm. Round off the final answer to two decimal places. ... W P aptation 16 h A C t b ➜
choose the correct answer
A 5 mm diameter steel suspension cable fixed at the upper end with length 20 m is subjected to load P = 5 kN at its lowest end. If the cable weighs 7850 kg per cu.m and modulus of elasticity is 200 GPa, what is the deformation of the cable due to its weight and applied load P in mm? Round your answer to 3 decimal places.
A uniform bar AB weighing 500 kg is supported at both end by cable as shown in the figure below. Determine the elongation in the Bronze cable if the modulus of Elasticity is 100 GPa and the cross sectional is 30O mm? . Steel L=4m Bronze L=4m A 10 m B A) 6.7 mm В 0.33 mm 0.67 mm D 3.3 mm
3.5