5(s+2)G(s)s? +4s the system given at the bottom of the transfer function,When the amplitude and phase frequency response analytical expressions are taken into account for1013|G(jw)|a1a2aza4asa6b3b4bgb615 -p(derece)bịb2amplitude and phase angle values will be calculated for some frequency (w) values given in the table:What is the phase angle value shown in the table with b5?O A) -74.7OB) -77.5OC) -71.6OD) -81.4O E) -79.5

In this question we need to find a phase angle Value.

5(s+2) G(s) = When the amplitude and phase frequency response analytical expressions are taken into account for s?+4s the system given at the bottom of the transfer function, 1 10 |G(jw)l az az az a4 as a6 15 - p(derece) b, b2 bz b, b5 amplitude and phase angle values will be calculated for some frequency (w) values given in the table: What is the phase angle value shown in the table with b5? O A) .74.7 OB) -77.5 OC) -71.6 OD) -81.4 OE) -79.5

5(s+2) G(s) = When the amplitude and phase frequency response analytical expressions are taken into account for s?+4s the system given at the bottom of the transfer function, 1 10 |G(jw)l az az az a4 as a6 15 - p(derece) b, b2 bz b, b5 amplitude and phase angle values will be calculated for some frequency (w) values given in the table: What is the phase angle value shown in the table with b5? O A) .74.7 OB) -77.5 OC) -71.6 OD) -81.4 OE) -79.5

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In designing a signal-switching circuit (RC circuit), it was found that a 100-µF capacitor was needed for a time constant of 3 ms. What value resistor is necessary for the circuit? The resonant circuit for a radio broadcast consists of a 120-pF capacitor in series with a 240-uH inductor and a resistance of 400 2, what is the resonant frequency of the circuit? What would be the resonant frequency if the resistance were reduced to 40
Derive and plot the magnitude and phase responses of the first order difference system, y[n] = x[n]–x[n − 1]. ..
a) Compute the transfer function T(w), the absolute value, and phase at resonant frequency. b) What kind of filter is this? Please answer in typing format please ASAP
Solve for the general expression of the complex gain (Vo/Vs) of the given RLC circuit. The Vs is sinusoidal nad has a magnitude |Vs|.
Problem 9. Consider the filter shown in the figure below. a) Derive an expression for the transfer function H(f) = Vout Vin b) Use MATLAB to obtain a Bode plot of the transfer-function magnitude for R₁ = 9 kQ, R₂=1 kQ and C = 0.01 μF. Allow the frequency to range from 10 Hz to 1 MHz. wwwwwwww c) At very low frequencies, the capacitance becomes an open circuit. In this case, determine an expression for the transfer function and evaluate for the circuit parameters of part (b). Does the result agree with the value plotted in part (b)? Vin + C HE ww R₁ R₂ Yout
uvquvurd Q2 A series RLC bandreject filter is used to reject a 200 Hz sinusoid while passing other frequencies, calculate the values of L and C. Take R=150 Q2 and as 100 Hz. the bandwidth
Could you please explain step by step? thank you
Required information A parallel resonance circuit has a resistance of 2 k and half-power frequencies of 84 kHz and 92 kHz. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Determine the bandwidth. The value of the bandwidth is krad/s.
4. Given the following LRC circuit below: The circuit shown has a resonant frequency, fr=100 kHz. The circuit has a resistance value, R = 10002, capacitance value, C = 1.33nF. and an inductance value of L=1.904mH. a. Determine the quality factor, Q, for the circuit b. What is the BW of this circuit? c. Calculate the upper and lower cut-off frequencies. d. If the following triangle wave with a fundamental frequency, f, of 20 kHz is put through this filter, determine the output.
In a series RLC circuit, what does it mean that the resonance? Develop a detailed answer and support it with equations, diagrams and comments on the physical processes that occur in said condition.
3
Given the discrete-time sequence Find two different continuous-time signals that would produce this sequence when sampled at a frequency of fs=120Hz.