2. In a copper-nickel system as shown in figure, an alloy composition of 35 wt% Ni was cooled down from the temperature of 1300°C. Sketch the expected microstructures at the point a, b, c, d and e and briefly describe the development of these microstructures in the equilibrium cooling. L L (35 Ni) 1300 L (32 Ni) a(46 Ni) a(43 Ni) L (24 Ni) d! 1200 1100 20 30 40 50 Composition (wt% Ni) Temperature (°C)

Q: As an engineer you are asked to evaluate the feasibility of a device which operates in a temperature…

A: Given, E = 70 GPa or 70000 MPa  σmax = 100 MPa

Q: [14] Electrolysis process is based on : * thermal effect of current O chemical effect of current O…

A: Answer :   Chemical effect of current.

Q: If the Ksp of Sn(OH)2 (s) is 5.33 x 10-27, what is the solubility of it in the unit of mg/L?

A: Apply formula for solubility  We will find solubility in mol/L from formula Then we have to convert…

Q: Given a Cu-Ag alloy with a bulk composition of 30wt% Ag, answer the following: a. At what…

A: Cçarefully examining the provided phase diagram for the Cu-Ag alloy system with a bulk composition…

Q: 3 Induction hardening and flame hardening are two heat treatment methods that can be used to…

A: Option A) is correct  Induction hardening uses an electric current to very rapidly generate heat via…

Q: 15. With the decrease in the viscosity, Reynolds number

A: To find : What will happen to Reynolds number if viscosity will be decreased.

Q: Compression molding is a manufacturing process in which the molding material is preheated then…

A: Option A is most accurate answer. Because, => Compression moulding is mostly used         for…

Q: Ca+2 = 36.8mg/L Mg+2 = 2.9mg/L HCO3 = 98mg/L pH = 7.53 Temp = 9C Calculate the following: a.…

A: Note- Hi! Thank you for the question, As per the honor code, we are allowed to answer three…

Q: Scission can be defined as. a. The loss of fragments from the surfaces of ceramic materials due to…

A:

Q: A teapot with a surface area of 665 cm2 is to be plated with silver. It is attached to the negative…

A: Given:

Q: Calculate the dosage of activated carbon to reduce an influent (flowrate = 10 mgd) concentration of…

A:

Q: Describe the basic properties of Montmorillonite.

A: Montmorilonite is a group of minerals which is contained in clayey soils. It is formed by…

Temperature effects on atom arrangements

Atoms are the smallest units of matter. Atoms can be subdivided into electrons, protons, and several other subatomic particles. Groups or combinations of atoms form molecules that primarily decide the property and behavior of materials. These molecules have the property to attract other molecules based on the valence electrons in the atoms' outermost orbit. An orderly arrangement of molecules is known as crystal structure, which forms the fundamental topic of concern in materials science and engineering. The arrangement of molecules is different for different materials and hence, each material exhibits different lattice arrangements. The lattice arrangements are functions of external loads, deformations, and temperature. On experiencing high temperatures or low temperatures, the behavior of the lattice arrangement of a material change.